Lindner Geotrac 83 parts for hitching, seating and charging

A Geotrac 83 rarely runs without something behind it. Forage wagons, tippers and slurry tanks all put load on the drawbar, the pin and the rails the hitch slides in. This page brings together more than 60 parts that fit the Lindner Geotrac 83, covering the hitch end of the tractor, the driver seat and a handful of engine and electrical components.

Hitch components

You will find drawbars with a ball or a pin, top drawbars, automatic hitches, ball hitches and the Piton Fix system, with makes such as Scharmüller, Walterscheid and ROCKINGER. Adapter plates, some of them height adjustable, let you fit a different coupling system to the existing rails. A trailer coupling and a single replacement ball are listed too, handy when only the ball has worn.

Cab, engine and electrics

• Tractor seats from GRAMMER, including an air suspended seat with fabric trim.
• An alternator for the charging circuit.
• A clutch plate for the drive line.
• An engine oil filter and an engine preheater that makes cold starts easier.

Matching the right part to your tractor

Start with the type plate on your Geotrac. The type and serial number printed there are what separate two versions of a part that look identical from the outside. With hitch parts, measuring matters next. Check the width between the rails, the diameter of the locking pin and whether your tractor uses a ball or a jaw, then compare those figures with the details given for each product on this page.

Old alternators and hitch parts often carry a stamped or labelled reference number. Note it down before the part goes in the scrap bin, because it is the quickest way to confirm that mounting points and connections on the replacement are the same.

Workshop note on a rattling drawbar

If the drawbar knocks in its rails, the drawbar itself is often not the culprit. Worn locking pins and guides let it move, and a new drawbar will keep moving if they are left in place. Check those first, give the rails a thin coat of grease after fitting and run the drawbar up and down a few times before pulling a loaded trailer. Planning an air suspended seat? Work out beforehand where the compressor will take its power from.

Running more than one tractor from this maker? Other models are grouped under Lindner parts.