Menu
EUR

Fiat 90-90 tractor parts & technical data

If there is a Fiat 90-90 in your yard, this is your overview: more than 200 parts for the 90 series, including lighting, electrics and trailer couplings.

235 parts found for Fiat 90-90
Show:
Pilot bearing 20 x 47 x 14 mm, 106 g
Dimensions (mm): 20 x 47 x 14 More
Dimensions (mm): 20 x 47 x 14
€9,85 €8,14
Piston steering cylinder Case IH, Fiat
€162,42 €134,23 €154,25 €127,48
You save 5%
Heating element Ford, Fiat, New Holland
€309,46 €255,75 €293,95 €242,93
You save 5%
Radiator hose, top inner-Ø 44 mm Fiat 08571-8571, Series 80-980
€19,80 €16,36
GRANIT Water pump with connecting flange and seal engine Ford, Fiat, Renault
GRANIT
Description: With gasket. More
Description: With gasket.
€125,51 €103,73 €119,20 €98,51
You save 5%
GRANIT Water pump with flange-mounted design and gasket Ford, Fiat
GRANIT
To fit: Fiat. Reference no.: S.59000. Version: Old version with flange connection and gasket. Description: With gasket. More
To fit: Fiat. Reference no.: S.59000. Version: Old version with flange...
€122,95 €101,61 €116,80 €96,53
You save 5%
Stop solenoid switch New Holland, Ford, Fiat, Fendt
€48,82 €40,35 €46,35 €38,31
You save 5%
GRANIT Injection nozzle Fiat 60-46 - 88-94, L 60, 75
GRANIT
Type formula: DLLA136S1000, 0433271775. Bosch no.: 2580433271775. More
Type formula: DLLA136S1000, 0433271775. Bosch no.: 2580433271775.
€31,94 €26,40 €30,30 €25,04
You save 5%
GRANIT Crankshaft seal Ø 42 x 65 x 12 mm Case IH, Fiat, Steyr, New Holland
GRANIT
Outer Ø: 65 mm. Width: 12 mm. Inner Ø: 42 mm. More
Outer Ø: 65 mm. Width: 12 mm. Inner Ø: 42 mm.
€5,00 €4,13
Yoke pin-Ø 26 mm, bore 20 mm Fiat
Dimensions: Bolt Ø = 26, Bore = 20 mm. More
Dimensions: Bolt Ø = 26, Bore = 20 mm.
€40,14 €33,17 €38,10 €31,49
You save 5%
Bush left lift arm shaft 62,8 x 68,2 x 40 mm Ford, Fiat, New Holland
Dimensions: 62.8 x 68.2 x 40 mm. More
Dimensions: 62.8 x 68.2 x 40 mm.
€22,00 €18,18
Frame hood Fiat series 80, 90, TK
€245,85 €203,18 €233,55 €193,02
You save 5%
Holder right Fiat Series 66-94
€58,21 €48,11 €52,65 €43,51
You save 10%
Sensor oliepeil transmission, M32 x 1,5
Version: Oil level monitoring, Thread: M32 x 1.5. More
Version: Oil level monitoring, Thread: M32 x 1.5.
€69,81 €57,69 €63,15 €52,19
You save 10%
Showing 97 - 120 of 235

Fiat 90-90 parts for the linkage, engine and steering

Most Fiat 90-90 tractors have a lot of hours behind them, and it shows in seals, bearings and bushes. More than 200 replacement parts fit this model, from GRANIT and from makers such as Cobo, Walterscheid, Bosch/Rexroth and FLEETGUARD.

Bringing the linkage back to life

If the linkage slowly drops with an implement on, the leak is often in the lift cylinder. There are seals for the outer lift cylinder and piston sealing rings, along with bushes for the lift arm shaft and lift rods. For oil pressure there is a single hydraulic pump from Bosch/Rexroth. Before fitting new seals, inspect the cylinder bore for scoring. A groove in the bore will chew through fresh seals in no time and the job will have been wasted.

Engine, clutch and front axle

For cooling there is a thermostat with its O-ring, plus gaskets for the water pump and the rear engine cover. A FLEETGUARD air filter with a separate inner element keeps the intake clean. The driving clutch can take a new thrust bearing, the steering new ball joints, and the brakes new brake cylinder O-rings. Lamp glasses, holders, yokes and rocker switches complete the list.

A quick note on the inner air filter: replace it rather than blowing it out. It is the last line of defence for the engine if the outer element is ever damaged.

Thrust bearing and clutch

A thrust bearing that sings or rattles as soon as you press the clutch pedal needs replacing. The tractor has to be split to reach it, so inspect the clutch plate and pressure plate on the same job. Reset the pedal play after fitting. With too little play the bearing turns all the time and the new one will soon be worn out too.

Ordering the right part

On an older tractor the type plate can be weathered, so clean it carefully to confirm you have a 90-90. For seals, bushes and bearings, measure the old part and compare the bore, outside size and width with the product details. Filters usually have a clearly printed reference number on the housing.

The rest of the 90 series

The 90 series came in several sizes, and each one has a page here with the parts that fit it:

For the rest of the brand, go to Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart