Menu
EUR

Fendt 818 Vario (Typ 718) tractor parts & technical data

With Typ 718 on the type plate, you are in the right place: more than 600 parts for the Fendt 818 Vario, including lighting, electrics and trailer couplings.

605 parts found for Fendt 818 Vario
Show:
GRANIT Brake disc Ø 224 x 5 mm, 36 teeth Fendt, Massey Ferguson
GRANIT
Dimensions: Ø 224, 36 splines, Thickness 5 mm. More
Dimensions: Ø 224, 36 splines, Thickness 5 mm.
€61,67 €50,97 €58,55 €48,39
You save 5%
Bush for Vario drive assembly Fendt, Massey Ferguson
€57,62 €47,62 €54,70 €45,21
You save 5%
GRANIT Starter ring gear Ø 393/364 mm, 129 teeth Fendt
GRANIT
Version: Ø 393/364 mm, 129 teeth. More
Version: Ø 393/364 mm, 129 teeth.
€78,01 €64,47 €74,10 €61,24
You save 5%
GRAMMER Tractor seat Maximo XT Evolution Dynamic air suspended fabric 550 mm
GRAMMER
To fit: Fendt new SCR and S4. Suspension: Air suspension. Upholstery type: Fabric / new design. Seat contact switch: Yes. Track gauge: 380 mm. Seat wi... More
To fit: Fendt new SCR and S4. Suspension: Air suspension. Upholstery t...
€7.672,53 €6.340,93 €7.288,90 €6.023,88
You save 5%
FAG Deep groove ball bearing 6205 2RS C3, 25 x 52 x 15 mm Fendt
FAG
Ø D: 52 mm. Outer Ø: 52 mm. B: 15 mm. Series: 62. Description: 6205 2RS C3. Width: 15 mm. Inner Ø: 25 mm. Material: Steel. Ø d: 25 mm. Type of bea... More
Ø D: 52 mm. Outer Ø: 52 mm. B: 15 mm. Series: 62. Description: 6205 ...
€14,35 €11,86
VICTOR REINZ Cylinder head gasket 3 bores engine BF6M2013 Fendt 711-716, 815-818
€180,45 €149,13 €171,40 €141,65
You save 5%
VICTOR REINZ Cylinder head gasket 2 bores engine BF6M2013 Fendt
€178,77 €147,74 €169,80 €140,33
You save 5%
GRANIT Engine gasket set without head gasket engine BF6M2013 Fendt
€615,09 €508,34 €584,30 €482,89
You save 5%
Fuel cooler Fendt 712-820
€658,08 €543,87 €625,15 €516,65
You save 5%
V-belt pulley Fendt
€286,18 €236,51 €271,85 €224,67
You save 5%
GRANIT Hollow shaft V-belt tensioner Fendt
GRANIT Rubber elbow heating / cab Ø 17 mm Fendt
GRANIT
Inner Ø: 17 mm. More
Inner Ø: 17 mm.
€52,71 €43,56 €50,00 €41,32
You save 5%
GRANIT Cooling fan Ø 530 mm, 9 fins Fendt Favorit 714-716, 815-818
GRANIT
Ø: 530 mm. Notes: 9 Blätter. More
Ø: 530 mm. Notes: 9 Blätter.
€360,68 €298,08 €342,60 €283,14
You save 5%
GRANIT V-belt Powerband Fendt
€62,54 €51,69 €59,40 €49,09
You save 5%
Hose elbow reservoir Ø 30/35 mm Fendt
Inner Ø: 30 / 35 mm. More
Inner Ø: 30 / 35 mm.
€36,85 €30,45
Optibelt Multi-rib belt 8 ribs Fendt, Case IH, Steyr, New Holland, Deutz-Fahr
€81,93 €67,71 €77,80 €64,30
You save 5%
Disc 2 mm Farmer 409-412, Favorit 711-716 Fendt
€49,03 €40,52 €46,55 €38,47
You save 5%
GRANIT Seal engine ventilation Fendt
Intake pipe intercooler Fendt 714-818
€133,21 €110,09 €126,50 €104,55
You save 5%
Stud bolt exhaust M8 / M10, 102 mm
Thread: M8 / M10. Length: 102 mm. Version: Thread M8 / M10, Length: 102 mm. More
Thread: M8 / M10. Length: 102 mm. Version: Thread M8 / M10, Length: 10...
€23,80 €19,67
GRANIT Push rod Fendt
€56,60 €46,78
Showing 409 - 432 of 605

Fendt 818 Vario Typ 718 parts and wear items

Check the identification plate before anything else. If it reads Typ 718, this page is for your tractor: it lists only the parts intended for the Fendt 818 Vario in that version, more than 600 of them. A different Typ number means you are better served by Fendt 818 Vario (Typ 729), or by the general Fendt 818 Vario page, which covers both versions together.

What gets replaced on a Typ 718

Wear starts with the small items. There are seals, including the seal for the tank sensor, and discs and bushes for hinges and pivot points. Pins keep the lower links and the hitch where they belong, and complete Scharmüller drawbars are here too, such as the K80 with its locking pin.

Around the cab you will find gas struts for the windscreen frame, handles for the body panels and push button switches. Lighting is covered by work lamps, rear lights and holders. Starter motors and alternators look after the electrical side, and GRAMMER tractor seats look after the driver. Other brands on this page are GRANIT, HELLA and Wabco.

Replacing the linkage potentiometer

When the rear linkage jerks, hangs or will not lower to its set position, the linkage potentiometer is a common cause. It reports the position of the lift arms to the control unit. Check the plug and wiring first, since a corroded contact gives exactly the same symptoms. If the potentiometer itself is worn, lower the arms fully before removing it and note the position of the driver lever. After fitting, the linkage control normally has to relearn its end positions. Do that before you hitch up a heavy implement again.

Not sure a part is the right one? Compare the reference number on the old part with the details of the new one before ordering.

If the starter motor only clicks or turns slowly, measure the battery voltage first and check the heavy cables and the earth connection. A poor contact gives exactly those symptoms. With a drawbar, pay attention to the rail width and the thickness of the locking pin, because two drawbars that look the same can differ there.

The rest of the Fendt 800 line

If you look after more than one Fendt, every model in the line has its own page with matching parts: Fendt 815 Vario, Fendt 820 Vario, Fendt 822 Vario, Fendt 824 Vario, Fendt 826 Vario and Fendt 828 Vario. The whole make is under Fendt parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart