Menu
EUR

Fiat 88-94 tractor parts & technical data

Running a Fiat 88-94 from the 94 series? This page lists more than 250 parts that fit it, with a wide choice of lighting, electrics and trailer couplings.

260 parts found for Fiat 88-94
Show:
GRANIT Connecting rod bearing standard, Ø 63,73 mm
GRANIT
Connecting rod bearing standard, Ø 63,73 mm
Dimensions: Ø 63.73 mm.
€11,70 €9,67
 
GRANIT Gasket rear cover engine 8035.05-8045.06
GRANIT
Gasket rear cover engine 8035.05-8045.06
€9,00 €7,44
 
Hydraulic pump single 16 cm³/rpm. anticlockwise, taper 1:8
5%
Hydraulic pump single 16 cm³/rpm. anticlockwise, taper 1:8
Output volume: 16 cc/rev. Drive shaft: Taper 1:8, Ø 17.46. A: 48,1 mm. B: 108,2 ...
€150,96 €124,76 €143,40 €118,51
 
Bosch/Rexroth Hydraulic pump 14 cm³/rpm., taper 1:8, Ø 17,46, 7/16-20 UNF, left Fiat
5%
Bosch/Rexroth
Hydraulic pump 14 cm³/rpm., taper 1:8, Ø 17,46, 7/16-20 UNF, left Fiat
Drive shaft: Taper 1:8, Ø 17.46- 7/16-20 UNF. Direction of rotation: Anticlockwi...
€490,49 €405,36 €465,95 €385,08
 
Threaded sleeve M27 x 3 mm Fiat 04108-4108, Series 66 - 980, L 60-95
5%
Threaded sleeve M27 x 3 mm Fiat 04108-4108, Series 66 - 980, L 60-95
Dimensions: Thread = M27 x 3 mm.
€33,98 €28,08 €32,25 €26,65
 
GRANIT Pin Ø 20 mm, length 60 mm Fiat
GRANIT
Pin Ø 20 mm, length 60 mm Fiat
Dimensions: Length = 60, Ø = 20 mm.
€8,20 €6,78
 
GRANIT Spacer 85 x 89 x 6 mm Fiat series 66-94
GRANIT
Spacer 85 x 89 x 6 mm Fiat series 66-94
Dimensions: 85 x 89 x 6 mm.
€33,70 €27,85
 
GRANIT Sealing ring piston 110 x 114 x 4 mm Fiat, Ford, New Holland
GRANIT
Sealing ring piston 110 x 114 x 4 mm Fiat, Ford, New Holland
Dimensions: 110 x 114 x 4 mm.
€17,45 €14,42
 
GRANIT Lift rod 510 - 640 mm, Ø lower 26, upper 22 mm Fiat
5%
GRANIT
Lift rod 510 - 640 mm, Ø lower 26, upper 22 mm Fiat
Dimensions: Ø top = 22, Ø bottom = 26, Clevis inside = 34 mm. Length min./max.: ...
€235,10 €194,30 €223,30 €184,55
 
Yoke 410 mm, M27, clevis width 33 mm, bore Ø 26 mm Fiat
5%
Yoke 410 mm, M27, clevis width 33 mm, bore Ø 26 mm Fiat
Dimensions: Length = 410, Thread = M27, Clevis width = 33, Bore Ø = 26 mm.
€99,61 €82,32 €94,60 €78,18
 
GRANIT Lock pin 16 x 70 mm galvanized
GRANIT
Lock pin 16 x 70 mm galvanized
A: 16 mm. B: 70 mm. C: 35 mm. Version: galvanised.
€8,95 €7,40
 
GRANIT Contact switch hand brake control, 2 blade connections
10%
GRANIT
Contact switch hand brake control, 2 blade connections
Version: 2 blade terminals.
€43,37 €35,84 €39,20 €32,40
 
GRANIT Cover for switch cut-off / controls
GRANIT
Cover for switch cut-off / controls
Version: For switch cut-out (fittings).
€17,60 €14,55
 
GRANIT Clutch cable PTO clutch 1150 mm, sleeve 920 mm, M6 Fiat
GRANIT
Clutch cable PTO clutch 1150 mm, sleeve 920 mm, M6 Fiat
To fit as: Fiat 55-88, 60-88, 65-88, 70-88, 80-88, 55-90, 60-90, 65-90, 70-90, 8...
€37,00 €30,58
 
SANDEN Aircon compressor 12 V, Ø 132 mm, 2 grooves, 175 ccm
5%
SANDEN
Aircon compressor 12 V, Ø 132 mm, 2 grooves, 175 ccm
Fixing: EM | Pulley Ø (mm): 132 | No. of grooves: 2 | Suitable oil: SP 20 | Refr...
€529,98 €438,00 €503,45 €416,07
 
GRANIT Thrust bearing single PTO clutch 70 x 110 x 20 mm
5%
GRANIT
Thrust bearing single PTO clutch 70 x 110 x 20 mm
Dimensions (mm): 70 x 110 x 20
€34,61 €28,60 €32,85 €27,15
 
GRANIT Thrust bearing driving clutch single 50 x 80/89 x 22 mm
5%
GRANIT
Thrust bearing driving clutch single 50 x 80/89 x 22 mm
Dimensions (mm): 50 x 80/89 x 22
€48,82 €40,35 €46,35 €38,31
 
GRANIT V-belt alternator Fendt, Fiat, Case IH, Ford, New Holland
GRANIT
V-belt alternator Fendt, Fiat, Case IH, Ford, New Holland
Version: Alternator.
€8,70 €7,19
 
Showing 217 - 240 of 260

Fiat 88-94 parts: clutch, cooling and three-point linkage

After many seasons, a Fiat 88-94 tends to bring back the same jobs: an alternator that stops charging, a clutch that starts to slip, a thermostat that sticks. This page holds more than 250 replacement parts for this tractor from makers such as GRANIT, Cobo, MAHLE, LUK and Walterscheid.

Clutch and engine

On the clutch side there are double clutch pressure plates and thrust bearings. With the tractor split anyway, always replace the thrust bearing too, even if it still runs quietly. It is a small part, but if it starts whining later you are back to splitting the tractor. For the engine there are gear reduction starters, alternators, air filters, V-belts and gaskets, including those for the turbocharger at the exhaust manifold and for the water pump. Fit a new O-ring with every new thermostat. An old ring that has been squashed flat will almost always let coolant past once the engine warms up.

Air conditioning, seat and hydraulics

If your 88-94 has a cab with air conditioning, there are aircon compressors for this model. When you replace a compressor, flush the system and fit a new receiver drier, or debris from the failed unit ends up in the new one. Match the compressor oil quantity to the system as well, since too much oil cools poorly and too little wears the new compressor.

The driver gets air-suspended tractor seats. At the rear there are drawbars, lift rods and seals for the lift cylinder, such as the seal for the outer lift cylinder and piston sealing rings. If the linkage slowly drops with a load on it, those piston seals are the first thing to check.

Finding the part that fits

The type plate on the tractor tells you exactly which model you have. Fiat made several tractors in the 94 series that look much alike at first glance. When you remove a part, look for a stamped or printed reference number and compare it with the number shown with the product. With an alternator, check the flange and the pulley. With a V-belt, check the length printed on the back of the old belt.

Each tractor in the 94 series has its own page with the parts that fit that model:

Other Fiat models are on the Fiat parts page.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart