For the Landini Vision 105 you will find more than 40 matching parts here, covering brakes and transmission, electrics, and the steering and front axle.
If you service your own Landini Vision 105, the filters are where it starts. There are air filters with a separate inner element and engine oil filters, including MANN-FILTER products. In all, more than 40 parts for this tractor are listed, from GRANIT, Cobo, LUK, MANN-FILTER and FEBI.
A word on the air filter: the inner element is the engine's last line of defence, so never blow it out with compressed air. Replace it at every second change of the outer element, or sooner if it is visibly dirty. Avoid knocking the outer filter against a tyre to clean it, as that can open up hairline tears in the paper that you will not see.
The electrical system is covered as well. Alternators keep the battery charged and a glow plug helps on cold mornings. There is a starter cut-out switch, a flasher unit, a multifunction switch, a temperature sensor and an electric feed pump. Lighting is covered by indicator and position lights and a headlight.
If the indicators suddenly flash twice as fast, a bulb on that side has almost certainly failed. Check the bulbs before you replace the flasher unit.
Extra play at the steering wheel can come from a worn axial joint. A torn rubber boot lets dirt in and the joint wears out quickly, so check the boot whenever the tractor is on the lift.
When the water pump comes off, it is a good moment to renew the coolant and check the hoses, because dirt and scale from the old system shorten the life of the new pump seal. A thrust bearing is best replaced together with the clutch disc and pressure plate, so the tractor only needs splitting once. A failing glow plug shows itself in winter through long cranking and white smoke for the first few minutes.
Use the type plate to confirm the model. With filters, the part number is usually printed clearly on the old filter. Compare it with the references given for each product to be sure the thread and dimensions are right. On thrust bearings and axial joints the number is often stamped into the metal.
For every other Landini model, head to the Landini parts overview.
