What fits a Fiat 566? You can see it at a glance here: more than 120 parts, including lighting and brake and transmission parts for this tractor.
Most Fiat 566 owners come to this page with one of three jobs in mind: a clutch that slips, an engine that runs too hot or too cold, or a light that no longer works. All three are covered by the more than 120 replacement parts that fit the 566, supplied by GRANIT and by brands such as LUK, SACHS, FEBI and Cobo.
For the driving clutch there are complete clutch kits, double clutches, clutch plates and thrust bearings. A kit contains the parts that wear together and finishes the job in one go. If you replace parts separately, always include the thrust bearing. Centre the clutch plate with an alignment tool before bolting up the pressure plate, then tighten its bolts in a cross pattern over several passes so it pulls down evenly and the clutch does not judder.
For the cooling system there are thermostats, water pump gaskets and V-belts. The engine is covered by crankshaft seals, spacers, bolt sets and engine oil filters for routine servicing, and the charging side by alternators. When a thermostat is replaced, fit a new gasket at the same time rather than reusing the old one.
For the exhaust there are pipes, including a curved vertical pipe with an enamelled finish. For the lighting you will find headlights and separate lamp glasses, so a cracked glass does not mean a whole new lamp.
Every oil change calls for a new engine oil filter. Smear the rubber ring of the new filter with a little clean oil and screw it on by hand, without a filter wrench. Run the engine briefly afterwards and check for leaks.
If the alternator is not charging or you hear a squeal when you open the throttle, look at the V-belt. A belt with glazed flanks, cracks or too much slack will slip and no longer drive the alternator and water pump properly. Retension a new belt after the first few hours of work, as it stretches slightly at first.
Check the type plate, then look at the part you are replacing. Clutch plates, thrust bearings and gaskets often carry a reference number you can compare with the new part, and with a clutch plate the diameter and spline count matter too.
Within the Fiat range, the 566 sits in the 66 series alongside several close relatives. The Fiat 60-66, Fiat 65-66 and Fiat 70-66 each have their own page showing what fits those tractors. For other Fiat models, start at Fiat parts.