Menu
EUR

Fiat 55-90 tractor parts & technical data

Lighting, trailer couplings, brake parts and transmission parts: for the Fiat 55-90 from the 90 series, more than 200 parts are listed on a single model page.

215 parts found for Fiat 55-90
Show:
Optibelt V-belt engine cooling Fiat, Renault
Seal oil pump Ford, Fiat
GRANIT Clamp Ø 46 mm Fiat series 46-93
Bosch/Rexroth Hydraulic pump 11 cm³/rpm., taper 1:8, Ø 17,46 mm, clockwise
Bosch/Rexroth
Output volume: 11 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation: Right. Bosch no.: 0510525046. More
Output volume: 11 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction ...
€440,02 €363,65 €418,00 €345,45
You save 5%
Cobo Multifunction switch horn, lighting, indicators
Cobo
Version: For horn, lights, indicators. More
Version: For horn, lights, indicators.
€135,54 €112,02 €128,75 €106,41
You save 5%
Cobo Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
Cobo
Version: Without fuses, blade terminal connection at the bottom, transparent cover, L 174 x W 50 x H 34.5 mm. To fit: Blade terminal. Number of pins: ... More
Version: Without fuses, blade terminal connection at the bottom, trans...
€90,71 €74,97 €82,00 €67,77
You save 10%
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
To fit as: Case IH 238, 248, 258, 268, 278, 288, 323, 354, 374, 384, 444, 474, 475, 484, 584, 674, 684, 784, 884 385, 485, 485XL, 585, 585XL, 685, 685... More
To fit as: Case IH 238, 248, 258, 268, 278, 288, 323, 354, 374, 384, 4...
€48,98 €40,48 €44,30 €36,61
You save 10%
SACHS Thrust bearing 50 x 80 mm, 89 x 22 mm
SACHS
Dimensions (mm): 50 x 80 89 x 22 More
Dimensions (mm): 50 x 80 89 x 22
€84,70 €70,00 €72,85 €60,21
You save 14%
LUK Clutch kit double plate connection without release bearing, 30,50 kg
LUK
Contents: Pressure plate 458228007714, clutch plate 458328018616 | Supplementary set: Without release bearing | Connection: For vehicles with double-d... More
Contents: Pressure plate 458228007714, clutch plate 458328018616 | Sup...
€761,39 €629,25 €723,30 €597,77
You save 5%
LUK Thrust bearing PTO shaft 70 x 110 x 20 mm
LUK
Dimensions (mm): 70 x 110 x 20 More
Dimensions (mm): 70 x 110 x 20
€120,88 €99,90 €114,80 €94,88
You save 5%
MAHLE Alternator 14 V, 45 A, pulley Ø 90 mm, flange 70 mm
MAHLE
Nominal voltage (V): 14 | Mounting L / d / R (mm): 70,0 / 12,2 / 85,0 | Belt width (mm) / type: 9,7 | Direction of rotation: ↻ | Nominal values (V /... More
Nominal voltage (V): 14 | Mounting L / d / R (mm): 70,0 / 12,2 / 85,0 ...
€266,89 €220,57 €166,75 €137,81
You save 38%
Seal brake piston inner Ø 210,8 x 3,4 mm
Dimensions: Ø 210.8 x 3.4 mm. More
Dimensions: Ø 210.8 x 3.4 mm.
€23,65 €19,55
Radiator cap grommet-Ø 57 mm, height 25 mm, for expansion tank
Version: For expansion tank. Neck Ø: 57 mm. Height: 25 mm. More
Version: For expansion tank. Neck Ø: 57 mm. Height: 25 mm.
€15,30 €12,64
Radiator 665 x 555 mm, Ø 45 / 38 mm Fiat 780-980, 55-90 - 110-90
To fit as: Fiat Series 80: 780, 880, 980; Series 90: 55-90–110-90; Series TK: 85-55, 95-55, 100-55 More
To fit as: Fiat Series 80: 780, 880, 980; Series 90: 55-90–110-90; S...
€621,41 €513,56 €590,30 €487,85
You save 5%
GRANIT Connecting rod bearing standard, Ø 63,73 mm
GRANIT
Dimensions: Ø 63.73 mm. More
Dimensions: Ø 63.73 mm.
€11,70 €9,67
Tube exhaust curved vertical enamelled 700 mm Fiat series 46-94
Version: Length: 700 mm, Inner Ø: 49 mm. Inner Ø: 49 mm. Length: 700 mm. More
Version: Length: 700 mm, Inner Ø: 49 mm. Inner Ø: 49 mm. Length: 700...
€47,88 €39,57 €45,45 €37,56
You save 5%
Showing 169 - 192 of 215

Fiat 55-90 parts for clutch, hydraulics and engine

A Fiat 55-90 has often done plenty of hours by now, and the familiar jobs come round: a slipping clutch, a linkage that creeps down, an alternator that stops charging. This page lists more than 200 replacement parts that fit the type, from GRANIT, Cobo, LUK, Walterscheid, Bosch/Rexroth and others.

Clutch work

For the clutch there are clutch kits and thrust bearings for the driving clutch, plus bushes and spacers. If you split the tractor to reach the clutch, always replace the thrust bearing at the same time. The bearing costs little compared with the labour, and one that starts to whine shortly after the repair means splitting the tractor all over again. While it is apart, check the rear crankshaft seal for leaks.

Hydraulic pump and lift shaft

Hydraulic pumps and seals are available, including lift shaft sealing rings. A linkage that slowly drops with a heavy implement attached often points to internal leakage, while a leaking lift shaft seal shows as oil running down the outside of the housing.

When changing the pump, renew the filter and check the oil as well, so debris from the old pump does not go straight into the new one. Mind the direction of rotation when fitting it.

Engine, cooling and electrics

Around the engine you will find gaskets, sealing rings, O-rings and thermostats. A sticking thermostat leaves the engine running too cold or too hot. Alternators, rocker switches for the dashboard and lamp glass for the lights are listed too, as is a curved, enamelled exhaust tube.

An alternator tip: disconnect the battery before you undo the charging cable. A spanner touching the block while the cable is live throws sparks and can damage the wiring or the new alternator. After fitting, use a multimeter to check that the charging voltage rises at idle and with the revs up.

Choosing the right part

The type plate tells you whether the tractor really is a 55-90. After that, the reference number on the old part is the quickest route. For a clutch, measure the diameter of the old disc and compare it with the details on this page. For lamp glass, check which side the glass sits on.

The 55-90 sits in the Fiat 90 series, and the other tractors in that line each have a page of their own:

All other models of the brand can be reached from Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart