Menu
EUR

Ford 6810 tractor parts & technical data

Replacing lights or repairing the electrics on your Ford 6810? With more than 190 parts for this model, trailer couplings included, the right part is here.

193 parts found for Ford 6810
Show:
GRANIT Gas strut door 300 N, 205 mm Ford 54303, Series 10-8730, TW 5-15
GRANIT
Newtons: 300. A: 205 mm. B: 95 mm. C: 13 mm. D: 13 mm. To fit: door. Form: 6. More
Newtons: 300. A: 205 mm. B: 95 mm. C: 13 mm. D: 13 mm. To fit: door. F...
€42,05 €34,75 €38,00 €31,41
You save 10%
Showing 193 - 193 of 193

Ford 6810 tractor parts for engine, clutch and steering

Plenty of farms still use a Ford 6810 every day, even though the hour meter on a typical example shows a serious number by now. With a tractor like that, it all comes down to the parts that wear: seals, the clutch, the steering and the starting system. Here you will find more than 190 Ford 6810 parts, from GRANIT, Eaton, LUK, Cobo and GRAMMER.

Engine and fuel side

For the engine there are sealing rings for the injection nozzles, exhaust gaskets and water pump gaskets. You will also find engine oil filters, V-belts and turbochargers. A tank cap looks like a minor item, but one that no longer seals lets dirt and moisture into the diesel, and the injectors pay for that later.

Whenever you pull an injector, always renew the sealing washer underneath it. A used washer has been crushed and no longer seals properly, which leads to blow-by and soot building up around the nozzle. Clean the seat thoroughly before the new washer goes in.

Fitting a turbocharger is a job where cleanliness counts. Flush or replace the oil feed line, change the engine oil and filter, and prime the new turbo with a little clean oil before the first start. Let the engine idle for a while before you open the throttle.

Driveline and clutch

The driveline is covered with clutch plates, universal joints and bushes for the transmission housing. If the clutch slips under load or will not disengage cleanly, the plate is usually worn. While it is apart, inspect the flywheel face and the release bearing as well.

Steering and drawbar

The front axle of a 6810 takes a beating in the yard and in the field. Axial joints and ball joints take the play out of the steering. After replacing an axial joint or a ball joint, reset the toe-in, otherwise the front tyres wear unevenly. At the back there are drawbars, and for the driver there are seats.

Finding the right part and related models

Locate the data plate and compare the reference number on the old part with the details on the product. On many parts for these tractors, a wire brush will make a worn number readable again.

In the Ford 10 series, the 6810 sits alongside several other models, and each of them has a page here with parts matched to that tractor:

For every other Ford tractor, carry on through Ford parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart