Menu
EUR

Fendt Favorit 611 (Typ 382) parts

Looking for parts for your Fendt Favorit 611 (Typ 382) tractor? In this category, you'll find everything you need for the maintenance and repair of your vehicle.

568 parts found for Fendt Favorit 611 (Typ 382)
Show:
Radiator hose Ø 18 mm, length 1000 mm Fendt
Inner Ø: 18 mm. Length: 1000 mm. More
Inner Ø: 18 mm. Length: 1000 mm.
€43,88 €36,26 €40,37 €33,36
You save 8%
Hose elbow heating Ø 18 mm Fendt
Inner Ø: 18 mm. More
Inner Ø: 18 mm.
€9,14 €7,55
Radiator hose cylinder head and air compressor inner-Ø 22 mm, 1000 mm
Inner Ø: 22 mm. Length: 1000 mm. More
Inner Ø: 22 mm. Length: 1000 mm.
€45,33 €37,46 €41,70 €34,47
You save 8%
Radiator hose thermostat / water pump Ø 24 mm Fendt
€34,91 €28,85 €32,12 €26,54
You save 8%
Radiator hose thermostat Ø 34/38 mm Fendt Favorit 611-615
€46,50 €38,43 €42,78 €35,36
You save 8%
Outlet valve Fendt
€25,73 €21,26
Cylinder head bolt M14 x 158 mm Case IH, Steyr, Fendt
Dimensions: M14 x 158 mm. Supplementary set: With thread at the top. More
Dimensions: M14 x 158 mm. Supplementary set: With thread at the top.
€47,30 €39,09 €43,52 €35,96
You save 8%
Hose lubricating pipe turbocharger Fendt
€48,04 €39,70 €44,20 €36,53
You save 8%
Oil pump line-Ø 30 mm Case IH, Renault, Steyr, Fendt
Dimensions: Pipe Ø 30 mm. More
Dimensions: Pipe Ø 30 mm.
€450,34 €372,18 €414,31 €342,41
You save 8%
Crankshaft seal rear outer-Ø 130 mm, inner-Ø 110 mm, width 13 mm
Outer Ø: 130 mm. Width: 13 mm. Inner Ø: 110 mm. More
Outer Ø: 130 mm. Width: 13 mm. Inner Ø: 110 mm.
€26,36 €21,79
Piston, complete Fendt Farmer 304-312, Favorit 509-615
€82,93 €68,54 €76,30 €63,05
You save 8%
Set of parts feed pump Ø 29/35 mm, height 53 mm engine For 314
Dimensions: Ø 29/35 mm. Height: 53 mm. More
Dimensions: Ø 29/35 mm. Height: 53 mm.
€13,54 €11,19
Ball pin steel M6, wrench size 8, E 10 mm Fendt 7387MI, Xylon 524
A: M6 mm. SW: 8. E: 10 mm. More
A: M6 mm. SW: 8. E: 10 mm.
€5,78 €4,77
Bar three-point parts Fendt
Guide ring Fendt
€19,54 €16,15
Seal kit lift cylinder front power lift Fendt Favorit 600-615, GT 345-380
Angled screw lift arm M27 x 3 mm Fendt
Dimensions: Thread = M27 x 3 mm. More
Dimensions: Thread = M27 x 3 mm.
€80,43 €66,47 €74,00 €61,15
You save 8%
Adjusting nut for lower link strut M27 x 3 Fendt
Dimensions: Thread = M27 x 3 mm. More
Dimensions: Thread = M27 x 3 mm.
€58,94 €48,71 €54,22 €44,81
You save 8%
Pin for lifting strut top 25 x 110 mm Fendt Favorit 600-615
Dimensions: 25 x 110 mm. More
Dimensions: 25 x 110 mm.
€33,70 €27,85 €31,00 €25,62
You save 8%
Gas strut roof window 120 N, 225 mm Fendt Farmer 240 S (Typ 294), GT 395
Newtons: 120. A: 225 mm. B: 130 mm. C: 6 mm. D: 6 mm. To fit: roof hatch. Form: 1. Menke no.: 54809. More
Newtons: 120. A: 225 mm. B: 130 mm. C: 6 mm. D: 6 mm. To fit: roof hat...
€31,20 €25,79
Spring plate fender Fendt
Scharmüller Drawbar frame 311/22/30, 2500 kg, Deutz-Fahr, Fendt
Scharmüller
To fit as: Deutz-Fahr D-06 (10006-12006): 10006, 12006; Fendt Favorit 600 LS/LSA/S/SL: 600, 610, 611, 612, 614, 615, 622, 626. More
To fit as: Deutz-Fahr D-06 (10006-12006): 10006, 12006; Fendt Favorit ...
€1.458,18 €1.205,11 €1.341,53 €1.108,70
You save 8%
Cut-out switch starter motor solenoid switch 42 V, 0,5 A
Version: Solenoid switch, 42 V / 0.5 A, With plug connection. More
Version: Solenoid switch, 42 V / 0.5 A, With plug connection.
€35,83 €29,61
Temperature sender 6 - 24 V, M14 x 1,5, wrench size 19 mm, black
Version: Connection type: 1 x 6.3 mm, Colour: black, Thread: M14 x 1.5, AF: 19.0 mm. Colour: Black. Thread: M14 x 1.5. AF: 19 mm. Connection type: 1 x... More
Version: Connection type: 1 x 6.3 mm, Colour: black, Thread: M14 x 1.5...
€53,03 €43,83 €48,79 €40,32
You save 8%
Tank temperature gauge 12 volt
Version: 12 V | To fit Fendt. More
Version: 12 V | To fit Fendt.
€1.093,42 €903,65
Push button switch fan 12 / 24 V, button yellow, Ø 30 mm
Version: 12/24 V, Yellow button, with lock, Ø 30 mm, 4 blade terminals 6.3 x 0.8 (31- S1- S- +), Dustproof and splashproof, With glass socket bulb 12... More
Version: 12/24 V, Yellow button, with lock, Ø 30 mm, 4 blade terminal...
€47,74 €39,45 €43,92 €36,30
You save 8%
SACEX Beacon H1 Saturnello orange 12 V, Ø 128 mm, 204 mm, push-on pin
SACEX
Nominal voltage: 12 V. Bulbs included: Yes. Light function: Rotating. Diameter: 128 mm. Total height: 204 mm. Connection: Socket pipe. Protection clas... More
Nominal voltage: 12 V. Bulbs included: Yes. Light function: Rotating. ...
€42,68 €35,27 €39,27 €32,45
You save 8%
HELLA Work lamp flood beam H3 55 / 70 W, 153 x 93 x 92 mm, 12 / 24 V
HELLA
Nominal voltage: 12 / 24 V. Form: Rectangular. Dimensions W x H x D: 153 x 93 x 92 mm. Light function: Close-range illumination. Bulb: H3. Material: H... More
Nominal voltage: 12 / 24 V. Form: Rectangular. Dimensions W x H x D: 1...
€47,85 €39,55 €46,08 €38,08
You save 4%
Work lamp flood beam H3, 55 W, 12 V, 150 x 98 x 89 mm
Bulb: H3. Form: Rectangular. Material: Housing: plastic, lens: glass. Dimensions W x H x D: 150 x 98 x 89 mm. Installation location: Left/right. Nomin... More
Bulb: H3. Form: Rectangular. Material: Housing: plastic, lens: glass. ...
€55,15 €45,58 €50,74 €41,93
You save 8%
HELLA Headlight insert left / right H4, 12 / 24 V, built-in
HELLA
Bulb: H4. To fit: 4551GA 004109021. Installation location: Left/right. Nominal voltage: 12 / 24 V. Test mark: E1 34463, ECE. Light function: With dipp... More
Bulb: H4. To fit: 4551GA 004109021. Installation location: Left/right....
€69,32 €57,29 €66,75 €55,17
You save 4%
Pipe RKLE
€102,02 €84,31 €93,86 €77,57
You save 8%
Light housing
€23,04 €19,04
Showing 289 - 336 of 568

Fendt Favorit 611 (Typ 382) specifications

The Fendt Favorit 611 LSA carries the internal type designation T 382 and was built from 1985 to 1993 exclusively with four-wheel drive. A total of 1,433 units were produced. The 611 LSA is the successor to the 611 LS (Typ 282) and at the same time the conclusion of a development line that began in 1972 with the Favorit 611 S. The LS version with rear-wheel drive falls under Typ FWA 282.

Production ran in two clearly distinct phases. In the first phase (chassis number T 382.250, 1985 to 1987, 228 units), the engine has no turbocharger and produces 115 hp. In the second phase (chassis number T 382.211, 1988 to 1993, 1,205 units), a turbocharger was added and the combustion process optimised, raising output to 125 hp while fuel consumption fell. The 611 LSA was succeeded in the line-up by the Favorit 500C series.

Hydraulics and lift system

The hydraulic tandem pump delivers 69 litres per minute (44 plus 25 litres) at 180 bar. The rear three-point hitch achieves a maximum lift capacity of 7,410 kg. An optional front linkage with category II three-point hitch is available with a maximum lift capacity of 3,940 kg. The permissible front axle load is 3,050 kg and the rear axle load 5,400 kg. The permissible gross weight is 8,500 kg.

Engine

The second phase (1988 to 1993) uses an MWM TD 226-B 6, a water-cooled six-cylinder four-stroke inline turbodiesel engine with direct injection into the combustion bowl of the piston. The engine is fitted with individually mounted cylinder heads, piston crown cooling, an oil cooler, Rotocap valves, a viscous fan, an inline injection pump, a multi-hole injector, a dry air filter with pre-cleaner, pressure circulation lubrication, an exhaust turbocharger with pulse charging and thermostatically controlled dual-circuit cooling. Displacement is 6,240 cc. Maximum torque is 497 Nm at 1,500 rpm. Injection pressure is 180 to 185 bar, raised to 650 bar from 1987.

The first phase (1985 to 1987) has a naturally aspirated MWM D 226.6.2 without turbocharger producing 115 hp, with a maximum torque of 412 Nm at 1,500 rpm.

Transmission and travel speed

The 611 LSA has a helical-cut ZF fully synchronised fine-step gearbox type T 3345 with side-mounted gear selection, offering 20 forward and 9 reverse gears. Top speed is 40 km/h in the standard version, with a 30 km/h version also available. In the 40 km/h version, the six gears in the fast range run from 3.88 to 38.41 km/h, in the slow range from 3.12 to 30.94 km/h and in the creep range from 4.71 to 27.41 km/h. From 1987, the Duospeed drive system was available as an option, along with an electronically controlled differential lock and a reversing unit.

Power take-off

The PTO is switchable between 540 and 1,000 rpm. An optional front PTO is available.

Brakes and steering

The braking system consists of hydraulically operated full disc brakes on the rear wheels, usable as individual wheel brakes. A propshaft disc brake acts on the four-wheel drive; when the individual wheel brake is applied, the front wheel brake disengages automatically. The parking brake is mechanically operated as an internal shoe brake. Steering is hydrostatically assisted.

Dimensions and weight

  • Unladen weight: 6,080 kg
  • Fuel tank: 222 litres
  • Fuel consumption at maximum power: 223 g/kWh

Standard tyre sizes are 14.9-26 at the front and 18.4R38 at the rear. The cab is a rubber-mounted, vibration and sound-insulated safety cab with a noise level of 78 dB, air-suspended seat, digital tractor meter, fold-open front and rear windows, roof hatch, three-stage ventilation system, two-stage heating, radio preparation and height-adjustable steering wheel.

Difference from the 611 LS (Typ 282)

The difference between Typ 382 and Typ 282 is a recurring point when sourcing parts and when purchasing. The Typ 282 is the LS series, built from 1977 to 1984, available with either rear-wheel or four-wheel drive and producing 100 to 110 hp from a naturally aspirated engine. The Typ 382 is available exclusively with four-wheel drive, has a turbocharged engine in its second phase, a higher hydraulic pump output and higher permissible axle loads. The gearbox on both types is a ZF T 3345, but the configuration differs between phases.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart