Menu
EUR

Fiat 65-90 tractor parts & technical data

More than 200 parts for the Fiat 65-90 on one page. They include lighting, trailer couplings and electrics, so the right spare for your tractor is easy to find.

246 parts found for Fiat 65-90
Show:
GRANIT Double clutch DuT 280 35 x 40 mm, 14 splines, without torsion damper
GRANIT
Dimensions (mm): 35 x 40, 14 grooves | Additional information: Made in Germany More
Dimensions (mm): 35 x 40, 14 grooves | Additional information: Made in...
€659,86 €545,34 €626,85 €518,06
You save 5%
GRANIT Pilot bearing 17 x 47 x 14 mm
GRANIT
Dimensions (mm): 17 x 47 x 14 More
Dimensions (mm): 17 x 47 x 14
€6,30 €5,21
MAHLE Alternator 14 V, 55 A, flange 70 mm, pulley Ø 80 mm
MAHLE
Direction of rotation: ↻ | Belt width (mm) / type: 9,7 | Charging current (A): 55 | Pulley spacing (mm): 49,0 | Installation angle (°): 0 | Form: A... More
Direction of rotation: ↻ | Belt width (mm) / type: 9,7 | Charging cu...
€239,68 €198,08 €149,75 €123,76
You save 38%
Alternator 14 V, 33 A, flange 73 mm, pulley Ø 82 mm
Charging current (A): 33 | Pulley spacing (mm): 49,0 | Mounting L / d / R (mm): 73,0 / 10,2 / 80,0 | Nominal values (V / A): 14 / 33 | Belt tension ho... More
Charging current (A): 33 | Pulley spacing (mm): 49,0 | Mounting L / d ...
€139,15 €115,00 €132,15 €109,21
You save 5%
FEBI Alternator 14 V / 33 A, form A, flange 73,5 mm, pulley-Ø 80,0 mm
FEBI
To fit as: Antonio Carraro, Fiat, Lamborghini More
To fit as: Antonio Carraro, Fiat, Lamborghini
€288,43 €238,37 €211,40 €174,71
You save 27%
Piston steering cylinder Case IH, Fiat
€162,42 €134,23 €154,25 €127,48
You save 5%
GRANIT Ball joint taper 16,2 - 18,3 mm, 640 mm, M14 x 1,5, 20 mm
GRANIT
A: 640 mm. C: M14 x 1,5 mm. D: 20 mm. E: 16,2 mm. F: 18,3 mm. Taper: 16,2 - 18,3 mm. More
A: 640 mm. C: M14 x 1,5 mm. D: 20 mm. E: 16,2 mm. F: 18,3 mm. Taper: 1...
€43,80 €36,20 €41,60 €34,38
You save 5%
Ball joint 80 mm, M14 x 1,5, M20 x 1, taper 16,2 - 18,3 mm
A: 80 mm. C: M14 x 1,5 mm. D: M20 x 1 mm. E: 16,2 mm. F: 18,3 mm. Taper: 16,2 - 18,3 mm. More
A: 80 mm. C: M14 x 1,5 mm. D: M20 x 1 mm. E: 16,2 mm. F: 18,3 mm. Tape...
€36,90 €30,50
Brake disc Ø 260 mm, thickness 10 mm, 14 teeth Case IH, Fiat, New Holland
GRANIT Installation cable mini-contact plug 1 m
GRANIT
Length: 1 m. Technical data: Closure: 1.0 m. Reference no.: 1762510. More
Length: 1 m. Technical data: Closure: 1.0 m. Reference no.: 1762510.
€163,94 €135,49 €155,70 €128,68
You save 5%
GRANIT Flange curved water pump Ford, Fiat
Radiator hose, top inner-Ø 44 mm Fiat 08571-8571, Series 80-980
€19,80 €16,36
GRANIT Plastic fitting Ø 31 mm Ford, Fiat
GRANIT
Dimensions: Ø 31 mm. More
Dimensions: Ø 31 mm.
€24,75 €20,45
Water pump gasket Ford, Fiat
Crankshaft, 4-cylinder forged Fiat L 65-95, New Holland TN80-TN95
Notes: Please follow the instructions in the installation guide. Please complete the test instruction report contained therein, and return it to garan... More
Notes: Please follow the instructions in the installation guide. Pleas...
€830,81 €686,62 €789,25 €652,27
You save 5%
Stop solenoid switch New Holland, Ford, Fiat, Fendt
€48,82 €40,35 €46,35 €38,31
You save 5%
GRANIT Gasket set complete engine 8045.02, 8045.06 Fiat
€160,05 €132,27 €152,00 €125,62
You save 5%
Stop solenoid switch
€36,78 €30,40 €34,90 €28,84
You save 5%
Showing 145 - 168 of 246

Fiat 65-90 parts for the clutch, charging system and seals

Plenty of Fiat 65-90 tractors are still doing a full day's work, and sooner or later one needs a clutch, an alternator or a cure for a leaking lift shaft. For this model there are more than 200 replacement parts on this page, from GRANIT, Cobo, LUK, MAHLE and Walterscheid.

Doing the clutch while the tractor is split

Splitting a 65-90 takes time, so it pays to do the whole job in one go. You will find double clutch assemblies, complete clutch kits and separate thrust bearings. Always replace the thrust bearing with the clutch. If an old bearing starts to whine a few months later, the tractor has to come apart again. While it is open, check the flywheel for scoring and heat spots and renew the crankshaft seal if it is already weeping.

Alternators and gear reduction starters

There are several alternators for the charging side. If the engine is slow to turn over, a gear reduction starter is worth considering, as it delivers more torque from less current than a direct drive starter. In the cab you will find rocker switches, and for the lights there are lamp glasses. When fitting a new alternator, clean the earth strap and the battery terminals as well, because a poor connection is often the real reason a battery keeps going flat.

Tracking down oil leaks

Oil under the rear axle often comes from the lift shaft seal. We carry that seal along with gaskets, for instance for the oil sump, sealing rings for the lift cylinder piston and O-rings for the brake cylinder. For the cooling circuit there are thermostats with their O-ring. Ball joints for the steering, drawbars and an exhaust tube complete the picture.

  • double clutches, clutch kits and thrust bearings
  • alternators and gear reduction starters
  • seals, gaskets, sealing rings and O-rings
  • ball joints, thermostats and lamp glasses

Making sure it fits your 65-90

Check the type plate to confirm the model and note the serial number. For clutch parts and alternators, the number on the old part matters just as much, because different versions were fitted over the years. Compare that number with the product details and ask us if anything does not add up.

Within the Fiat 90 series, the 65-90 sits among several related models. Other models in that series have their own pages with the parts that fit them: Fiat 55-90, Fiat 60-90, Fiat 80-90, Fiat 90-90, Fiat 100-90 and Fiat 110-90. The Fiat 85-90 is part of the same series too. Fiat tractors outside this series are listed under Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart