Menu
EUR

Fiat 65-90 tractor parts & technical data

More than 200 parts for the Fiat 65-90 on one page. They include lighting, trailer couplings and electrics, so the right spare for your tractor is easy to find.

246 parts found for Fiat 65-90
Show:
GRANIT Cylinder head gasket set upper engine 8045.02, 8045.06 Fiat
€86,77 €71,71 €82,40 €68,10
You save 5%
GRANIT Seal rear cover engine Fiat
Hydraulic pump single 16 cm³/rpm. anticlockwise, taper 1:8
Output volume: 16 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. A: 48,1 mm. B: 108,2 mm. Direction of rotation: Anticlockwise. Line connection suction sid... More
Output volume: 16 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. A: 48,1 mm...
€150,96 €124,76 €143,40 €118,51
You save 5%
Bosch/Rexroth Hydraulic pump 14 cm³/rpm., taper 1:8, Ø 17,46, 7/16-20 UNF, left Fiat
Bosch/Rexroth
Drive shaft: Taper 1:8, Ø 17.46- 7/16-20 UNF. Direction of rotation: Anticlockwise. Output volume: 14 cc/rev. Line connection suction side: Ø 40mm, ... More
Drive shaft: Taper 1:8, Ø 17.46- 7/16-20 UNF. Direction of rotation: ...
€490,49 €405,36 €465,95 €385,08
You save 5%
GRANIT Pin Ø 20 mm, length 60 mm Fiat
GRANIT
Dimensions: Length = 60, Ø = 20 mm. More
Dimensions: Length = 60, Ø = 20 mm.
€8,20 €6,78
GRANIT Spacer 85 x 89 x 6 mm Fiat series 66-94
GRANIT
Dimensions: 85 x 89 x 6 mm. More
Dimensions: 85 x 89 x 6 mm.
€33,70 €27,85
GRANIT Bowden cable drawbar / drawbar 1840 mm Fiat
GRANIT
Length: 1840 mm. More
Length: 1840 mm.
€80,67 €66,67 €72,95 €60,29
You save 10%
GRANIT Lock pin 16 x 70 mm galvanized
GRANIT
A: 16 mm. B: 70 mm. C: 35 mm. Version: galvanised. More
A: 16 mm. B: 70 mm. C: 35 mm. Version: galvanised.
€8,95 €7,40
GRANIT Contact switch hand brake control, 2 blade connections
GRANIT
Version: 2 blade terminals. More
Version: 2 blade terminals.
€43,37 €35,84 €39,20 €32,40
You save 10%
GRANIT Clutch cable PTO clutch 1150 mm, sleeve 920 mm, M6 Fiat
GRANIT
To fit as: Fiat 55-88, 60-88, 65-88, 70-88, 80-88, 55-90, 60-90, 65-90, 70-90, 80-90, 85-90, 60-94, 65-94, 72-94, 82-94, 88-94 More
To fit as: Fiat 55-88, 60-88, 65-88, 70-88, 80-88, 55-90, 60-90, 65-90...
€37,00 €30,58
GRANIT Thrust bearing single PTO clutch 70 x 110 x 20 mm
GRANIT
Dimensions (mm): 70 x 110 x 20 More
Dimensions (mm): 70 x 110 x 20
€34,61 €28,60 €32,85 €27,15
You save 5%
GRANIT Thrust bearing driving clutch single 50 x 80/89 x 22 mm
GRANIT
Dimensions (mm): 50 x 80/89 x 22 More
Dimensions (mm): 50 x 80/89 x 22
€48,82 €40,35 €46,35 €38,31
You save 5%
Elring Cylinder head gasket 1,43 mm engine 8045
€79,74 €65,90 €75,75 €62,60
You save 5%
Elring Cylinder head gasket 1,43 mm, Ø 105,5 mm engine 8045
€70,20 €58,02 €66,65 €55,08
You save 5%
MANN-FILTER Secondary filter main insert C14101, C14202/1, C14210/2
MANN-FILTER
Height: 318 mm. Outer Ø: 79 / 82 mm. Inner Ø: 77 mm. A: 79 mm. B: 77 mm. D: 82 mm. MANN no.: CF850/2. H: 318 mm. Fleetguard no.: AF25484. Menke no.:... More
Height: 318 mm. Outer Ø: 79 / 82 mm. Inner Ø: 77 mm. A: 79 mm. B: 77...
€32,25 €26,65
GRANIT Outlet valve Fiat, New Holland
GRANIT Hand throttle cable A 1170 mm, B 945 mm Fiat
GRANIT
A: 1170 mm. B: 945 mm. More
A: 1170 mm. B: 945 mm.
€30,55 €25,25
GRANIT Lift rod Ø 22 mm, yoke 37 mm, M27 Fiat
GRANIT
Dimensions: Thread = M27, Clevis width = 37, Bore Ø = 22 mm. More
Dimensions: Thread = M27, Clevis width = 37, Bore Ø = 22 mm.
€102,04 €84,33 €96,90 €80,08
You save 5%
Showing 217 - 240 of 246

Fiat 65-90 parts for the clutch, charging system and seals

Plenty of Fiat 65-90 tractors are still doing a full day's work, and sooner or later one needs a clutch, an alternator or a cure for a leaking lift shaft. For this model there are more than 200 replacement parts on this page, from GRANIT, Cobo, LUK, MAHLE and Walterscheid.

Doing the clutch while the tractor is split

Splitting a 65-90 takes time, so it pays to do the whole job in one go. You will find double clutch assemblies, complete clutch kits and separate thrust bearings. Always replace the thrust bearing with the clutch. If an old bearing starts to whine a few months later, the tractor has to come apart again. While it is open, check the flywheel for scoring and heat spots and renew the crankshaft seal if it is already weeping.

Alternators and gear reduction starters

There are several alternators for the charging side. If the engine is slow to turn over, a gear reduction starter is worth considering, as it delivers more torque from less current than a direct drive starter. In the cab you will find rocker switches, and for the lights there are lamp glasses. When fitting a new alternator, clean the earth strap and the battery terminals as well, because a poor connection is often the real reason a battery keeps going flat.

Tracking down oil leaks

Oil under the rear axle often comes from the lift shaft seal. We carry that seal along with gaskets, for instance for the oil sump, sealing rings for the lift cylinder piston and O-rings for the brake cylinder. For the cooling circuit there are thermostats with their O-ring. Ball joints for the steering, drawbars and an exhaust tube complete the picture.

  • double clutches, clutch kits and thrust bearings
  • alternators and gear reduction starters
  • seals, gaskets, sealing rings and O-rings
  • ball joints, thermostats and lamp glasses

Making sure it fits your 65-90

Check the type plate to confirm the model and note the serial number. For clutch parts and alternators, the number on the old part matters just as much, because different versions were fitted over the years. Compare that number with the product details and ask us if anything does not add up.

Within the Fiat 90 series, the 65-90 sits among several related models. Other models in that series have their own pages with the parts that fit them: Fiat 55-90, Fiat 60-90, Fiat 80-90, Fiat 90-90, Fiat 100-90 and Fiat 110-90. The Fiat 85-90 is part of the same series too. Fiat tractors outside this series are listed under Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart