Menu
EUR

Fiat 60-88 tractor parts & technical data

From lighting and electrics to brake and transmission parts, the Fiat 60-88 from the 88 series is covered here with more than 200 matching items.

225 parts found for Fiat 60-88
Show:
Oil pump Fiat 350-855
Oil pump Fiat 350-855
€100,40 €82,98
 
GRANIT Bearing for lower link shaft Ø 25 mm Ford, Case IH, Fiat, New Holland
5%
GRANIT
Bearing for lower link shaft Ø 25 mm Ford, Case IH, Fiat, New Holland
Dimensions: Ø: 25 mm.
€48,32 €39,93 €45,90 €37,93
 
GRANIT Wiper motor 12 V Fiat Series 88
5%
GRANIT
Wiper motor 12 V Fiat Series 88
Volts: 12.
€286,24 €236,56 €271,90 €224,71
 
Holder right Fiat Series 66-94
10%
Holder right Fiat Series 66-94
€58,21 €48,11 €52,65 €43,51
 
GRANIT Brake light switch oil pressure make contact, neutral position off, M10 x 1
5%
GRANIT
Brake light switch oil pressure make contact, neutral position off, M10 x 1
Version: Thread M10 x 1, normally off, make contact, Blade terminal.
€37,90 €31,32 €36,00 €29,75
 
Cobo Tank sender main tank, stroke 389 mm
10%
Cobo
Tank sender main tank, stroke 389 mm
Version: Main tank, stroke: 389 mm.
€80,45 €66,49 €72,75 €60,12
 
Cobo Indicator/position light 169 x 62 x 90 mm, P21W, R5W left
10%
Cobo
Indicator/position light 169 x 62 x 90 mm, P21W, R5W left
Bulb: 12V21WK / P21W, 12V5WK / R5W. Colour: Yellow, white. Width: 169 mm. Form: ...
€50,33 €41,60 €45,50 €37,60
 
GRANIT Relays make contact 12 V, 30 A, without bracket, 5-pin, 6,3 mm
GRANIT
Relays make contact 12 V, 30 A, without bracket, 5-pin, 6,3 mm
Version: 12 V / 30 A, Without bracket, 5-pin, blade terminal 6.3 mm.
€29,20 €24,13
 
GRANIT Clutch cable driving clutch 480 mm, sleeve length 255 mm, M6 Fiat
GRANIT
Clutch cable driving clutch 480 mm, sleeve length 255 mm, M6 Fiat
Sleeve length (mm): 255 | Cable length (mm): 480 | Thread: M6
€35,20 €29,09
 
LUK Clutch plate 280UKF 22 x 25 mm, 10 splines
5%
LUK
Clutch plate 280UKF 22 x 25 mm, 10 splines
Dimensions (mm): 22 x 25 10 grooves
€133,57 €110,39 €126,85 €104,83
 
GRANIT Alternator 12 V / 45 A, pulley Ø 90 mm, W-connection
5%
GRANIT
Alternator 12 V / 45 A, pulley Ø 90 mm, W-connection
Nominal voltage (V): 12 | Charging current (A): 45 | Pulley spacing (mm): 58,0 |...
€194,88 €161,06 €185,10 €152,98
 
Eaton Gear wheel transmission 1,72 kg Case IH, Fiat, Ford, New Holland
5%
Eaton
Gear wheel transmission 1,72 kg Case IH, Fiat, Ford, New Holland
Reference no.: 5125005
€181,14 €149,70 €172,00 €142,15
 
Eaton As transmission Case IH, Fiat, Ford, New Holland, 3,10 kg
Eaton
As transmission Case IH, Fiat, Ford, New Holland, 3,10 kg
Reference no.: 47132984
€201,80 €166,78
 
Eaton Link wheel Case IH, Fiat, Ford, New Holland
5%
Eaton
Link wheel Case IH, Fiat, Ford, New Holland
Reference no.: 5125007
€287,74 €237,80 €273,35 €225,91
 
GRANIT Thrust washer drive shaft Fiat series 80-94
GRANIT
Thrust washer drive shaft Fiat series 80-94
€36,35 €30,04
 
LUK Pilot bearing 17 x 47 x 14 mm
5%
LUK
Pilot bearing 17 x 47 x 14 mm
Dimensions: 17 x 47 x 14 mm. Menke no.: 167836.
€32,31 €26,70 €30,65 €25,33
 
Tank cap Fiat series 46-93
Tank cap Fiat series 46-93
€7,55 €6,24
 
GRANIT O-ring 25,07 x 2,62 mm Fiat
GRANIT
O-ring 25,07 x 2,62 mm Fiat
Dimensions: 25.07 x 2.62 mm.
€1,00 €0,83
 
Crankshaft, 3-cylinder forged Fiat L 60, New Holland TN55-TN75
5%
Crankshaft, 3-cylinder forged Fiat L 60, New Holland TN55-TN75
Notes: Please follow the instructions in the installation guide. Please complete...
€1.059,71 €875,79 €1.006,70 €831,98
 
Showing 73 - 96 of 225

Fiat 60-88 parts for a tractor that is still worth keeping

The 60-88 from Fiat's 88 series is still a common sight on mixed farms and in collectors' sheds. For this model we carry more than 200 replacement parts from GRANIT, Cobo, LUK, Bosch/Rexroth and Eaton.

Hydraulics and linkage

For the hydraulics there are hydraulic pumps and seals, such as the lift shaft seal. A practical point with the pump: check the rotation and the shaft type of the pump you take off. A pump with the wrong rotation or a different taper may bolt to the flange but will not deliver oil. Prime the new pump with clean oil through the port before starting, so it does not run dry.

Cooling and engine

On the engine side you will find thermostats with matching O-rings, gaskets such as the rear engine cover gasket, and an exhaust tube. Always renew the O-ring with a new thermostat. An old ring that has sat in coolant for years is usually distorted and tends to leak the first time the engine warms up.

Clutch, steering and electrics

For the clutch there are clutch kits and thrust bearings, including a release bearing for the main clutch. On the steering side there are ball joints.

The electrics cover alternators, rocker switches, indicator and position lights and lamp glasses. If only the lens of an indicator is broken, just the glass needs replacing. There are also holders and an air suspended tractor seat.

An exhaust tube on an older tractor often rusts from the inside, from condensation that never burns off on short runs. If you see rust holes along the seams, replace the tube before it snaps and secure it with new clamps. Ball joints can be replaced one at a time, but the toe-in has to be reset afterwards. Measure the length of the old track rod before you undo it and you will be close to the right setting straight after fitting.

The Fiat 60-88 and its stablemates

The 88 series includes several models with different numbers, so check the type plate to confirm your tractor really is a 60-88 and note the chassis number. If the old part is still in the workshop, look for a stamped number. On hydraulic pumps and alternators it often sits on a tag on the housing.

From the same series, the Fiat 70-88 has its own page. The Fiat 65-88 belongs to this range too. Every other Fiat tractor is listed by model under Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart