Menu
EUR

Renault 75-32 tractor parts & technical data

There is no need to hunt for Renault 75-32 parts one by one. This page shows more than 100 of them for the R series, including trailer couplings and lighting.

103 parts found for Renault 75-32
Show:
GRANIT Stop cable A 1620 mm, B 1445 mm Renault
GRANIT
A: 1620 mm. B: 1445 mm. More
A: 1620 mm. B: 1445 mm.
€27,65 €22,85
GRANIT Seal kit upper 1 cylinder ZKD 1,15 mm MWM D 226, TD 226, TD 228
€35,61 €29,43 €33,80 €27,93
You save 5%
GRANIT Injection nozzle Renault Ceres 65-95, 58-12 - 133-54
GRANIT
Type formula: BDLL150S6741CF, 0433272007. More
Type formula: BDLL150S6741CF, 0433272007.
€43,86 €36,25 €41,65 €34,42
You save 5%
GRANIT Aircon compressor 12 V, pulley Ø 152 mm, 2 grooves, EM Renault
GRANIT
Fixing: EM | Pulley Ø (mm): 152 | Suitable oil: PAG 46 | Oil quantity (ccm): 200 | Refrigerant: R 134a | Nominal voltage (V): 12 | No. of grooves: 2 More
Fixing: EM | Pulley Ø (mm): 152 | Suitable oil: PAG 46 | Oil quantity...
€568,46 €469,80 €540,00 €446,28
You save 5%
GRANIT Starter ring gear Ø 350/317 mm, 115 teeth Renault
GRANIT
Version: Ø 350/317 mm, 115 teeth. More
Version: Ø 350/317 mm, 115 teeth.
€319,32 €263,90 €303,35 €250,70
You save 5%
GRANIT Radiator hose, bottom inner-Ø 37 mm Renault 58-32 - 106-54
€75,25 €62,19
Radiator hose, top with heating inner-Ø 22 mm Renault
€54,40 €44,96 €51,65 €42,69
You save 5%
Radiator hose, top thermostat inner-Ø 35 / 38 mm Renault
€43,61 €36,04 €41,40 €34,21
You save 5%
Thrust bearing standard Ø 65 mm Fendt, Renault
Dimensions: Ø 65 mm. More
Dimensions: Ø 65 mm.
€114,65 €94,75
Oil pump line-Ø 30 mm Case IH, Renault, Steyr, Fendt
Dimensions: Pipe Ø 30 mm. More
Dimensions: Pipe Ø 30 mm.
€431,57 €356,67 €409,95 €338,80
You save 5%
Angle drive engine side M18 x 1,5, clockwise rotation - right
€131,53 €108,70 €124,95 €103,26
You save 5%
GRANIT Stop cable 1445 / 1620 mm Renault 58-12 - 106-54, 850-954
GRANIT
To fit as: Renault 58-12, 58-14, 65-12, 65-14, 70-12, 70-14, 75-12, 75-14, 80-12, 80-14, 85-12, 85-14, 95-12, 95-14, 103-12, 103-14, 106-14, 61-12, 61... More
To fit as: Renault 58-12, 58-14, 65-12, 65-14, 70-12, 70-14, 75-12, 75...
€27,65 €22,85
MAHLE Alternator 14 V, 65 A, pulley-Ø 90 mm Lindner, Massey Ferguson, Renault
MAHLE
Nominal voltage (V): 14 | Pulley spacing (mm): 32,5 | Direction of rotation: ↻ | Mounting hole Ø / R (mm): 10,3 / 83,0 | Nominal values (V / A): 14... More
Nominal voltage (V): 14 | Pulley spacing (mm): 32,5 | Direction of rot...
€282,61 €233,56 €176,60 €145,95
You save 38%
GRANIT PTO shaft end piece 1 3/8 inch, 6 splines, 295 mm, 1000 rpm Renault
GRANIT
Version: Length 295 mm, 1 3/8", 6 splines, 1000 rpm. More
Version: Length 295 mm, 1 3/8", 6 splines, 1000 rpm.
€274,34 €226,73 €260,60 €215,37
You save 5%
O-ring oil pump Renault
GRANIT Piston set, complete 4 rings, Ø 105 mm, piston pin Ø 35 x 82 mm
GRANIT
Dimensions: 4 rings, Ø 105 mm, Gudgeon pin Ø 35 x 82 mm, Combustion chamber Ø 62 mm, Combustion chamber depth 20.25 mm, Dry liner. More
Dimensions: 4 rings, Ø 105 mm, Gudgeon pin Ø 35 x 82 mm, Combustion ...
€198,91 €164,39 €188,95 €156,16
You save 5%
Showing 73 - 96 of 103

Renault 75-32 parts for engine rebuilds, hydraulics and the hitch

A Renault 75-32 from the R series stays at work because someone keeps spanners on it. Plenty of owners rebuild the engine themselves, replace the hydraulic pump or swap in a better seat. For jobs like these, this page has more than 100 new replacement parts that fit the Renault 75-32, from GRANIT, Walterscheid, GRAMMER, ROCKINGER and Bosch/Rexroth. They are aftermarket parts rather than dealer stock, and they keep an older tractor going for years.

Engine bearings and injection

For the bottom end there are connecting rod bearings and main bearings. Injection nozzles cover the fuel side, and there is a stop cable for shutting the engine down. The cooling system gets radiator hoses, such as the top hose at the thermostat, and V-belts for engine cooling.

Before you order bearings, measure the crankshaft journals with a micrometer. If the crank has been reground at some point, you need undersize shells, and a standard bearing will not do. The back of the old shells is often stamped with the size. After fitting, check the running clearance with Plastigage and oil the shells generously during assembly.

When you fit an injection nozzle, always use a new copper sealing washer under it. The old washer has been crushed and will not seal properly, so combustion gas blows past and the nozzle seizes in the head, which turns the next removal into a long job.

Hydraulics, linkage and steering

  • A Bosch/Rexroth double pump for the hydraulic system
  • Stabilizer struts and spindles for the three-point linkage
  • Steering ball joints for the front axle
  • Tubes for pipework

Hitch and seat

For hitching there are drawbars with a ball, top drawbars and flange hitches. In the cab, an air suspended GRAMMER tractor seat can replace the old one, which makes a real difference on an older tractor with stiff suspension.

Related R series models

Renault's R series includes many closely related models, so read the serial plate and compare the old part with the product description. Separate pages exist for the Renault 65-12, Renault 65-32, Renault 68-12, Renault 70-12, Renault 75-12 and Renault 681, which helps if you look after more than one Renault. The 77-12 and the 85-34 also belong to this line. Every other Renault tractor in our range can be reached via Renault parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart