The Same Iron 165.7 has its own page with more than 190 parts. Trailer couplings, lighting and electrics are prefiltered, so you only see what fits.
Over a season, a Same Iron 165.7 ends up pulling all sorts of trailers and trailed machines. The more than 190 parts that fit it start with a full set of hitch components and go on to gaskets for the engine, hydraulic pumps, starter motors and work lamps. Suppliers include GRANIT, Scharmüller, HELLA, ROCKINGER and Sauermann.
For the engine there are cylinder head gaskets, valve cover gaskets and an air receiver gasket. Hydraulic pumps and starter motors round off this group.
When replacing a head gasket, use new head bolts if the manufacturer calls for them and tighten in several stages in a cross pattern to the specified values. Clean both faces thoroughly and check the head with a straight edge. A new gasket on a warped head rarely lasts.
With a new hydraulic pump, clean oil matters as much as the pump itself. Change the hydraulic filter, fill the pump with oil before the first start and let the engine idle without loading the linkage. Then raise and lower the linkage slowly a few times to purge air from the system. A new starter motor needs a good connection too, so clean the earth cable and terminals to bare metal before bolting it in.
With an adaptor plate, the same rail takes either a drawbar or a piton, depending on which trailer is going on that day. Make sure the locking pin drops fully into place every time you swap.
For the driver there are air suspended tractor seats and separate seat parts, plus gas struts for the windscreen frame or the rear window. Outside, HELLA work lamps and reflectors fit. A window that will not stay open points to a tired gas strut, so replace both struts together.
A broken reflector takes minutes to replace and keeps the tractor clearly visible to other traffic on the road after dark.
The type plate confirms the Iron 165.7. For gaskets and the hydraulic pump, the number on the old part is your safest guide, and with a pump you also check the direction of rotation. For hitch parts, measure the rail width on the frame.
From the same Iron range, the Same Iron 100 has its own page, which is the one to use for that model. The rest of the brand is listed on Same parts.