Menu
EUR

Renault 75-34 tractor parts & technical data

Trailer couplings and lighting are the best represented groups in this overview for the Renault 75-34. Altogether there are more than 100 matching parts.

91 parts found for Renault 75-34
Show:
GRANIT Outlet valve engine MWM D 226, D 227 Renault
GRANIT
Outlet valve engine MWM D 226, D 227 Renault
€24,55 €20,29
 
Angle drive engine side M18 x 1,5, clockwise rotation - right
5%
Angle drive engine side M18 x 1,5, clockwise rotation - right
€131,53 €108,70 €124,95 €103,26
 
GRANIT Stop cable 1445 / 1620 mm Renault 58-12 - 106-54, 850-954
GRANIT
Stop cable 1445 / 1620 mm Renault 58-12 - 106-54, 850-954
To fit as: Renault 58-12, 58-14, 65-12, 65-14, 70-12, 70-14, 75-12, 75-14, 80-12...
€27,65 €22,85
 
MAHLE Alternator 14 V, 65 A, pulley-Ø 90 mm Lindner, Massey Ferguson, Renault
38%
MAHLE
Alternator 14 V, 65 A, pulley-Ø 90 mm Lindner, Massey Ferguson, Renault
Nominal voltage (V): 14 | Pulley spacing (mm): 32,5 | Direction of rotation: ↻ |...
€282,61 €233,56 €176,60 €145,95
 
GRANIT PTO shaft end piece 1 3/8 inch, 6 splines, 295 mm, 1000 rpm Renault
5%
GRANIT
PTO shaft end piece 1 3/8 inch, 6 splines, 295 mm, 1000 rpm Renault
Version: Length 295 mm, 1 3/8", 6 splines, 1000 rpm.
€274,34 €226,73 €260,60 €215,37
 
Connecting rod bolt Fendt, Renault
Connecting rod bolt Fendt, Renault
€37,50 €30,99
 
Exhaust pipe Renault Ceres 85-954
Exhaust pipe Renault Ceres 85-954
€175,70 €145,21
 
O-ring oil pump Renault
O-ring oil pump Renault
€13,70 €11,32
 
GRANIT Piston set, complete 4 rings, Ø 105 mm, piston pin Ø 35 x 82 mm
5%
GRANIT
Piston set, complete 4 rings, Ø 105 mm, piston pin Ø 35 x 82 mm
Dimensions: 4 rings, Ø 105 mm, Gudgeon pin Ø 35 x 82 mm, Combustion chamber Ø 62...
€198,91 €164,39 €188,95 €156,16
 
GRANIT Flame glow plug 12 V, thread 7/8" UNF Renault 650-954, Ceres 65-95
GRANIT
Flame glow plug 12 V, thread 7/8" UNF Renault 650-954, Ceres 65-95
Version: 12 V, thread 7/8" UNF.
€24,60 €20,33
 
Stabilizer strut 585 mm, Ø 22 mm Renault
5%
Stabilizer strut 585 mm, Ø 22 mm Renault
d: 22 mm. L: 585 mm. Dimensions: Length = 585, Ball Ø = 22 mm.
€257,75 €213,02 €244,85 €202,36
 
Spindle three-point without thread Ø 18 mm, ball-Ø 22,5 mm Renault
5%
Spindle three-point without thread Ø 18 mm, ball-Ø 22,5 mm Renault
Dimensions: Ø = 18, Ball Ø = 22.5 mm.
€54,69 €45,20 €51,95 €42,93
 
GRANIT Hydraulic pump double 16 + 12 cm³ Renault 58-32 - 106-54
5%
GRANIT
Hydraulic pump double 16 + 12 cm³ Renault 58-32 - 106-54
Output volume (cc/rev): 16 + 12
€623,45 €515,25 €592,25 €489,46
 
Radiator hose, top inner-Ø 37 mm Renault
5%
Radiator hose, top inner-Ø 37 mm Renault
Inner Ø: 37 mm.
€50,41 €41,66 €47,85 €39,55
 
Cobo Lamp glass right, left, rear
Cobo
Lamp glass right, left, rear
Installation location: Right, left, rear.
€25,90 €21,41
 
Showing 73 - 91 of 91

Renault 75-34 parts for an engine rebuild, hydraulics and steering

When the engine of a 75-34 comes apart, you want every bearing, bolt and seal on the bench before the first nut is undone. There are more than 100 parts for this Renault from the R series, and a fair number of them belong inside the engine: main bearings, connecting rod bearings, connecting rod bolts and injection nozzles. Around them sit radiator hoses, a hydraulic double pump, ball joints and hitching gear from GRANIT, Walterscheid, GRAMMER, ROCKINGER and Bosch/Rexroth.

Bearings, bolts and injectors

Measure the crankshaft journals before ordering bearings. If they are round and within size, a standard bearing will do. If the crank has been reground, the undersize of the new bearing must match the grind. Connecting rod bolts stretch permanently when they are torqued, so they should never be reused. Have a fresh set ready for every rod you take off.

If the tractor starts poorly or smokes black under load, have the injection nozzles pressure tested by a diesel specialist first. The test shows whether opening pressure and spray pattern are still right before you spend anything. Always fit new copper washers when the nozzles go back in. A stop cable and a tube for the pipework complete the engine side.

Hydraulics, steering and the three-point linkage

  • An anticlockwise double pump for the hydraulic system
  • Ball joints for the track rod
  • Stabilizer struts and spindles for the three-point linkage
  • Flange hitches, ball drawbars and a top drawbar
  • An air suspended GRAMMER tractor seat

A simple trick when changing a ball joint: count the turns it takes to unscrew the old joint from the track rod and screw the new one on by the same amount. Toe-in will then be close, which makes the final adjustment much quicker. Clean and lightly grease the threads of the linkage spindles before setting their length, or the adjustment will seize after a season in the dirt.

Identifying your tractor in the R series

Many tractors in this range look almost identical, so the type plate is the place to confirm you are working on a 75-34. For bearings and nozzles, the number on the old part is the quickest cross-check against the reference number shown with each product.

Other tractors from the range have their own pages listing only the parts that suit them. See the Renault 75-32, Renault 75-12, Renault 65-32, Renault 70-12, Renault 68-12 and Renault 65-12. For the Renault 681, the 85-34 and every other model of the brand, head to Renault parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart