Menu
EUR

Fendt Favorit 611 (Typ 382) parts

Looking for parts for your Fendt Favorit 611 (Typ 382) tractor? In this category, you'll find everything you need for the maintenance and repair of your vehicle.

527 parts found for Fendt Favorit 611 (Typ 382)
Show:
GRANIT Banjo bolt M10 x 1, length 23 mm, wrench size 13 mm Fendt
GRANIT
Medium: DOT4. Total length: 23 mm. Thread: M10x1. AF: 13 mm. Thread length: 8 mm. More
Medium: DOT4. Total length: 23 mm. Thread: M10x1. AF: 13 mm. Thread le...
€13,71 €11,33 €13,44 €11,11
You save 2%
GRANIT Repair set foot brake Fendt
€37,20 €30,74 €36,46 €30,13
You save 2%
GRANIT Wheel brake cylinder Ø 38,1 mm, DOT 4 Fendt Favorit 600-615
€330,94 €273,50 €281,30 €232,48
You save 15%
GRANIT Return spring for brake shoe Fendt Favorit 600-615
€18,40 €15,21 €18,03 €14,90
You save 2%
GRANIT Gasket manual transmission top Fendt Favorit 600-615
€52,51 €43,40 €51,46 €42,53
You save 2%
GRANIT Bush rear axle outer Fendt Favorit 610, 611
€444,20 €367,11 €377,57 €312,04
You save 15%
GRANIT Back-up ring rear axle shaft inner Fendt Favorit 600-615
€14,53 €12,01 €14,24 €11,77
You save 2%
GRANIT Rear axle shaft seal inner Ø 60,5 x 80 x 12 mm Fendt Favorit 600-615
GRANIT
Dimensions: 60,5 x 80 x 12 mm. Outer Ø: 80 mm. Inner Ø: 60.5 mm. Height 1: 12 mm. More
Dimensions: 60,5 x 80 x 12 mm. Outer Ø: 80 mm. Inner Ø: 60.5 mm. Hei...
€70,58 €58,33 €69,17 €57,17
You save 2%
GRANIT Starter ring gear Ø 350/316 mm, 115 teeth Fendt
GRANIT
Version: Ø 350/316 mm, 115 splines. More
Version: Ø 350/316 mm, 115 splines.
€492,74 €407,22 €418,83 €346,14
You save 15%
GRANIT Bowden cable driving clutch 3010 mm, sleeve 2800 mm, M6 Fendt
GRANIT
Cable length: 3010 mm. Sleeve length: 2800 mm. Thread: M6. More
Cable length: 3010 mm. Sleeve length: 2800 mm. Thread: M6.
€387,59 €320,32 €329,45 €272,27
You save 15%
Walterscheid Flange hitch manual pin 31 mm, 160 x 100 mm, M21, 2000 kg
Walterscheid
Lock: Manual pin. Hole pattern: 160 x 100 mm. Load capacity: 2000 kg. D-value: 92,0 kN. Hole: M21 mm. No. of holes: 4. Colour: Black. Description: Thi... More
Lock: Manual pin. Hole pattern: 160 x 100 mm. Load capacity: 2000 kg. ...
€724,19 €598,50 €615,56 €508,73
You save 15%
GRAMMER Air-sprung tractor seat fabric Maximo Dynamic DDS MSG95AL/741
GRAMMER
To fit: Fendt, old bracket. Suspension: Air suspension. Upholstery type: Fabric. Seat contact switch: Yes. Track gauge: 260 mm. Seat width: 550 mm. Jo... More
To fit: Fendt, old bracket. Suspension: Air suspension. Upholstery typ...
€3.699,05 €3.057,07
GRANIT Replacement glass, main mirror curved 366 x 176 x 3 mm, unheated
GRANIT
Dimensions (mm): 366 x 176 x 3. Version: Unheated. Installation location: Right/left. Radius of curvature (mm): 1800. More
Dimensions (mm): 366 x 176 x 3. Version: Unheated. Installation locati...
€23,68 €19,57 €23,21 €19,18
You save 2%
KS Piston set, complete Ø 105 mm, piston pin 32 x 82 mm, Fendt, Renault
KS
Dimensions: 4 rings, Ø 105 mm, Gudgeon pin Ø 32 x 82 mm, Combustion chamber Ø 62 mm, Combustion chamber depth 19.8 mm, Dry liner. Menke no.: 72751.... More
Dimensions: 4 rings, Ø 105 mm, Gudgeon pin Ø 32 x 82 mm, Combustion ...
€409,14 €338,13 €347,77 €287,41
You save 15%
GRANIT Disc Ø 11 x 19 x 5 mm Fendt Farmer 312, Favorit 512-615
€14,02 €11,59 €13,74 €11,36
You save 2%
GRANIT Push rod Fendt, Case IH, Steyr
GRANIT
Menke no.: 210255. More
Menke no.: 210255.
€50,40 €41,65 €49,39 €40,82
You save 2%
KS Piston set complete Ø 105 mm, piston pin 32 x 82 mm, Fendt
€409,14 €338,13 €347,77 €287,41
You save 15%
GRANIT Radiator hose, bottom Ø 44 mm, length 100 mm Fendt
GRANIT
Inner Ø: 44 mm. Length: 100 mm. More
Inner Ø: 44 mm. Length: 100 mm.
€25,94 €21,44 €25,42 €21,01
You save 2%
GRANIT V-belt Fendt Favorit 611-615, Massey Ferguson 2745-2805
€17,32 €14,31 €16,97 €14,02
You save 2%
GRANIT Radiator hose thermostat / pressure pipe cylinder head Ø 45 mm Fendt
€31,19 €25,78 €30,57 €25,26
You save 2%
GRANIT Thermostat Ø 38/38/24/18 mm, 75 °C, Fendt Favorit 600-615
GRANIT
Ø: 38/38/24/18 mm. Temperature: 75 °C. Menke no.: 59888. More
Ø: 38/38/24/18 mm. Temperature: 75 °C. Menke no.: 59888.
€135,75 €112,19 €128,96 €106,58
You save 5%
GRANIT Tank cap reservoir thread 48 mm
GRANIT
Version: Thread 48 mm, For expansion tank. More
Version: Thread 48 mm, For expansion tank.
€20,32 €16,79 €19,91 €16,45
You save 2%
Showing 457 - 480 of 527

Fendt Favorit 611 (Typ 382) specifications

The Fendt Favorit 611 LSA carries the internal type designation T 382 and was built from 1985 to 1993 exclusively with four-wheel drive. A total of 1,433 units were produced. The 611 LSA is the successor to the 611 LS (Typ 282) and at the same time the conclusion of a development line that began in 1972 with the Favorit 611 S. The LS version with rear-wheel drive falls under Typ FWA 282.

Production ran in two clearly distinct phases. In the first phase (chassis number T 382.250, 1985 to 1987, 228 units), the engine has no turbocharger and produces 115 hp. In the second phase (chassis number T 382.211, 1988 to 1993, 1,205 units), a turbocharger was added and the combustion process optimised, raising output to 125 hp while fuel consumption fell. The 611 LSA was succeeded in the line-up by the Favorit 500C series.

Hydraulics and lift system

The hydraulic tandem pump delivers 69 litres per minute (44 plus 25 litres) at 180 bar. The rear three-point hitch achieves a maximum lift capacity of 7,410 kg. An optional front linkage with category II three-point hitch is available with a maximum lift capacity of 3,940 kg. The permissible front axle load is 3,050 kg and the rear axle load 5,400 kg. The permissible gross weight is 8,500 kg.

Engine

The second phase (1988 to 1993) uses an MWM TD 226-B 6, a water-cooled six-cylinder four-stroke inline turbodiesel engine with direct injection into the combustion bowl of the piston. The engine is fitted with individually mounted cylinder heads, piston crown cooling, an oil cooler, Rotocap valves, a viscous fan, an inline injection pump, a multi-hole injector, a dry air filter with pre-cleaner, pressure circulation lubrication, an exhaust turbocharger with pulse charging and thermostatically controlled dual-circuit cooling. Displacement is 6,240 cc. Maximum torque is 497 Nm at 1,500 rpm. Injection pressure is 180 to 185 bar, raised to 650 bar from 1987.

The first phase (1985 to 1987) has a naturally aspirated MWM D 226.6.2 without turbocharger producing 115 hp, with a maximum torque of 412 Nm at 1,500 rpm.

Transmission and travel speed

The 611 LSA has a helical-cut ZF fully synchronised fine-step gearbox type T 3345 with side-mounted gear selection, offering 20 forward and 9 reverse gears. Top speed is 40 km/h in the standard version, with a 30 km/h version also available. In the 40 km/h version, the six gears in the fast range run from 3.88 to 38.41 km/h, in the slow range from 3.12 to 30.94 km/h and in the creep range from 4.71 to 27.41 km/h. From 1987, the Duospeed drive system was available as an option, along with an electronically controlled differential lock and a reversing unit.

Power take-off

The PTO is switchable between 540 and 1,000 rpm. An optional front PTO is available.

Brakes and steering

The braking system consists of hydraulically operated full disc brakes on the rear wheels, usable as individual wheel brakes. A propshaft disc brake acts on the four-wheel drive; when the individual wheel brake is applied, the front wheel brake disengages automatically. The parking brake is mechanically operated as an internal shoe brake. Steering is hydrostatically assisted.

Dimensions and weight

  • Unladen weight: 6,080 kg
  • Fuel tank: 222 litres
  • Fuel consumption at maximum power: 223 g/kWh

Standard tyre sizes are 14.9-26 at the front and 18.4R38 at the rear. The cab is a rubber-mounted, vibration and sound-insulated safety cab with a noise level of 78 dB, air-suspended seat, digital tractor meter, fold-open front and rear windows, roof hatch, three-stage ventilation system, two-stage heating, radio preparation and height-adjustable steering wheel.

Difference from the 611 LS (Typ 282)

The difference between Typ 382 and Typ 282 is a recurring point when sourcing parts and when purchasing. The Typ 282 is the LS series, built from 1977 to 1984, available with either rear-wheel or four-wheel drive and producing 100 to 110 hp from a naturally aspirated engine. The Typ 382 is available exclusively with four-wheel drive, has a turbocharged engine in its second phase, a higher hydraulic pump output and higher permissible axle loads. The gearbox on both types is a ZF T 3345, but the configuration differs between phases.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart