Menu
EUR
Techniek Totaal Logo

We are closed today

Dear visitor!

Welcome to our site. Today is Sunday, a day of rest in the Christian religion. Therefore, we have chosen not to work today, and our webshop is closed. Of course, you are warmly welcome again tomorrow.

Have a nice Sunday and best regards,
Team Techniek Totaal

Tractor parts Fendt Farmer 308 (Typ 178)

Looking for parts for your Fendt Farmer 308 (Typ 178) tractor? In this category, you'll find everything you need for the maintenance and repair of your vehicle.

1063 parts found for Fendt Farmer 308 (Typ 178)
Show:
GRANIT Brake disc organic Ø 165 mm, thickness 13 mm, 22 teeth, bonded Fendt
€42,14 €34,83 €41,30 €34,13
You save 2%
GRANIT As overdrive transmission 40 km/h Fendt
€714,51 €590,50 €607,33 €501,93
You save 15%
GRANIT Clutch body drive shaft Fendt
€291,36 €240,79 €276,79 €228,75
You save 5%
GRANIT Gear wheel main shaft 39 teeth Fendt Farmer 308-311
GRANIT
Number of teeth: 39. More
Number of teeth: 39.
€631,54 €521,93 €536,81 €443,64
You save 15%
GRANIT Gear wheel drive shaft 39 teeth Fendt Farmer 308-311, GT 380
GRANIT
Number of teeth: 39. More
Number of teeth: 39.
€783,17 €647,25 €665,69 €550,16
You save 15%
GRANIT Gaiter gear lever Fendt
€22,17 €18,32 €21,73 €17,96
You save 2%
GRANIT Rod PTO clutch Fendt
€49,62 €41,01 €48,63 €40,19
You save 2%
GRANIT Staggered rivet PTO clutch Fendt
€8,25 €6,82 €8,09 €6,69
You save 2%
GRANIT Thrust piece PTO clutch Fendt Farmer 240S-312, GT 345-395
€15,23 €12,59 €14,93 €12,34
You save 2%
GRANIT Gearshift pattern 21/21 gears Fendt
€12,75 €10,54 €12,50 €10,33
You save 2%
GRANIT Compression spring shifting 19,5 mm, Ø 10,5 mm, wire thickness 1,5 mm Fendt
GRANIT
Dimensions: Length 19,5, Ø 10,5, Wire thickness 1,5. More
Dimensions: Length 19,5, Ø 10,5, Wire thickness 1,5.
€4,02 €3,32 €3,94 €3,26
You save 2%
GRANIT Bearing shell lower gear lever Fendt Farmer, Favorit, GT
€62,34 €51,52 €61,09 €50,49
You save 2%
GRANIT Selector cover upper Fendt
€128,21 €105,96 €121,80 €100,66
You save 5%
GRANIT Shim 0,25 mm Fendt
GRANIT
Thickness: 0,25 mm. More
Thickness: 0,25 mm.
€7,99 €6,60 €7,83 €6,47
You save 2%
GRANIT Shim vane connection 0,15 mm Fendt
GRANIT
Thickness: 0,15 mm. More
Thickness: 0,15 mm.
€7,21 €5,96 €7,07 €5,84
You save 2%
GRANIT Gasket manual transmission top Fendt Farmer 303-309
€22,24 €18,38 €21,80 €18,02
You save 2%
GRANIT O-ring differential right 82,14 x 3,53 mm Fendt
€8,87 €7,33 €8,69 €7,18
You save 2%
GRANIT O-ring differential left 101 x 3 mm Fendt
€6,74 €5,57 €6,61 €5,46
You save 2%
GRANIT Clutch carrier Ø 375 mm Fendt
€318,79 €263,46 €270,97 €223,94
You save 15%
GRANIT Gear wheel constant overdrive 35 teeth Fendt
GRANIT
Number of teeth: 35. More
Number of teeth: 35.
€801,85 €662,69 €681,57 €563,28
You save 15%
GRANIT Spacer lift arm shaft 55,5 x 64 x 10 mm Fendt
GRANIT
Dimensions (mm): 55.5 x 64 x 10. More
Dimensions (mm): 55.5 x 64 x 10.
€9,68 €8,00 €9,49 €7,84
You save 2%
GRANIT Pin stabilizer lower 20 x 110 mm Fendt
GRANIT
Dimensions (mm): 20 x 110. More
Dimensions (mm): 20 x 110.
€23,67 €19,56 €23,20 €19,17
You save 2%
GRANIT Handle Fendt Farmer 310-312, Fendt 714-924
GRANIT
To fit as Fendt. More
To fit as Fendt.
€17,36 €14,35 €17,01 €14,06
You save 2%
GRANIT Window profile door screen right upper
GRANIT
To fit as Fendt. More
To fit as Fendt.
€141,33 €116,80 €134,26 €110,96
You save 5%
Showing 745 - 768 of 1063

Fendt Farmer 308 (Typ 178) specs

The Fendt Farmer 308 with type designation Typ 178 covers the 308 LS and 308 LSA from the Farmer 300 series, built from 1980 to 2000. The "LS" indicates a higher specification level, while the "A" in LSA refers to all-wheel drive. The Typ 178 is therefore the LS/LSA line of the Farmer 308, distinct from the later compact C line (Typ 118). Over the twenty years of production, several revisions were carried out, gradually improving both power output and transmission.

Engine

Power comes from an MWM D 226.4.2, a water-cooled four-stroke four-cylinder inline engine with direct injection, overhead valves, pressure lubrication, inline injection pump (Bosch PES 4 A 80 D 320/3 RS 1301), multi-hole injector nozzles, centrifugal governor and dry cylinder liners. Cooling is handled by a thermostatically controlled dual-circuit system. Displacement is 4.2 litres (bore x stroke: 105 x 120 mm), rated engine speed is 2,400 rpm. Maximum torque was initially 275 Nm at 1,498 rpm.

From 1989 the turbocharged MWM TD 226 B-4 was used (rated speed 2,250 rpm, 26% torque increase). Power rose from 78 hp (1980) to 82 hp in 1989 and further to 86 hp (approx. 63 kW) in 1991. Maximum torque increased from 321 Nm at 1,550 rpm (1989) to 337 Nm at 1,550 rpm (1991). From approximately the 1989 model year, wet cylinder liners were used.

Transmission and travel speeds

The 308 LS and 308 LSA were delivered with a fully synchronised gearbox. The first generation had 15 forward and 4 reverse gears (15/4), with two overdrive speeds for 25/30 or 30/40 km/h. In 1984 this became a 21/6 gearbox, followed in 1991 by the optional 21/21 reverser transmission. Top speed is 30 km/h as standard, with an optional 40 km/h version. Shifting is handled via a Voith fluid coupling type 358 TD-F (from 1989: 360 TD-F2, from 1990: 360 TD-F1) and a Fichtel & Sachs single-disc dry clutch type GT NX 310 (from 1984: GTF 320 N or GTF 320 N-295).

The front axle of the LSA is a load-switchable ZF oscillating axle type APL-1552 (from 1984: APL-335, from 1989: APL-735, from 1990: APL-700 F3), with a lateral driveshaft and self-locking "Locomatik" differential.

Hydraulics and lift capacity

The hydraulic system is a Fendt block-type control hydraulic with mechanical lift control (MHR) and top link sensing. The three-point linkage is category II, available on request with a quick coupler. A single-acting working cylinder with an 86 mm bore and 137.4 mm stroke is fitted as standard; optionally two additional working cylinders with a 45 mm bore and 181 mm stroke.

  • Early pump flow: 39.95 l/min at 175 bar (as three-circuit system 66 l/min)
  • Max. early lift capacity: 3,490 kp / lift travel 660 mm
  • From 1984: 180 bar working pressure, max. lift capacity 3,820 kp
  • Later model: 71 l/min at 180 bar, max. lift capacity 4,420 kp
  • Optional front hydraulics (cat. II): two working cylinders 28 mm bore, 162 mm stroke, max. lift capacity 24.6 kN

PTO

The PTO is switchable to 540, 750 and 1,000 rpm. A ground-speed PTO is available on request (9.6 PTO revolutions per wheel revolution). Maximum permissible torque: 1,750 Nm at 540 rpm, 1,100 Nm at 750 rpm and 900 Nm at 1,000 rpm. From 1991, front and rear axle are electrohydraulically switchable.

Dimensions and weights

  • Length: approx. 4.0 m
  • Width: approx. 2.14 m
  • Height: approx. 2.7 m
  • Wheelbase: approx. 2.28 m
  • Unladen weight 308 LS: approx. 3,795 kg / permissible total weight: 6,500 kg
  • Unladen weight 308 LSA: approx. 3,870 kg / permissible total weight: 6,500 kg

Tyres and brakes

Standard tyre sizes are 13.6R24 front and 16.9R34 rear. The parking brake is an internal shoe brake on the differential output shafts. A single- or dual-circuit compressed air braking system was available as an option. At 40 km/h, drum brakes in the front wheels are mandatory; at 30 km/h they are optional.

Cab

The tractor comes with a sound-insulated comfort cab with a noise level of 73.5 dB(A), an air-suspended seat, tinted glass, adjustable front, side and rear windows and an opening roof hatch. Standard equipment includes heating with a three-speed blower, interior lighting, a radio pre-installation with two speakers, electrically adjustable exterior mirrors, digital instruments and rear work lights. Optional extras include air conditioning (later versions), front work lights, particulate filter and H4 supplementary front lighting.

Production numbers Typ 178

The 308 LS was built in the following series: T 178.010 (1980-1984, 2,633 units), T 178.011 (1984-1988, 596 units), T 178.050 (1989, 37 units), T 178.060 (1989-1990, 73 units), T 178.061 (1990-1991, 50 units), T 178.062/063/064 (1991-1993, 14/24/28 units) and T 178.065 (1993-1998, 206 units). The 308 LSA ran from T 178.210 (1980-1984, 5,498 units) and T 178.211 (1984-1988, 2,964 units) through to T 178.265 (1993-1998, 2,263 units).

Parts and brands for the Fendt Farmer 308 (Typ 178)

We stock a wide range of parts for the Fendt Farmer 308 Typ 178, including engine parts, filters, brake parts, hydraulic components, exhaust parts, electrical components and cab parts. We work with brands such as Granit, Agco Parts, Bosch, Hella, Mahle, Mann-Filter, Kramp, Grammer, Cobo, Scharmüller and Walterscheid, so there is always a choice between an original part or a well-fitting alternative.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart