Menu
EUR

Fiat 60-90 tractor parts & technical data

Our range holds more than 200 parts that fit the Fiat 60-90, among them lighting, trailer couplings, and brake and transmission parts.

231 parts found for Fiat 60-90
Show:
LUK Thrust bearing 50 x 90 x 21,6 mm
5%
LUK
Thrust bearing 50 x 90 x 21,6 mm
Dimensions (mm): 50 x 90 x 21.6
€85,00 €70,25 €80,75 €66,74
 
GRANIT Clutch plate 280 22 x 25, 10 splines
5%
GRANIT
Clutch plate 280 22 x 25, 10 splines
Additional information: Made in Germany | Dimensions (mm): 22 x 25, 10 grooves
€105,06 €86,83 €99,80 €82,48
 
GRANIT Clutch kit 2 mm raised, Ø 280 mm Fiat 500 - 780
5%
GRANIT
Clutch kit 2 mm raised, Ø 280 mm Fiat 500 - 780
Contents: Double clutch, clutch plate and 2x release bearing | Version: Clutch i...
€527,06 €435,59 €500,70 €413,80
 
FEBI Fuel filter WK842
57%
FEBI
Fuel filter WK842
€19,60 €16,20 €8,47 €7,00
 
MAHLE Gear reduction starter 12 V, 2,6 kW, 9 teeth, Ø 110 mm, clockwise
38%
MAHLE
Gear reduction starter 12 V, 2,6 kW, 9 teeth, Ø 110 mm, clockwise
€522,12 €431,50 €326,30 €269,67
 
MAHLE Gear reduction starter 12 V, 4,2 kW, 9 teeth, Ø 110 mm, clockwise
38%
MAHLE
Gear reduction starter 12 V, 4,2 kW, 9 teeth, Ø 110 mm, clockwise
€613,17 €506,75 €383,20 €316,69
 
GRANIT Brake pad pad on both sides, thickness 4,3 mm
GRANIT
Brake pad pad on both sides, thickness 4,3 mm
€31,20 €25,79
 
GRANIT Brake pad lining on one side, thickness 3,3 mm
GRANIT
Brake pad lining on one side, thickness 3,3 mm
€38,45 €31,78
 
Thrust washer Ø 325 mm Case IH, Fiat, New Holland
5%
Thrust washer Ø 325 mm Case IH, Fiat, New Holland
€101,58 €83,95 €96,50 €79,75
 
GRANIT Spring clutch Fiat, Ford, New Holland
GRANIT
Spring clutch Fiat, Ford, New Holland
€1,61 €1,33
 
Optibelt V-belt engine cooling Fiat, Renault
Optibelt
V-belt engine cooling Fiat, Renault
€31,00 €25,62
 
Collet set Fiat, New Holland
Collet set Fiat, New Holland
€2,04 €1,69
 
GRANIT O-ring thermostat Ford, Case IH, Fiat, Steyr
GRANIT
O-ring thermostat Ford, Case IH, Fiat, Steyr
€4,31 €3,56
 
Seal oil pump Ford, Fiat
Seal oil pump Ford, Fiat
€6,50 €5,37
 
GRANIT Clamp Ø 46 mm Fiat series 46-93
GRANIT
Clamp Ø 46 mm Fiat series 46-93
€16,25 €13,43
 
Lever with bolt and lock steering valve Fiat, Ford, New Holland
5%
Lever with bolt and lock steering valve Fiat, Ford, New Holland
€85,28 €70,48 €81,00 €66,94
 
Bosch/Rexroth Hydraulic pump 11 cm³/rpm., taper 1:8, Ø 17,46 mm, clockwise
5%
Bosch/Rexroth
Hydraulic pump 11 cm³/rpm., taper 1:8, Ø 17,46 mm, clockwise
Output volume: 11 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation...
€440,02 €363,65 €418,00 €345,45
 
Cobo Multifunction switch horn, lighting, indicators
5%
Cobo
Multifunction switch horn, lighting, indicators
Version: For horn, lights, indicators.
€135,54 €112,02 €128,75 €106,41
 
Cobo Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
10%
Cobo
Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
Version: Without fuses, blade terminal connection at the bottom, transparent cov...
€90,71 €74,97 €82,00 €67,77
 
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
10%
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
To fit as: Case IH 238, 248, 258, 268, 278, 288, 323, 354, 374, 384, 444, 474, 4...
€48,98 €40,48 €44,30 €36,61
 
Showing 169 - 192 of 231

Fiat 60-90 parts

The Fiat 60-90 is a tractor you can still keep running with ordinary tools in the farm workshop. This page holds more than 200 new replacement parts for it, from GRANIT, Cobo, LUK, Walterscheid and Bosch/Rexroth.

Hydraulic pump and lift shaft

When the linkage lifts slowly or drops under load, the hydraulic pump or leaking seals are the usual suspects. A hydraulic pump and lift shaft sealing rings are listed here. Before fitting a new pump, fill it with clean oil and turn it over by hand a few times so it does not run dry on the first start. Check the drive taper and key as well, since there must be no play there.

Clutch kit and thrust bearing

For the clutch there are complete clutch kits and separate thrust bearings for the driving clutch. Whenever the clutch is out, fit a new thrust bearing too. A bearing that starts whining soon after means splitting the tractor all over again. While you are there, inspect the flywheel. If it shows blue heat marks or fine cracks, have it skimmed before the new plate goes on. Bushes and spacers complete the driveline parts.

Engine, cooling and electrics

Engine parts include gaskets, such as the one for the rear cover, along with thermostats and O-rings. An alternator is available if the battery has stopped charging. There is an exhaust tube, and you will also find rocker switches, lamp glasses and holders. Brake cylinder O-rings and a replacement drawbar complete the picture.

A rusted through exhaust tube is not only noisy, it can also direct hot gases towards the operator or the fuel system. Use new clamps when replacing it and mount the tube without tension so vibration does not crack the joint again. Before removing the alternator, check the belt and cables, as a slipping belt or a corroded terminal also leaves the battery flat.

Finding the right part

Check the type plate to confirm you have a 60-90. Hydraulic pumps and alternators usually carry their own plate with a number. Compare it with the number given on the product, and with a pump also check the direction of rotation.

The 60-90 is one of the Fiat 90 series tractors. These related models each have their own page:

The 85-90 belongs to the same series. For every other Fiat tractor, head to Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart