Menu
EUR

Fiat 72-94 tractor parts & technical data

Sorted by model: more than 250 parts that fit the Fiat 72-94 from the 94 series, including lighting, electrics and trailer couplings for this tractor.

264 parts found for Fiat 72-94
Show:
Thrust washer Ø 325 mm Case IH, Fiat, New Holland
€101,58 €83,95 €96,50 €79,75
You save 5%
Optibelt V-belt engine cooling Fiat, Renault
Seal oil pump Ford, Fiat
GRANIT Clamp Ø 46 mm Fiat series 46-93
Injection nozzle Fiat 55-46 - 72-94, L 65, 85, 95
Type formula: DLL124S500W, DLLA124S1001, 0433271774. Bosch no.: 2580433271774. More
Type formula: DLL124S500W, DLLA124S1001, 0433271774. Bosch no.: 258043...
€42,59 €35,20 €40,45 €33,43
You save 5%
GRANIT Joint Fiat 90-90, 100-90, 110-90
€75,63 €62,50 €71,80 €59,34
You save 5%
Signal transmitter temperature thread M16
Version: Temperature, thread: M16. More
Version: Temperature, thread: M16.
€22,80 €18,84
Cobo Multifunction switch horn, indicators, indicator
Cobo
Version: For horn, lights, indicators, headlight flasher. More
Version: For horn, lights, indicators, headlight flasher.
€145,04 €119,87 €137,75 €113,84
You save 5%
Cobo Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
Cobo
Version: Without fuses, blade terminal connection at the bottom, transparent cover, L 174 x W 50 x H 34.5 mm. To fit: Blade terminal. Number of pins: ... More
Version: Without fuses, blade terminal connection at the bottom, trans...
€90,71 €74,97 €82,00 €67,77
You save 10%
HELLA Work lamp flood beam H3, 12 / 24 V, 35 / 70 W, square, mounting, bolted
HELLA
Bulb: H3. Connection: Blade terminal. Form: Rectangular. Material: • Housing: plastic • Diffusing lens: glass. Dimensions W x H x D: 154 x 94 x 11... More
Bulb: H3. Connection: Blade terminal. Form: Rectangular. Material: •...
€54,55 €45,08
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
To fit as: Case IH 238, 248, 258, 268, 278, 288, 323, 354, 374, 384, 444, 474, 475, 484, 584, 674, 684, 784, 884 385, 485, 485XL, 585, 585XL, 685, 685... More
To fit as: Case IH 238, 248, 258, 268, 278, 288, 323, 354, 374, 384, 4...
€48,98 €40,48 €44,30 €36,61
You save 10%
SACHS Thrust bearing 50 x 80 mm, 89 x 22 mm
SACHS
Dimensions (mm): 50 x 80 89 x 22 More
Dimensions (mm): 50 x 80 89 x 22
€84,70 €70,00 €72,85 €60,21
You save 14%
LUK Clutch kit double plate connection without release bearing, 30,50 kg
LUK
Contents: Pressure plate 458228007714, clutch plate 458328018616 | Supplementary set: Without release bearing | Connection: For vehicles with double-d... More
Contents: Pressure plate 458228007714, clutch plate 458328018616 | Sup...
€761,39 €629,25 €723,30 €597,77
You save 5%
LUK Thrust bearing PTO shaft 70 x 110 x 20 mm
LUK
Dimensions (mm): 70 x 110 x 20 More
Dimensions (mm): 70 x 110 x 20
€120,88 €99,90 €114,80 €94,88
You save 5%
Showing 193 - 216 of 264

Fiat 72-94 parts for the linkage, belt drive and clutch

On a Fiat 72-94 with plenty of seasons behind it, the linkage, the belts and the clutch tend to be the first things asking for attention. For this model from the Fiat 94 Series there are more than 250 replacement parts on this page, made by GRANIT, Cobo, MAHLE, LUK and Eaton among others.

Getting the linkage tight again

For the three point linkage there are lift rods, such as the upper part of the lifting strut, and seals for the lift shaft. A leaking lift shaft shows up as oil on the outside of the lift housing, usually mixed with dust into a dark crust. When you replace that seal, check the running surface of the shaft. A worn groove will make even a new seal weep again. Piston sealing rings are here as well.

Engine, belts and electrics

Engine parts include V-belts, gaskets such as the one for the oil sump, thermostat O-rings and alternators. For hard starting there is a gear reduction starter, which puts more torque on the ring gear while drawing less current.

A practical tip: fit a new V-belt whenever you fit a new alternator, and tension it properly. An old, stretched belt slips on the pulley, the alternator undercharges and the belt wears even faster. Check the tension again after a few hours of running, since a new belt always beds in a little.

In the cab, an air conditioning compressor from this range gets the cooling going again, and for the driver there are air suspended tractor seats.

Clutch and drawbar

On the clutch side there are clutch kits, double clutches and thrust bearings, plus gear wheels for the drive. A double clutch handles both the driving clutch and the PTO, so if you are unsure which one is slipping, it pays to look at the whole assembly. At the rear, a drawbar from this range fits the tractor.

Picking the right part for a 72-94

The rating plate tells you if you have a 72-94 or another model from the 94 Series. That matters, because each model has a page of its own. If you are unsure about a gasket or seal, use the number on the old part to compare it with the parts on this page.

The other 94 Series models each have their own overview. If you run one of them next to the 72-94, find its parts there:

Older Fiats and the other series are covered on Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart