Web Analytics
Fendt Favorit 611 (Typ 382) Parts & Specs
Menu
EUR

Fendt Favorit 611 (Typ 382) parts

Looking for parts for your Fendt Favorit 611 (Typ 382) tractor? In this category, you'll find everything you need for the maintenance and repair of your vehicle.

432 Products
Show:
GRANIT Valve guide for inlet and exhaust valve
€22,30 €18,43 €21,85 €18,06
You save 2%
GRANIT Valve stem seal
€2,66 €2,20 €2,61 €2,16
You save 2%
GRANIT Gasket for oil filter head
€6,17 €5,10 €6,05 €5,00
You save 2%
GRANIT Piston complete
GRANIT
Menke no.: 53212. More
Menke no.: 53212.
€137,15 €113,35 €130,29 €107,68
You save 5%
GRANIT Ball pin steel
GRANIT
A: M6 mm. SW: 8. E: 10 mm. More
A: M6 mm. SW: 8. E: 10 mm.
€4,26 €3,52 €4,17 €3,45
You save 2%
GRANIT Door handle right and left
€38,24 €31,60 €37,48 €30,98
You save 2%
GRANIT Locking claw rear screen
€28,21 €23,31 €27,65 €22,85
You save 2%
GRANIT Push button insert
€32,84 €27,14 €32,18 €26,60
You save 2%
GRANIT Force measuring pin 40 kN
GRANIT
Dimensions: Length = 158.3, Ø = 36.8 mm. Ø: 36,8 mm. Length: 158,3 mm. More
Dimensions: Length = 158.3, Ø = 36.8 mm. Ø: 36,8 mm. Length: 158,3 m
€570,76 €471,70 €485,15 €400,95
You save 15%
GRANIT Gas strut
GRANIT
Newtons: 120. A: 225 mm. B: 130 mm. C: 6 mm. D: 6 mm. To fit: roof hatch. Form: 1. Menke no.: 54809. More
Newtons: 120. A: 225 mm. B: 130 mm. C: 6 mm. D: 6 mm. To fit: roof hat...
€23,17 €19,15 €22,71 €18,77
You save 2%
GRANIT Mirror
GRANIT
Dimensions: 260 x 148 mm. Height: 260 mm. Width: 148 mm. Radius of curvature: 1400 mm. Version: Unheated. Installation location: Right/left. Material:... More
Dimensions: 260 x 148 mm. Height: 260 mm. Width: 148 mm. Radius of cur...
€98,36 €81,29 €96,39 €79,66
You save 2%
GRANIT Tension spring
€3,15 €2,60 €3,09 €2,55
You save 2%
GRANIT Rubber washer for window that can be opened, right and left
€1,52 €1,26 €1,49 €1,23
You save 2%
GRANIT Detent bearing
€19,90 €16,45 €19,50 €16,12
You save 2%
GRANIT Cut-out switch PTO shaft
GRANIT
Version: Make contact (lever function), Normally off, 2 blade terminals. More
Version: Make contact (lever function), Normally off, 2 blade terminal...
€93,45 €77,23 €91,58 €75,69
You save 2%
GRANIT Brake light switch Mechanical
GRANIT
Version: Break contact, normally on. More
Version: Break contact, normally on.
€87,83 €72,59 €86,07 €71,13
You save 2%
GRANIT Temperature switch, oil temperature 6 - 24 V
GRANIT
Version: Temperature switching point: 102°C ± 3°C, Thread: M14 x 1.5, Contact closes as the temperature increases, Outlet: 1-pin via earth, Switchi... More
Version: Temperature switching point: 102°C ± 3°C, Thread: M14 x 1....
€80,97 €66,92 €79,35 €65,58
You save 2%
HELLA Symbol Air conditioning
HELLA
Version: Green, air conditioning. Colour: grün. To fit: HELLA Schalter Serien 4570 und 7832. Symbol: Klimaanlage. More
Version: Green, air conditioning. Colour: grün. To fit: HELLA Schalte...
€2,30 €1,90 €2,25 €1,86
You save 2%
GRANIT Push button switch Hazard warning lights
GRANIT
Version: 12/24 V, Red button, with lock, Ø 30 mm, 7 blade terminals 6.3 x 0.8 (L- R- 30- 30b- 49a- 15- 49), dustproof and splashproof, With glass soc... More
Version: 12/24 V, Red button, with lock, Ø 30 mm, 7 blade terminals 6...
€41,29 €34,12 €40,46 €33,44
You save 2%
SACEX H1 rotating beacon Saturnello 12V | Socket pipe
SACEX
Nominal voltage: 12 V. Bulbs included: Yes. Light function: Rotating. Diameter: 128 mm. Total height: 204 mm. Connection: Socket pipe. Protection clas... More
Nominal voltage: 12 V. Bulbs included: Yes. Light function: Rotating. ...
€40,29 €33,30 €39,48 €32,63
You save 2%
HELLA Reflectors
HELLA
Colour: Red. Width: 94 mm. Height: 44 mm. Material thickness: 6 mm. Hole Ø: 4.3 mm. Hole spacing: 70 mm. Additional information: • 33 cm² effectiv... More
Colour: Red. Width: 94 mm. Height: 44 mm. Material thickness: 6 mm. Ho...
€2,32 €1,92 €2,27 €1,88
You save 2%
GRANIT Thermostat Ø 45 x 45 x 25 mm 75°C
GRANIT
To fit as: Fendt Farmer 310, 311, 312, Favorit 611, 612, 614, 615 More
To fit as: Fendt Farmer 310, 311, 312, Favorit 611, 612, 614, 615
€266,11 €219,93 €252,80 €208,93
You save 5%
MANN-FILTER Fuel filter WDK725
€20,52 €16,96 €13,01 €10,75
You save 37%
GRANIT Hitch pin Ø 31 mm - 150 mm - 480 mm
€35,79 €29,58 €35,07 €28,98
You save 2%
Showing 97 - 120 of 432

Fendt Favorit 611 (Typ 382) specifications

The Fendt Favorit 611 LSA carries the internal type designation T 382 and was built from 1985 to 1993 exclusively with four-wheel drive. A total of 1,433 units were produced. The 611 LSA is the successor to the 611 LS (Typ 282) and at the same time the conclusion of a development line that began in 1972 with the Favorit 611 S. The LS version with rear-wheel drive falls under Typ FWA 282.

Production ran in two clearly distinct phases. In the first phase (chassis number T 382.250, 1985 to 1987, 228 units), the engine has no turbocharger and produces 115 hp. In the second phase (chassis number T 382.211, 1988 to 1993, 1,205 units), a turbocharger was added and the combustion process optimised, raising output to 125 hp while fuel consumption fell. The 611 LSA was succeeded in the line-up by the Favorit 500C series.

Hydraulics and lift system

The hydraulic tandem pump delivers 69 litres per minute (44 plus 25 litres) at 180 bar. The rear three-point hitch achieves a maximum lift capacity of 7,410 kg. An optional front linkage with category II three-point hitch is available with a maximum lift capacity of 3,940 kg. The permissible front axle load is 3,050 kg and the rear axle load 5,400 kg. The permissible gross weight is 8,500 kg.

Engine

The second phase (1988 to 1993) uses an MWM TD 226-B 6, a water-cooled six-cylinder four-stroke inline turbodiesel engine with direct injection into the combustion bowl of the piston. The engine is fitted with individually mounted cylinder heads, piston crown cooling, an oil cooler, Rotocap valves, a viscous fan, an inline injection pump, a multi-hole injector, a dry air filter with pre-cleaner, pressure circulation lubrication, an exhaust turbocharger with pulse charging and thermostatically controlled dual-circuit cooling. Displacement is 6,240 cc. Maximum torque is 497 Nm at 1,500 rpm. Injection pressure is 180 to 185 bar, raised to 650 bar from 1987.

The first phase (1985 to 1987) has a naturally aspirated MWM D 226.6.2 without turbocharger producing 115 hp, with a maximum torque of 412 Nm at 1,500 rpm.

Transmission and travel speed

The 611 LSA has a helical-cut ZF fully synchronised fine-step gearbox type T 3345 with side-mounted gear selection, offering 20 forward and 9 reverse gears. Top speed is 40 km/h in the standard version, with a 30 km/h version also available. In the 40 km/h version, the six gears in the fast range run from 3.88 to 38.41 km/h, in the slow range from 3.12 to 30.94 km/h and in the creep range from 4.71 to 27.41 km/h. From 1987, the Duospeed drive system was available as an option, along with an electronically controlled differential lock and a reversing unit.

Power take-off

The PTO is switchable between 540 and 1,000 rpm. An optional front PTO is available.

Brakes and steering

The braking system consists of hydraulically operated full disc brakes on the rear wheels, usable as individual wheel brakes. A propshaft disc brake acts on the four-wheel drive; when the individual wheel brake is applied, the front wheel brake disengages automatically. The parking brake is mechanically operated as an internal shoe brake. Steering is hydrostatically assisted.

Dimensions and weight

  • Unladen weight: 6,080 kg
  • Fuel tank: 222 litres
  • Fuel consumption at maximum power: 223 g/kWh

Standard tyre sizes are 14.9-26 at the front and 18.4R38 at the rear. The cab is a rubber-mounted, vibration and sound-insulated safety cab with a noise level of 78 dB, air-suspended seat, digital tractor meter, fold-open front and rear windows, roof hatch, three-stage ventilation system, two-stage heating, radio preparation and height-adjustable steering wheel.

Difference from the 611 LS (Typ 282)

The difference between Typ 382 and Typ 282 is a recurring point when sourcing parts and when purchasing. The Typ 282 is the LS series, built from 1977 to 1984, available with either rear-wheel or four-wheel drive and producing 100 to 110 hp from a naturally aspirated engine. The Typ 382 is available exclusively with four-wheel drive, has a turbocharged engine in its second phase, a higher hydraulic pump output and higher permissible axle loads. The gearbox on both types is a ZF T 3345, but the configuration differs between phases.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart