Menu
EUR

Fiat 60-88 tractor parts & technical data

From lighting and electrics to brake and transmission parts, the Fiat 60-88 from the 88 series is covered here with more than 200 matching items.

225 parts found for Fiat 60-88
Show:
Oil pump Fiat 350-855
GRANIT Bearing for lower link shaft Ø 25 mm Ford, Case IH, Fiat, New Holland
€48,32 €39,93 €45,90 €37,93
You save 5%
GRANIT Wiper motor 12 V Fiat Series 88
GRANIT
Volts: 12. More
Volts: 12.
€286,24 €236,56 €271,90 €224,71
You save 5%
Holder right Fiat Series 66-94
€58,21 €48,11 €52,65 €43,51
You save 10%
GRANIT Brake light switch oil pressure make contact, neutral position off, M10 x 1
GRANIT
Version: Thread M10 x 1, normally off, make contact, Blade terminal. More
Version: Thread M10 x 1, normally off, make contact, Blade terminal.
€37,90 €31,32 €36,00 €29,75
You save 5%
Cobo Tank sender main tank, stroke 389 mm
Cobo
Version: Main tank, stroke: 389 mm. More
Version: Main tank, stroke: 389 mm.
€80,45 €66,49 €72,75 €60,12
You save 10%
Cobo Indicator/position light 169 x 62 x 90 mm, P21W, R5W left
Cobo
Bulb: 12V21WK / P21W, 12V5WK / R5W. Colour: Yellow, white. Width: 169 mm. Form: Rectangular. Height: 62 mm. Dimensions W x H x D: 169 x 62 x 90 mm. De... More
Bulb: 12V21WK / P21W, 12V5WK / R5W. Colour: Yellow, white. Width: 169 ...
€50,33 €41,60 €45,50 €37,60
You save 10%
GRANIT Relays make contact 12 V, 30 A, without bracket, 5-pin, 6,3 mm
GRANIT
Version: 12 V / 30 A, Without bracket, 5-pin, blade terminal 6.3 mm. More
Version: 12 V / 30 A, Without bracket, 5-pin, blade terminal 6.3 mm.
€29,20 €24,13
GRANIT Clutch cable driving clutch 480 mm, sleeve length 255 mm, M6 Fiat
GRANIT
Sleeve length (mm): 255 | Cable length (mm): 480 | Thread: M6 More
Sleeve length (mm): 255 | Cable length (mm): 480 | Thread: M6
€35,20 €29,09
LUK Clutch plate 280UKF 22 x 25 mm, 10 splines
LUK
Dimensions (mm): 22 x 25 10 grooves More
Dimensions (mm): 22 x 25 10 grooves
€133,57 €110,39 €126,85 €104,83
You save 5%
GRANIT Alternator 12 V / 45 A, pulley Ø 90 mm, W-connection
GRANIT
Nominal voltage (V): 12 | Charging current (A): 45 | Pulley spacing (mm): 58,0 | Additional information: With W connection | Belt tension hole Ø / R ... More
Nominal voltage (V): 12 | Charging current (A): 45 | Pulley spacing (m...
€194,88 €161,06 €185,10 €152,98
You save 5%
Eaton Gear wheel transmission 1,72 kg Case IH, Fiat, Ford, New Holland
Eaton
Reference no.: 5125005 More
Reference no.: 5125005
€181,14 €149,70 €172,00 €142,15
You save 5%
Eaton As transmission Case IH, Fiat, Ford, New Holland, 3,10 kg
Eaton
Reference no.: 47132984 More
Reference no.: 47132984
€201,80 €166,78
Eaton Link wheel Case IH, Fiat, Ford, New Holland
Eaton
Reference no.: 5125007 More
Reference no.: 5125007
€287,74 €237,80 €273,35 €225,91
You save 5%
LUK Pilot bearing 17 x 47 x 14 mm
LUK
Dimensions: 17 x 47 x 14 mm. Menke no.: 167836. More
Dimensions: 17 x 47 x 14 mm. Menke no.: 167836.
€32,31 €26,70 €30,65 €25,33
You save 5%
GRANIT O-ring 25,07 x 2,62 mm Fiat
GRANIT
Dimensions: 25.07 x 2.62 mm. More
Dimensions: 25.07 x 2.62 mm.
€1,00 €0,83
Crankshaft, 3-cylinder forged Fiat L 60, New Holland TN55-TN75
Notes: Please follow the instructions in the installation guide. Please complete the test instruction report contained therein, and return it to garan... More
Notes: Please follow the instructions in the installation guide. Pleas...
€1.059,71 €875,79 €1.006,70 €831,98
You save 5%
Showing 73 - 96 of 225

Fiat 60-88 parts for a tractor that is still worth keeping

The 60-88 from Fiat's 88 series is still a common sight on mixed farms and in collectors' sheds. For this model we carry more than 200 replacement parts from GRANIT, Cobo, LUK, Bosch/Rexroth and Eaton.

Hydraulics and linkage

For the hydraulics there are hydraulic pumps and seals, such as the lift shaft seal. A practical point with the pump: check the rotation and the shaft type of the pump you take off. A pump with the wrong rotation or a different taper may bolt to the flange but will not deliver oil. Prime the new pump with clean oil through the port before starting, so it does not run dry.

Cooling and engine

On the engine side you will find thermostats with matching O-rings, gaskets such as the rear engine cover gasket, and an exhaust tube. Always renew the O-ring with a new thermostat. An old ring that has sat in coolant for years is usually distorted and tends to leak the first time the engine warms up.

Clutch, steering and electrics

For the clutch there are clutch kits and thrust bearings, including a release bearing for the main clutch. On the steering side there are ball joints.

The electrics cover alternators, rocker switches, indicator and position lights and lamp glasses. If only the lens of an indicator is broken, just the glass needs replacing. There are also holders and an air suspended tractor seat.

An exhaust tube on an older tractor often rusts from the inside, from condensation that never burns off on short runs. If you see rust holes along the seams, replace the tube before it snaps and secure it with new clamps. Ball joints can be replaced one at a time, but the toe-in has to be reset afterwards. Measure the length of the old track rod before you undo it and you will be close to the right setting straight after fitting.

The Fiat 60-88 and its stablemates

The 88 series includes several models with different numbers, so check the type plate to confirm your tractor really is a 60-88 and note the chassis number. If the old part is still in the workshop, look for a stamped number. On hydraulic pumps and alternators it often sits on a tag on the housing.

From the same series, the Fiat 70-88 has its own page. The Fiat 65-88 belongs to this range too. Every other Fiat tractor is listed by model under Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart