Menu
EUR

Fiat 55-90 tractor parts & technical data

Lighting, trailer couplings, brake parts and transmission parts: for the Fiat 55-90 from the 90 series, more than 200 parts are listed on a single model page.

215 parts found for Fiat 55-90
Show:
LUK Pilot bearing 17 x 47 x 14 mm
5%
LUK
Pilot bearing 17 x 47 x 14 mm
Dimensions: 17 x 47 x 14 mm. Menke no.: 167836.
€32,31 €26,70 €30,65 €25,33
 
Heating element Ford, Fiat, New Holland
5%
Heating element Ford, Fiat, New Holland
€309,46 €255,75 €293,95 €242,93
 
V-belt Fiat, Renault
V-belt Fiat, Renault
€19,00 €15,70
 
Tank cap Fiat series 46-93
Tank cap Fiat series 46-93
€7,55 €6,24
 
Thermostat gasket Fiat 400-1580
Thermostat gasket Fiat 400-1580
€2,74 €2,26
 
Crankshaft, 3-cylinder forged Fiat L 60, New Holland TN55-TN75
5%
Crankshaft, 3-cylinder forged Fiat L 60, New Holland TN55-TN75
Notes: Please follow the instructions in the installation guide. Please complete...
€1.059,71 €875,79 €1.006,70 €831,98
 
GRANIT Nut cylinder head Ford, Fiat, New Holland
GRANIT
Nut cylinder head Ford, Fiat, New Holland
€17,70 €14,63
 
GRANIT Valve cover gasket 3-cylinder Fiat
GRANIT
Valve cover gasket 3-cylinder Fiat
€12,30 €10,17
 
GRANIT Crankshaft seal Ø 42 x 65 x 12 mm Case IH, Fiat, Steyr, New Holland
GRANIT
Crankshaft seal Ø 42 x 65 x 12 mm Case IH, Fiat, Steyr, New Holland
Outer Ø: 65 mm. Width: 12 mm. Inner Ø: 42 mm.
€5,00 €4,13
 
GRANIT Fuel tank Fiat series 88, 90, 93, 94
5%
GRANIT
Fuel tank Fiat series 88, 90, 93, 94
€642,51 €531,00 €610,35 €504,42
 
Seal water pump Fiat, Ford
Seal water pump Fiat, Ford
€3,81 €3,15
 
Bosch/Rexroth Hydraulic pump 19 cm³/rpm., taper 1:8, Ø 17,46 mm, anticlockwise
5%
Bosch/Rexroth
Hydraulic pump 19 cm³/rpm., taper 1:8, Ø 17,46 mm, anticlockwise
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation...
€446,89 €369,33 €424,50 €350,83
 
Bosch/Rexroth Hydraulic pump clockwise 19 cm³/rpm., taper 1:8, Ø 17,46 mm
5%
Bosch/Rexroth
Hydraulic pump clockwise 19 cm³/rpm., taper 1:8, Ø 17,46 mm
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation...
€417,97 €345,43 €397,00 €328,10
 
Spacer 25 x 40 x 25 mm Fiat series 66 - 94, L 60 - L 95
Spacer 25 x 40 x 25 mm Fiat series 66 - 94, L 60 - L 95
Dimensions: 25 x 40 x 25 mm.
€10,00 €8,26
 
GRANIT Ring 23 x 40 x 25 mm Fiat L 60-95, New Holland TN55-TN95
GRANIT
Ring 23 x 40 x 25 mm Fiat L 60-95, New Holland TN55-TN95
Dimensions: 23 x 40 x 25 mm.
€9,95 €8,22
 
GRANIT Spacer 25 x 42 x 24 mm Case IH, Fiat, New Holland
GRANIT
Spacer 25 x 42 x 24 mm Case IH, Fiat, New Holland
Dimensions: 25 x 42 x 24 mm.
€26,00 €21,49
 
GRANIT Sealing ring lift arm shaft 23 x 37 x 11 mm Ford, Case IH, Fiat, New Holland
GRANIT
Sealing ring lift arm shaft 23 x 37 x 11 mm Ford, Case IH, Fiat, New Holland
Dimensions: 23 x 37 x 11 mm.
€24,15 €19,96
 
Bush left lift arm shaft 62,8 x 68,2 x 40 mm Ford, Fiat, New Holland
Bush left lift arm shaft 62,8 x 68,2 x 40 mm Ford, Fiat, New Holland
Dimensions: 62.8 x 68.2 x 40 mm.
€22,00 €18,18
 
Frame hood Fiat series 80, 90, TK
5%
Frame hood Fiat series 80, 90, TK
€245,85 €203,18 €233,55 €193,02
 
AL-KO Chock UK 800 folding, 2.500 kg, tires radius 830 mm
AL-KO
Chock UK 800 folding, 2.500 kg, tires radius 830 mm
Static tyre radius up to max.: 830 mm.
€109,20 €90,25
 
Showing 97 - 120 of 215

Fiat 55-90 parts for clutch, hydraulics and engine

A Fiat 55-90 has often done plenty of hours by now, and the familiar jobs come round: a slipping clutch, a linkage that creeps down, an alternator that stops charging. This page lists more than 200 replacement parts that fit the type, from GRANIT, Cobo, LUK, Walterscheid, Bosch/Rexroth and others.

Clutch work

For the clutch there are clutch kits and thrust bearings for the driving clutch, plus bushes and spacers. If you split the tractor to reach the clutch, always replace the thrust bearing at the same time. The bearing costs little compared with the labour, and one that starts to whine shortly after the repair means splitting the tractor all over again. While it is apart, check the rear crankshaft seal for leaks.

Hydraulic pump and lift shaft

Hydraulic pumps and seals are available, including lift shaft sealing rings. A linkage that slowly drops with a heavy implement attached often points to internal leakage, while a leaking lift shaft seal shows as oil running down the outside of the housing.

When changing the pump, renew the filter and check the oil as well, so debris from the old pump does not go straight into the new one. Mind the direction of rotation when fitting it.

Engine, cooling and electrics

Around the engine you will find gaskets, sealing rings, O-rings and thermostats. A sticking thermostat leaves the engine running too cold or too hot. Alternators, rocker switches for the dashboard and lamp glass for the lights are listed too, as is a curved, enamelled exhaust tube.

An alternator tip: disconnect the battery before you undo the charging cable. A spanner touching the block while the cable is live throws sparks and can damage the wiring or the new alternator. After fitting, use a multimeter to check that the charging voltage rises at idle and with the revs up.

Choosing the right part

The type plate tells you whether the tractor really is a 55-90. After that, the reference number on the old part is the quickest route. For a clutch, measure the diameter of the old disc and compare it with the details on this page. For lamp glass, check which side the glass sits on.

The 55-90 sits in the Fiat 90 series, and the other tractors in that line each have a page of their own:

All other models of the brand can be reached from Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart