Menu
EUR

Fendt Favorit 611 (Typ 382) parts

Looking for parts for your Fendt Favorit 611 (Typ 382) tractor? In this category, you'll find everything you need for the maintenance and repair of your vehicle.

527 parts found for Fendt Favorit 611 (Typ 382)
Show:
GRANIT Rotary switch heating, fan, black button, 5 connections
2%
GRANIT
Rotary switch heating, fan, black button, 5 connections
Version: For heater, blower, With 5 blade terminals.
€76,10 €62,89 €74,58 €61,64
 
GRANIT Push button switch marker-/parking light 12/24 V, button yellow
2%
GRANIT
Push button switch marker-/parking light 12/24 V, button yellow
Version: 12/24 V, Yellow button, with lock, Ø 30 mm, 4 blade terminals 6.3 x 0.8...
€39,03 €32,26 €38,25 €31,61
 
GRANIT Reflector round yellow, Ø 61 mm, bore Ø 5,2 mm
2%
GRANIT
Reflector round yellow, Ø 61 mm, bore Ø 5,2 mm
Colour: Yellow | Hole Ø (mm): 5.2 | Total Ø (mm): 61
€1,57 €1,30 €1,54 €1,27
 
SACEX Beacon H1 Saturnello orange 12 V, Ø 128 mm, 204 mm, push-on pin
2%
SACEX
Beacon H1 Saturnello orange 12 V, Ø 128 mm, 204 mm, push-on pin
Nominal voltage: 12 V. Bulbs included: Yes. Light function: Rotating. Diameter: ...
€40,90 €33,80 €40,08 €33,12
 
HELLA Work lamp flood beam H3 55 / 70 W, 12 / 24 V, 154 x 128 x 77 mm
2%
HELLA
Work lamp flood beam H3 55 / 70 W, 12 / 24 V, 154 x 128 x 77 mm
Bulb: H3. Form: Rectangular. Material: Housing: plastic, lens: glass. Dimensions...
€42,96 €35,50 €42,10 €34,79
 
GRANIT Reflector round red Ø 80 mm, bore Ø 5,5 mm, screwed
2%
GRANIT
Reflector round red Ø 80 mm, bore Ø 5,5 mm, screwed
Form: Round. Mounting type: Bolted. Colour: Red. Total Ø: 80 mm. Hole Ø: 5.5 mm....
€5,30 €4,38 €5,19 €4,29
 
GRANIT Tail light holder
2%
GRANIT
Tail light holder
€75,13 €62,09 €73,63 €60,85
 
GRANIT Pipe RKLE
2%
GRANIT
Pipe RKLE
€97,77 €80,80 €95,81 €79,18
 
HELLA Work lamp flood beam H3 35 / 70 W, 12 / 24 V, 154 x 104 x 84 mm
2%
HELLA
Work lamp flood beam H3 35 / 70 W, 12 / 24 V, 154 x 104 x 84 mm
Bulb: H3. Bulbs included: No. Light function: Close-range illumination. Dimensio...
€36,91 €30,50 €36,17 €29,89
 
GRANIT Cover
2%
GRANIT
Cover
€55,54 €45,90 €54,43 €44,98
 
HELLA Work lamp flood beam H3, 12 / 24 V, 35 / 70 W, square, mounting, bolted
2%
HELLA
Work lamp flood beam H3, 12 / 24 V, 35 / 70 W, square, mounting, bolted
Bulb: H3. Connection: Blade terminal. Form: Rectangular. Material: • Housing: pl...
€54,33 €44,90 €53,24 €44,00
 
Cobo Work lamp H3, 12 V, 55 W, angular, 158 x 96 x 85 mm, hanging
2%
Cobo
Work lamp H3, 12 V, 55 W, angular, 158 x 96 x 85 mm, hanging
Bulb: H3. Form: Rectangular. Dimensions W x H x D: 158 x 96 x 85 mm. Nominal vol...
€94,68 €78,25 €92,79 €76,69
 
GRANIT Relays N/O-contact 12 V / 2x 20 A, 5-pin, with holder, blade terminal
2%
GRANIT
Relays N/O-contact 12 V / 2x 20 A, 5-pin, with holder, blade terminal
Version: 12 V / 2 x 20 A, with holder, 5-pin, blade terminal.
€8,53 €7,05 €8,36 €6,91
 
HELLA Glass rear light right, 3 light functions, lamp P21W, R10W
15%
HELLA
Glass rear light right, 3 light functions, lamp P21W, R10W
To fit as: John Deere 940, 1040, 1140, 940V, 1040V, 1140V, 1750V, 1850V, 1140F, ...
€19,63 €16,22 €16,61 €13,73
 
GRANIT Seal feed pump
GRANIT
Seal feed pump
To fit as: Deutz DX 140, 145, 160
€2,42 €2,00
 
Set of parts filter glass Ø 29/35 x 53 mm
33%
Set of parts filter glass Ø 29/35 x 53 mm
Ø: 29/35 mm. Height: 33 mm.
€10,38 €8,58 €6,98 €5,77
 
Stabilus Windshield frame shock absorber 250 N, 600,5 mm, stroke 252,5 mm Fendt
2%
Stabilus
Windshield frame shock absorber 250 N, 600,5 mm, stroke 252,5 mm Fendt
To fit as: Fendt Windscreen
€40,92 €33,82 €40,10 €33,14
 
GRANIT Top link ball cat. 3 Ø 59 mm Fendt
2%
GRANIT
Top link ball cat. 3 Ø 59 mm Fendt
Tractor types: Fendt Farmer 409, 410, 411, 412. Fendt Farmer 600, 610, 612, 614,...
€33,48 €27,67 €32,81 €27,12
 
GRANIT Outlet valve engine D 327 Fendt F 231 GT
2%
GRANIT
Outlet valve engine D 327 Fendt F 231 GT
To fit as: Fendt F 231 GT from serial no. 16774
€22,39 €18,50 €21,94 €18,13
 
GRANIT Thrust bearing 60 x 104 x 93 mm Fendt Favorit 611 - 615
GRANIT
Thrust bearing 60 x 104 x 93 mm Fendt Favorit 611 - 615
Dimensions (mm): 60 x 104 x 93
€411,41 €340,01
 
Elring Valve cover gasket MWM D226B, TD226B Fendt Farmer 304 - Favorit 615
2%
Elring
Valve cover gasket MWM D226B, TD226B Fendt Farmer 304 - Favorit 615
€6,03 €4,98 €5,90 €4,88
 
Wabco Cover antifreeze pump Fendt, Massey Ferguson, Case IH
2%
Wabco
Cover antifreeze pump Fendt, Massey Ferguson, Case IH
€62,07 €51,30 €60,83 €50,27
 
Wabco Compressor 10 bar, 159 cm³, Ø 75 mm, stroke 36 mm, M18 x 1,5 Fendt
Wabco
Compressor 10 bar, 159 cm³, Ø 75 mm, stroke 36 mm, M18 x 1,5 Fendt
Operating pressure max.: 10 bar. Cylinder capacity: 159 cm³. Speed: 3000 1/min.....
€2.600,46 €2.149,14
 
Showing 337 - 360 of 527

Fendt Favorit 611 (Typ 382) specifications

The Fendt Favorit 611 LSA carries the internal type designation T 382 and was built from 1985 to 1993 exclusively with four-wheel drive. A total of 1,433 units were produced. The 611 LSA is the successor to the 611 LS (Typ 282) and at the same time the conclusion of a development line that began in 1972 with the Favorit 611 S. The LS version with rear-wheel drive falls under Typ FWA 282.

Production ran in two clearly distinct phases. In the first phase (chassis number T 382.250, 1985 to 1987, 228 units), the engine has no turbocharger and produces 115 hp. In the second phase (chassis number T 382.211, 1988 to 1993, 1,205 units), a turbocharger was added and the combustion process optimised, raising output to 125 hp while fuel consumption fell. The 611 LSA was succeeded in the line-up by the Favorit 500C series.

Hydraulics and lift system

The hydraulic tandem pump delivers 69 litres per minute (44 plus 25 litres) at 180 bar. The rear three-point hitch achieves a maximum lift capacity of 7,410 kg. An optional front linkage with category II three-point hitch is available with a maximum lift capacity of 3,940 kg. The permissible front axle load is 3,050 kg and the rear axle load 5,400 kg. The permissible gross weight is 8,500 kg.

Engine

The second phase (1988 to 1993) uses an MWM TD 226-B 6, a water-cooled six-cylinder four-stroke inline turbodiesel engine with direct injection into the combustion bowl of the piston. The engine is fitted with individually mounted cylinder heads, piston crown cooling, an oil cooler, Rotocap valves, a viscous fan, an inline injection pump, a multi-hole injector, a dry air filter with pre-cleaner, pressure circulation lubrication, an exhaust turbocharger with pulse charging and thermostatically controlled dual-circuit cooling. Displacement is 6,240 cc. Maximum torque is 497 Nm at 1,500 rpm. Injection pressure is 180 to 185 bar, raised to 650 bar from 1987.

The first phase (1985 to 1987) has a naturally aspirated MWM D 226.6.2 without turbocharger producing 115 hp, with a maximum torque of 412 Nm at 1,500 rpm.

Transmission and travel speed

The 611 LSA has a helical-cut ZF fully synchronised fine-step gearbox type T 3345 with side-mounted gear selection, offering 20 forward and 9 reverse gears. Top speed is 40 km/h in the standard version, with a 30 km/h version also available. In the 40 km/h version, the six gears in the fast range run from 3.88 to 38.41 km/h, in the slow range from 3.12 to 30.94 km/h and in the creep range from 4.71 to 27.41 km/h. From 1987, the Duospeed drive system was available as an option, along with an electronically controlled differential lock and a reversing unit.

Power take-off

The PTO is switchable between 540 and 1,000 rpm. An optional front PTO is available.

Brakes and steering

The braking system consists of hydraulically operated full disc brakes on the rear wheels, usable as individual wheel brakes. A propshaft disc brake acts on the four-wheel drive; when the individual wheel brake is applied, the front wheel brake disengages automatically. The parking brake is mechanically operated as an internal shoe brake. Steering is hydrostatically assisted.

Dimensions and weight

  • Unladen weight: 6,080 kg
  • Fuel tank: 222 litres
  • Fuel consumption at maximum power: 223 g/kWh

Standard tyre sizes are 14.9-26 at the front and 18.4R38 at the rear. The cab is a rubber-mounted, vibration and sound-insulated safety cab with a noise level of 78 dB, air-suspended seat, digital tractor meter, fold-open front and rear windows, roof hatch, three-stage ventilation system, two-stage heating, radio preparation and height-adjustable steering wheel.

Difference from the 611 LS (Typ 282)

The difference between Typ 382 and Typ 282 is a recurring point when sourcing parts and when purchasing. The Typ 282 is the LS series, built from 1977 to 1984, available with either rear-wheel or four-wheel drive and producing 100 to 110 hp from a naturally aspirated engine. The Typ 382 is available exclusively with four-wheel drive, has a turbocharged engine in its second phase, a higher hydraulic pump output and higher permissible axle loads. The gearbox on both types is a ZF T 3345, but the configuration differs between phases.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart