Web Analytics
Fiat 180-90 tractor parts - Techniek Totaal
Menu
EUR

Tractor parts Fiat 180-90

Looking for parts for your Fiat 180-90 tractor? In this category, you'll find everything you need for the maintenance and repair of your vehicle.

93 Products
Show:
PROBOSS Seat AS2480 air suspension
PROBOSS
Air suspension with 12V compressor. Fore/aft isolator. Height adjustment, longitudinal adjustment, backrest tilt adjustment. Mechanical lumbar support... More
Air suspension with 12V compressor. Fore/aft isolator. Height adjustme...
€839,00 €693,39 €839,00 €693,39
You save 0%
 
GRANIT Rubber seal - 5 pcs.
GRANIT
Clamping range: 1 - 4 mm. Length: 5 m. B: 19,4 mm. H: 14,5 mm. More
Clamping range: 1 - 4 mm. Length: 5 m. B: 19,4 mm. H: 14,5 mm.
€51,57 €42,62 €49,07 €40,55
You save 5%
 
GRANIT Rubber seal 18,7 x 14,6 mm | clamping range 1,5-3 mm | 5 metres
GRANIT
Clamping range (mm): 1.5 - 3. Length (m): 5. W (mm): 18.7. H (mm): 14.6. More
Clamping range (mm): 1.5 - 3. Length (m): 5. W (mm): 18.7. H (mm): 14....
€40,80 €33,72 €38,82 €32,08
You save 5%
 
GRANIT Rubber seal - 5 pcs.
GRANIT
Clamping range: 2,2 mm. Length: 5 m. B: 24 mm. H: 22 mm. More
Clamping range: 2,2 mm. Length: 5 m. B: 24 mm. H: 22 mm.
€40,60 €33,55 €38,63 €31,93
You save 5%
 
GRANIT Gasket set for control unit 85219130 flange surface with O-ring and support ring
€22,80 €18,84 €24,10 €19,92
You save -6%
 
GRANIT Control unit Can be switched between sa and da, with float position with detent and limit stop adjustable from 150 - 210 bar
GRANIT
Technical data: Max. operating pressure: 220 bar, Nominal flow rate: max. 70 l/min, Tightening torque: 30 Nm, Connections: M18 x 1.5, Dimensions: 210 ... More
Technical data: Max. operating pressure: 220 bar, Nominal flow rate: m...
€864,84 €714,74 €765,38 €632,55
You save 11%
 
GRANIT Temperature sensor Thread: M22 x 1.5
GRANIT
Version: Thread: M22 x 1.5. Temperature: 25 - 100 °C. More
Version: Thread: M22 x 1.5. Temperature: 25 - 100 °C.
€14,05 €11,61 €13,37 €11,05
You save 5%
 
Cobo Fuse box 12-pin
Cobo
Version: Without fuses, blade terminal connection at the bottom, transparent cover, L 174 x W 50 x H 34.5 mm. To fit: Blade terminal. Number of pins: ... More
Version: Without fuses, blade terminal connection at the bottom, trans...
€79,64 €65,82 €75,79 €62,64
You save 5%
 
Cobo Flasher/electronic 12 V, 6 connections
Cobo
Version: 12 V / 2 + 1 + 1 x 21 / 8 x 21 W, With bracket, With hazard warning light function. More
Version: 12 V / 2 + 1 + 1 x 21 / 8 x 21 W, With bracket, With hazard w...
€47,96 €39,64 €45,64 €37,72
You save 5%
 
GRANIT Hand pump M16 x 1,5
GRANIT
Version: M16 x 1.5 More
Version: M16 x 1.5
€14,94 €12,35 €13,89 €11,48
You save 7%
 
Cobo Light lens
Cobo
Installation location: Right. Menke no.: 55041. More
Installation location: Right. Menke no.: 55041.
€18,76 €15,50 €17,85 €14,75
You save 5%
 
Starter 12 V / 3.0 kW - Fiat, Laverda, New Holland
To fit as: Fiat, Laverda, New Holland More
To fit as: Fiat, Laverda, New Holland
€415,19 €343,13 €349,62 €288,94
You save 16%
 
GRANIT Ball joint taper 20 - 22.2 mm - length 95 mm - M24 x 1.5
GRANIT
Taper (mm): 20 - 22.2. Length (mm): 95. Outer thread (mm): M24 x 1.5. More
Taper (mm): 20 - 22.2. Length (mm): 95. Outer thread (mm): M24 x 1.5.
€50,28 €41,55 €36,55 €30,21
You save 27%
 
GRANIT Hydraulic/transmission oil filter to fit as W1150/2 & HF7569
€15,25 €12,60 €14,18 €11,72
You save 7%
 
GRANIT Gear lever knob
GRANIT
Version: Ø top 20 mm, length 35 mm, thread M8. More
Version: Ø top 20 mm, length 35 mm, thread M8.
€5,45 €4,50 €5,18 €4,28
You save 5%
 
GRANIT O-ring
€4,91 €4,06 €4,68 €3,87
You save 5%
 
GRANIT Stop cable
GRANIT
A: 1150 mm. B: 950 mm. More
A: 1150 mm. B: 950 mm.
€26,26 €21,70 €24,99 €20,65
You save 5%
 
Bosch/Rexroth Single pump anticlockwise
Bosch/Rexroth
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation: Anticlockwise. Line connection suction side: Ø 40mm, 4-Loch, M8. L... More
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction ...
€571,27 €472,12 €481,48 €397,92
You save 16%
 
GRANIT Lateral strut right and left
GRANIT
C sleeve length: 385 mm. Thread: M30 x 3 mm. Length min./max.: 480 - 610 mm. Assembly notes: rechts und links. More
C sleeve length: 385 mm. Thread: M30 x 3 mm. Length min./max.: 480 - 6...
€204,97 €169,40 €195,05 €161,20
You save 5%
 
GRANIT Seal kit for outer lifting cylinder
€31,82 €26,30 €30,28 €25,02
You save 5%
 
GRANIT Oil pressure switch
GRANIT
Version: 0.3 - 0.6 bar, Thread M12 x 1.5, Blade terminal. More
Version: 0.3 - 0.6 bar, Thread M12 x 1.5, Blade terminal.
€12,15 €10,04 €11,57 €9,56
You save 5%
 
Cobo Ignition start switch With key
Cobo
Version: 12 V, with blade terminal, Function:, P: parking light, 0: off, 1: consumer, 2: start, Housing Ø 40 mm. More
Version: 12 V, with blade terminal, Function:, P: parking light, 0: of...
€57,32 €47,37 €54,54 €45,07
You save 5%
 
Cobo Rocker switch For work lights
Cobo
Version: 12 V/24 V, On/off switch, 8 blade terminals, Installation dimension: 15 mm wide, 29 mm long and 34 mm high. More
Version: 12 V/24 V, On/off switch, 8 blade terminals, Installation dim...
€39,75 €32,85 €37,83 €31,26
You save 5%
 
HELLA Push button switch Black button
HELLA
Version: For engine start and horn, moisture-proof push button, 2 blade terminals 6.3 mm, black push button, for wall thickness up to max. 5 mm, short... More
Version: For engine start and horn, moisture-proof push button, 2 blad...
€13,43 €11,10 €13,20 €10,91
You save 2%
 
Showing 1 - 24 of 93

Parts for your Fiat 180-90 tractor

At Techniek Totaal, you'll find a wide range of tractor parts for your Fiat 180-90. We also offer the right parts for all other tractor types from Fiat. Enter your part number in the search bar to find the correct part.

Parts

We offer a complete range of parts. Whether it's a can of paint to make your tractor look like new again, or more complex engine parts to get your tractor running again, we have the right parts for your Fiat 180-90. Additionally, we offer parts for engine cooling, fuel systems, front axles, brakes, drives, bodywork, hydraulics, exhaust systems, and accessories.

Techniek Totaal in Barneveld

Techniek Totaal is a young company located in Barneveld, a central point in the Netherlands. For those looking to save on shipping costs, we are opening a pickup warehouse at the end of 2024 where parts will be ready for pickup every workday. This sets us apart from the modern world, where everything is handled exclusively online.

Ordering

Easily order parts for your Fiat 180-90. Use our parts-by-brand configurator to quickly find everything you need for your tractor, agricultural machine, or forklift. Once you place an order, we will process it immediately, and you'll receive it within 1 to 3 days.

About the manufacturer Fiat

Fiat was founded in Turin, Italy, in 1899 by Giovanni Agnelli, an industrialist. Fiat stands for Fabricca Italiana Automobili Torino. The company started by producing cars and trucks. Later, stationary and marine engines, railway equipment, and even airplanes were built.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart