Menu
EUR

Fiat 88-94 tractor parts & technical data

Running a Fiat 88-94 from the 94 series? This page lists more than 250 parts that fit it, with a wide choice of lighting, electrics and trailer couplings.

260 parts found for Fiat 88-94
Show:
GRANIT Cylinder head gasket set upper engine 8045.04, 8045.05, 8045.25 Fiat
5%
GRANIT
Cylinder head gasket set upper engine 8045.04, 8045.05, 8045.25 Fiat
€175,83 €145,31 €167,00 €138,02
 
GRANIT O-ring thermostat Ford, Case IH, Fiat, Steyr
GRANIT
O-ring thermostat Ford, Case IH, Fiat, Steyr
€4,31 €3,56
 
GRANIT Seal rear cover engine Fiat
GRANIT
Seal rear cover engine Fiat
€2,64 €2,18
 
GRANIT Joint Fiat 90-90, 100-90, 110-90
5%
GRANIT
Joint Fiat 90-90, 100-90, 110-90
€75,63 €62,50 €71,80 €59,34
 
GRANIT Bowden cable drawbar / drawbar 1840 mm Fiat
10%
GRANIT
Bowden cable drawbar / drawbar 1840 mm Fiat
Length: 1840 mm.
€80,67 €66,67 €72,95 €60,29
 
Signal transmitter temperature thread M16
Signal transmitter temperature thread M16
Version: Temperature, thread: M16.
€22,80 €18,84
 
Cobo Multifunction switch horn, indicators, indicator
5%
Cobo
Multifunction switch horn, indicators, indicator
Version: For horn, lights, indicators, headlight flasher.
€145,04 €119,87 €137,75 €113,84
 
Cobo Push button switch built-in make contact 12 V/30 A, 24 V/20 A, IP40
Cobo
Push button switch built-in make contact 12 V/30 A, 24 V/20 A, IP40
Version: For flush mounting, make contact, normally off, 12 V / 30 A inductive, ...
€20,50 €16,94
 
HELLA Work lamp flood beam H3, 12 / 24 V, 35 / 70 W, square, mounting, bolted
HELLA
Work lamp flood beam H3, 12 / 24 V, 35 / 70 W, square, mounting, bolted
Bulb: H3. Connection: Blade terminal. Form: Rectangular. Material: • Housing: pl...
€54,55 €45,08
 
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
10%
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
To fit as: Case IH 238, 248, 258, 268, 278, 288, 323, 354, 374, 384, 444, 474, 4...
€48,98 €40,48 €44,30 €36,61
 
SACHS Thrust bearing 50 x 80 mm, 89 x 22 mm
14%
SACHS
Thrust bearing 50 x 80 mm, 89 x 22 mm
Dimensions (mm): 50 x 80 89 x 22
€84,70 €70,00 €72,85 €60,21
 
LUK Clutch kit double plate connection without release bearing, 30,50 kg
5%
LUK
Clutch kit double plate connection without release bearing, 30,50 kg
Contents: Pressure plate 458228007714, clutch plate 458328018616 | Supplementary...
€761,39 €629,25 €723,30 €597,77
 
LUK Thrust bearing PTO shaft 70 x 110 x 20 mm
5%
LUK
Thrust bearing PTO shaft 70 x 110 x 20 mm
Dimensions (mm): 70 x 110 x 20
€120,88 €99,90 €114,80 €94,88
 
MAHLE Alternator 14 V, 45 A, pulley Ø 90 mm, flange 70 mm
38%
MAHLE
Alternator 14 V, 45 A, pulley Ø 90 mm, flange 70 mm
Nominal voltage (V): 14 | Mounting L / d / R (mm): 70,0 / 12,2 / 85,0 | Belt wid...
€266,89 €220,57 €166,75 €137,81
 
Elring Cylinder head gasket 1,43 mm, Ø 105,5 mm engine 8045
5%
Elring
Cylinder head gasket 1,43 mm, Ø 105,5 mm engine 8045
€70,20 €58,02 €66,65 €55,08
 
Eaton Gear wheel transmission 3,15 kg Case IH, Fiat, Ford, New Holland, Steyr
5%
Eaton
Gear wheel transmission 3,15 kg Case IH, Fiat, Ford, New Holland, Steyr
Reference no.: 5131680
€289,80 €239,50 €275,30 €227,52
 
MAHLE Gear reduction starter 12 V, 3,2 kW, 9 teeth, Ø 110 mm, flange 30 mm
38%
MAHLE
Gear reduction starter 12 V, 3,2 kW, 9 teeth, Ø 110 mm, flange 30 mm
€572,32 €472,99 €357,65 €295,58
 
Radiator cap grommet-Ø 57 mm, height 25 mm, for expansion tank
Radiator cap grommet-Ø 57 mm, height 25 mm, for expansion tank
Version: For expansion tank. Neck Ø: 57 mm. Height: 25 mm.
€15,30 €12,64
 
Showing 193 - 216 of 260

Fiat 88-94 parts: clutch, cooling and three-point linkage

After many seasons, a Fiat 88-94 tends to bring back the same jobs: an alternator that stops charging, a clutch that starts to slip, a thermostat that sticks. This page holds more than 250 replacement parts for this tractor from makers such as GRANIT, Cobo, MAHLE, LUK and Walterscheid.

Clutch and engine

On the clutch side there are double clutch pressure plates and thrust bearings. With the tractor split anyway, always replace the thrust bearing too, even if it still runs quietly. It is a small part, but if it starts whining later you are back to splitting the tractor. For the engine there are gear reduction starters, alternators, air filters, V-belts and gaskets, including those for the turbocharger at the exhaust manifold and for the water pump. Fit a new O-ring with every new thermostat. An old ring that has been squashed flat will almost always let coolant past once the engine warms up.

Air conditioning, seat and hydraulics

If your 88-94 has a cab with air conditioning, there are aircon compressors for this model. When you replace a compressor, flush the system and fit a new receiver drier, or debris from the failed unit ends up in the new one. Match the compressor oil quantity to the system as well, since too much oil cools poorly and too little wears the new compressor.

The driver gets air-suspended tractor seats. At the rear there are drawbars, lift rods and seals for the lift cylinder, such as the seal for the outer lift cylinder and piston sealing rings. If the linkage slowly drops with a load on it, those piston seals are the first thing to check.

Finding the part that fits

The type plate on the tractor tells you exactly which model you have. Fiat made several tractors in the 94 series that look much alike at first glance. When you remove a part, look for a stamped or printed reference number and compare it with the number shown with the product. With an alternator, check the flange and the pulley. With a V-belt, check the length printed on the back of the old belt.

Each tractor in the 94 series has its own page with the parts that fit that model:

Other Fiat models are on the Fiat parts page.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart