Menu
EUR

Fiat 88-94 tractor parts & technical data

Running a Fiat 88-94 from the 94 series? This page lists more than 250 parts that fit it, with a wide choice of lighting, electrics and trailer couplings.

260 parts found for Fiat 88-94
Show:
GRANIT Double clutch DuT 280 35 x 40 mm, 14 splines, without torsion damper
5%
GRANIT
Double clutch DuT 280 35 x 40 mm, 14 splines, without torsion damper
Dimensions (mm): 35 x 40, 14 grooves | Additional information: Made in Germany
€659,86 €545,34 €626,85 €518,06
 
MAHLE Alternator 14 V, 55 A, flange 70 mm, pulley Ø 80 mm
38%
MAHLE
Alternator 14 V, 55 A, flange 70 mm, pulley Ø 80 mm
Direction of rotation: ↻ | Belt width (mm) / type: 9,7 | Charging current (A): 5...
€239,68 €198,08 €149,75 €123,76
 
Alternator 14 V, 33 A, flange 73 mm, pulley Ø 82 mm
5%
Alternator 14 V, 33 A, flange 73 mm, pulley Ø 82 mm
Charging current (A): 33 | Pulley spacing (mm): 49,0 | Mounting L / d / R (mm): ...
€139,15 €115,00 €132,15 €109,21
 
FEBI Alternator 14 V / 33 A, form A, flange 73,5 mm, pulley-Ø 80,0 mm
27%
FEBI
Alternator 14 V / 33 A, form A, flange 73,5 mm, pulley-Ø 80,0 mm
To fit as: Antonio Carraro, Fiat, Lamborghini
€288,43 €238,37 €211,40 €174,71
 
Piston steering cylinder Case IH, Fiat
5%
Piston steering cylinder Case IH, Fiat
€162,42 €134,23 €154,25 €127,48
 
GRANIT Ball joint taper 16,2 - 18,3 mm, 640 mm, M14 x 1,5, 20 mm
5%
GRANIT
Ball joint taper 16,2 - 18,3 mm, 640 mm, M14 x 1,5, 20 mm
A: 640 mm. C: M14 x 1,5 mm. D: 20 mm. E: 16,2 mm. F: 18,3 mm. Taper: 16,2 - 18,3...
€43,80 €36,20 €41,60 €34,38
 
Brake disc Ø 260 mm, thickness 10 mm, 14 teeth Case IH, Fiat, New Holland
5%
Brake disc Ø 260 mm, thickness 10 mm, 14 teeth Case IH, Fiat, New Holland
€163,43 €135,07 €155,25 €128,31
 
GRANIT Flange curved water pump Ford, Fiat
GRANIT
Flange curved water pump Ford, Fiat
€10,85 €8,97
 
Water pump gasket Ford, Fiat
Water pump gasket Ford, Fiat
€12,35 €10,21
 
Crankshaft, 4-cylinder forged Fiat L 65-95, New Holland TN80-TN95
5%
Crankshaft, 4-cylinder forged Fiat L 65-95, New Holland TN80-TN95
Notes: Please follow the instructions in the installation guide. Please complete...
€830,81 €686,62 €789,25 €652,27
 
Tension spring fast lift Fiat
Tension spring fast lift Fiat
€0,96 €0,79
 
Bosch/Rexroth Hydraulic pump 19 cm³/rpm., taper 1:8, Ø 17,46 mm, anticlockwise
5%
Bosch/Rexroth
Hydraulic pump 19 cm³/rpm., taper 1:8, Ø 17,46 mm, anticlockwise
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation...
€446,89 €369,33 €424,50 €350,83
 
Lift arm 970 mm, eye-Ø 26 / 28 mm Fiat, New Holland, Case IH
5%
Lift arm 970 mm, eye-Ø 26 / 28 mm Fiat, New Holland, Case IH
Eye Ø: 26 / 28 mm. Length: 970 mm.
€213,44 €176,40 €202,75 €167,56
 
Yoke pin-Ø 26 mm, bore 20 mm Fiat
5%
Yoke pin-Ø 26 mm, bore 20 mm Fiat
Dimensions: Bolt Ø = 26, Bore = 20 mm.
€40,14 €33,17 €38,10 €31,49
 
Cobo Tank sender main tank, stroke 389 mm
10%
Cobo
Tank sender main tank, stroke 389 mm
Version: Main tank, stroke: 389 mm.
€80,45 €66,49 €72,75 €60,12
 
Cobo Starter switch with key, 12 V, blade terminal, parking light, Ø 40 mm
10%
Cobo
Starter switch with key, 12 V, blade terminal, parking light, Ø 40 mm
Version: 12 V, with blade terminal, Function:, P: parking light, 0: off, 1: cons...
€64,66 €53,44 €58,50 €48,35
 
Cobo Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
10%
Cobo
Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
Version: Without fuses, blade terminal connection at the bottom, transparent cov...
€90,71 €74,97 €82,00 €67,77
 
Showing 145 - 168 of 260

Fiat 88-94 parts: clutch, cooling and three-point linkage

After many seasons, a Fiat 88-94 tends to bring back the same jobs: an alternator that stops charging, a clutch that starts to slip, a thermostat that sticks. This page holds more than 250 replacement parts for this tractor from makers such as GRANIT, Cobo, MAHLE, LUK and Walterscheid.

Clutch and engine

On the clutch side there are double clutch pressure plates and thrust bearings. With the tractor split anyway, always replace the thrust bearing too, even if it still runs quietly. It is a small part, but if it starts whining later you are back to splitting the tractor. For the engine there are gear reduction starters, alternators, air filters, V-belts and gaskets, including those for the turbocharger at the exhaust manifold and for the water pump. Fit a new O-ring with every new thermostat. An old ring that has been squashed flat will almost always let coolant past once the engine warms up.

Air conditioning, seat and hydraulics

If your 88-94 has a cab with air conditioning, there are aircon compressors for this model. When you replace a compressor, flush the system and fit a new receiver drier, or debris from the failed unit ends up in the new one. Match the compressor oil quantity to the system as well, since too much oil cools poorly and too little wears the new compressor.

The driver gets air-suspended tractor seats. At the rear there are drawbars, lift rods and seals for the lift cylinder, such as the seal for the outer lift cylinder and piston sealing rings. If the linkage slowly drops with a load on it, those piston seals are the first thing to check.

Finding the part that fits

The type plate on the tractor tells you exactly which model you have. Fiat made several tractors in the 94 series that look much alike at first glance. When you remove a part, look for a stamped or printed reference number and compare it with the number shown with the product. With an alternator, check the flange and the pulley. With a V-belt, check the length printed on the back of the old belt.

Each tractor in the 94 series has its own page with the parts that fit that model:

Other Fiat models are on the Fiat parts page.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart