Web Analytics
Fendt Favorit 600 (Typ 280) tractor parts & specs
Menu
EUR

Tractor parts Fendt Favorit 600 (Typ 280)

Looking for parts for your Fendt Favorit 600 (Typ 280) tractor? In this category, you'll find everything you need for the maintenance and repair of your vehicle.

257 Products
Show:
GRANIT Driver For angle drive/drive shaft
7%
GRANIT
Driver For angle drive/drive shaft
€135,40 €111,90 €125,92 €104,07
 
GRANIT Starter 12 V / 2.7 kW - Nominal voltage: 12 V, Nominal power: 2,7 kW, No. of pinion teeth: 9
7%
GRANIT
Starter 12 V / 2.7 kW - Nominal voltage: 12 V, Nominal power: 2,7 kW, No. of pinion teeth: 9
Nominal voltage (V): 12 | Nominal power (kW): 2,7 | No. of pinion teeth: 9 | Hol...
€259,27 €214,27 €241,12 €199,27
 
GRANIT Gasket manual transmission top
5%
GRANIT
Gasket manual transmission top
€50,37 €41,63 €47,85 €39,55
 
GRANIT Gasket transfer case, bottom
5%
GRANIT
Gasket transfer case, bottom
€3,69 €3,05 €3,51 €2,90
 
GRANIT O-ring differential gear, right, Ø 82,14 x 3,53 mm
5%
GRANIT
O-ring differential gear, right, Ø 82,14 x 3,53 mm
€8,63 €7,13 €8,20 €6,78
 
GRANIT Protective ring rear axle, inner
5%
GRANIT
Protective ring rear axle, inner
€13,94 €11,52 €13,24 €10,94
 
GRANIT Bearing bush 75 x 70 x 40 mm
7%
GRANIT
Bearing bush 75 x 70 x 40 mm
€131,77 €108,90 €122,55 €101,28
 
KS Piston ring set 4 rings, Ø 100 mm, 2.75 mm (trapezoidal ring) / 2 mm / 2 mm / 4 mm
5%
KS
Piston ring set 4 rings, Ø 100 mm, 2.75 mm (trapezoidal ring) / 2 mm / 2 mm / 4 mm
Dimensions: 4 rings, Ø 100 mm, 2.75 mm (trapezoidal ring) / 2 mm / 2 mm / 4 mm.
€60,68 €50,15 €57,68 €47,67
 
GRANIT Feed pump
7%
GRANIT
Feed pump
Version: 3 holes, Vertical hole spacing = 50 mm, Horizontal hole spacing = 34 mm...
€133,35 €110,21 €124,02 €102,50
 
GRANIT Vibration damper
5%
GRANIT
Vibration damper
€14,53 €12,01 €13,80 €11,41
 
GRANIT Radiator hose water pump suction pipe
5%
GRANIT
Radiator hose water pump suction pipe
Inner Ø: 32 / 36 mm.
€21,36 €17,65 €20,29 €16,77
 
GRANIT Exhaust valve
5%
GRANIT
Exhaust valve
€19,11 €15,79 €18,15 €15,00
 
GRANIT Washer
GRANIT
Washer
€1,36 €1,12
 
GRANIT Gasket for oil filter head
5%
GRANIT
Gasket for oil filter head
€6,17 €5,10 €5,86 €4,84
 
GRANIT Clamp half for MWM engine
5%
GRANIT
Clamp half for MWM engine
€9,85 €8,14 €9,36 €7,74
 
GRANIT Spindle for lifting strut
7%
GRANIT
Spindle for lifting strut
Dimensions: Length = 300, Thread = M28 x 2 mm.
€160,40 €132,56 €149,17 €123,28
 
GRANIT Relay changeover
5%
GRANIT
Relay changeover
Version: 12 V / 30 - 40 A, With bracket, 5-pin, blade terminal.
€6,73 €5,56 €6,39 €5,28
 
Showing 241 - 257 of 257

Fendt Favorit 600 (Typ 280) specifications

The Fendt Favorit 600 LS carries the internal type designation T 280 and was built from 1978 to 1981. A total of 1,631 units were produced, of which 386 had rear-wheel drive (chassis number T 280.010) and 1,245 had four-wheel drive (chassis number T 280.210). Production was discontinued after just three years due to insufficient commercial success. The intention was to extend the power range of the Favorit 600 series downwards, but the market did not respond as expected. The 600 LS is therefore the only model in the LS line of the 600 series that did not receive a successor in the LSA range.

The four-wheel drive version was also informally referred to as the 600 LSA, although this was not an official model designation. The difference from the 610 LS is that the 600 LS produces 10 hp less and has a slightly lower maximum torque figure, while both use the same MWM D 227 engine.

Engine and power

The Favorit 600 LS is fitted with an MWM D 227.6.2, a water-cooled six-cylinder four-stroke inline diesel engine without turbocharger and with direct injection. The engine features overhead valves, an inline injection pump with governor, a multi-hole injector, a seven-bearing crankshaft, a gear-driven camshaft, pressure circulation lubrication, a dry air filter and thermostatically controlled dual-circuit cooling with a flat-fin radiator. The governed speed range runs from 650 to 2,450 rpm and minimum oil pressure at rated speed is 2.0 bar.

Power output is 85 hp. Maximum torque is 324 Nm at 1,450 rpm.

Transmission and travel speed

Top speed is 30 km/h. In the slow range, the six gears run from 2.47 to 23.36 km/h, in the fast range from 3.09 to 29.18 km/h. A third range is also available with gears running from 3.42 to 19.91 km/h.

Power take-off

The PTO is switchable between 540 and 1,000 rpm. An optional front PTO is available.

Hydraulics and lift system

The hydraulic pump delivers 40 litres per minute. The rear three-point hitch features draft, position and mixed control. An optional front linkage is available.

Brakes and steering

The brakes are hydraulically operated. Steering is hydrostatically assisted. An optional single or dual-circuit compressed air braking system was available.

Dimensions and weight

  • Length: 480 cm
  • Height: 283 cm
  • Unladen weight: 5,170 kg
  • Fuel tank: 222 litres

Standard tyre sizes are 16.9R38 at the rear and 12.4R28 at the front. The cab is a rubber-mounted, vibration and sound-insulated safety cab with a noise level of 81 dB, fold-open front and rear windows, three-stage ventilation system, two-stage heating and radio preparation.

Position in the series and difference from the 610 LS

The 600 LS is the smallest and least powerful model in the LS line of the Favorit 600 series. Compared to the 610 LS (Typ 281), the 600 LS produces 10 hp less at a lower maximum torque, but technically the two models are closely related. Both use the MWM D 227 engine, the same cab and the same basic construction. Due to the short production period of only three years, examples of the 600 LS are rarer than the other models in the series, which also affects the availability of spare parts.

Brands
  • View more
Guide width
Connecting pin
Length of gas strut
Newton
Price
Min Max
Close
Choose your language
Choose your currency

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart