Menu
EUR

Fiat 65-88 tractor parts & technical data

Sorting through parts for a Fiat 65-88? This 88 series tractor has more than 200 of them on this page, such as lighting, electrics and trailer couplings.

240 parts found for Fiat 65-88
Show:
GRANIT Alternator 12 V / 45 A, pulley Ø 90 mm, W-connection
GRANIT
Nominal voltage (V): 12 | Charging current (A): 45 | Pulley spacing (mm): 58,0 | Additional information: With W connection | Belt tension hole Ø / R ... More
Nominal voltage (V): 12 | Charging current (A): 45 | Pulley spacing (m...
€194,88 €161,06 €185,10 €152,98
You save 5%
Eaton Gear wheel transmission 1,72 kg Case IH, Fiat, Ford, New Holland
Eaton
Reference no.: 5125005 More
Reference no.: 5125005
€181,14 €149,70 €172,00 €142,15
You save 5%
Eaton As transmission Case IH, Fiat, Ford, New Holland, 3,10 kg
Eaton
Reference no.: 47132984 More
Reference no.: 47132984
€201,80 €166,78
Eaton Link wheel Case IH, Fiat, Ford, New Holland
Eaton
Reference no.: 5125007 More
Reference no.: 5125007
€287,74 €237,80 €273,35 €225,91
You save 5%
LUK Pilot bearing 17 x 47 x 14 mm
LUK
Dimensions: 17 x 47 x 14 mm. Menke no.: 167836. More
Dimensions: 17 x 47 x 14 mm. Menke no.: 167836.
€32,31 €26,70 €30,65 €25,33
You save 5%
GRANIT O-ring 25,07 x 2,62 mm Fiat
GRANIT
Dimensions: 25.07 x 2.62 mm. More
Dimensions: 25.07 x 2.62 mm.
€1,00 €0,83
GRANIT Crankshaft seal Ø 42 x 65 x 12 mm Case IH, Fiat, Steyr, New Holland
GRANIT
Outer Ø: 65 mm. Width: 12 mm. Inner Ø: 42 mm. More
Outer Ø: 65 mm. Width: 12 mm. Inner Ø: 42 mm.
€5,00 €4,13
GRANIT Exhaust manifold enamelled outer-Ø 45 mm Case IH, Fiat, Ford
GRANIT
Version: Outer Ø: 45 mm. More
Version: Outer Ø: 45 mm.
€37,50 €30,99
GRANIT Fuel tank Fiat series 88, 90, 93, 94
€642,51 €531,00 €610,35 €504,42
You save 5%
Bosch/Rexroth Hydraulic pump 19 cm³/rpm., taper 1:8, Ø 17,46 mm, anticlockwise
Bosch/Rexroth
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation: Anticlockwise. Line connection suction side: Ø 40mm, 4-Loch, M8. L... More
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction ...
€446,89 €369,33 €424,50 €350,83
You save 5%
Bosch/Rexroth Hydraulic pump clockwise 19 cm³/rpm., taper 1:8, Ø 17,46 mm
Bosch/Rexroth
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction of rotation: Right. Line connection suction side: Ø 40mm, 4-Loch, M8. Line conn... More
Output volume: 19 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. Direction ...
€417,97 €345,43 €397,00 €328,10
You save 5%
GRANIT Handle right Fiat 15844, Series 88
€91,31 €75,46 €86,70 €71,65
You save 5%
Spacer 25 x 40 x 25 mm Fiat series 66 - 94, L 60 - L 95
Dimensions: 25 x 40 x 25 mm. More
Dimensions: 25 x 40 x 25 mm.
€10,00 €8,26
GRANIT Ring 23 x 40 x 25 mm Fiat L 60-95, New Holland TN55-TN95
GRANIT
Dimensions: 23 x 40 x 25 mm. More
Dimensions: 23 x 40 x 25 mm.
€9,95 €8,22
GRANIT Spacer 25 x 42 x 24 mm Case IH, Fiat, New Holland
GRANIT
Dimensions: 25 x 42 x 24 mm. More
Dimensions: 25 x 42 x 24 mm.
€26,00 €21,49
Showing 97 - 120 of 240

Fiat 65-88 parts to keep a classic working

The Fiat 65-88 has plenty of life left in it if the wear items are dealt with in time. More than 200 parts on this page fit this tractor. They are new replacement parts from GRANIT and from manufacturers including Cobo, LUK, MAHLE and Walterscheid.

Electrics and lighting

If the battery is not charging, an alternator is the likely candidate. For starting there are gear reduction starters, which turn the engine over with less current draw than an older direct drive unit. Inside the cab, worn rocker switches are a simple swap. On the lighting side, an indicator or position light often only has a cracked or faded lens while the housing and bulb holder are still sound. In that case a separate lamp glass is all you need, and the complete light for left or right is there when the housing itself has given up.

Cooling, hydraulics and steering

  • Thermostats with matching O-rings, plus gaskets for the water pump and oil sump
  • Hydraulic pumps and lifting shaft seals
  • Ball joints for the steering linkage
  • Thrust bearings for the driving clutch
  • Exhaust tubes, drawbars and an air suspended tractor seat

Pump rotation matters

Before ordering a hydraulic pump, check the direction of rotation and the drive. A pump turning the wrong way will not deliver oil and can be damaged quickly. The rotation is stated for every pump, so compare it with the unit you are taking off.

Before you replace the alternator

Measure the charging voltage with the engine running and check the earth strap first. A poor earth connection on an older tractor gives exactly the same symptoms as a failed regulator, and costs a lot less to fix. If the alternator really is at fault, compare the pulley and mounting flange of the old unit with the new one before fitting.

Identifying your 65-88 parts

The type plate tells you which model you have. On a tractor of this age some parts may already have been swapped for different ones over the years, so the number on the old part is a more dependable guide than memory. Hold it against the references listed with each product. For shaft seals, measuring inner diameter, outer diameter and thickness is a sure way to get the right one.

Other models in the 88 series

If you also look after a Fiat 60-88 or a Fiat 70-88, each has its own page listing what fits that model. For everything from this make, go to Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart