Menu
EUR

Fiat 90-90 tractor parts & technical data

If there is a Fiat 90-90 in your yard, this is your overview: more than 200 parts for the 90 series, including lighting, electrics and trailer couplings.

235 parts found for Fiat 90-90
Show:
Bush 14 teeth Fiat 90-90 - 110-90, F 100 - F 140, M 115 - M 160
5%
Bush 14 teeth Fiat 90-90 - 110-90, F 100 - F 140, M 115 - M 160
€68,36 €56,50 €64,90 €53,64
 
Piston steering cylinder Case IH, Fiat
5%
Piston steering cylinder Case IH, Fiat
€162,42 €134,23 €154,25 €127,48
 
GRANIT Ball joint taper 16,2 - 18,3 mm, 640 mm, M14 x 1,5, 20 mm
5%
GRANIT
Ball joint taper 16,2 - 18,3 mm, 640 mm, M14 x 1,5, 20 mm
A: 640 mm. C: M14 x 1,5 mm. D: 20 mm. E: 16,2 mm. F: 18,3 mm. Taper: 16,2 - 18,3...
€43,80 €36,20 €41,60 €34,38
 
GRANIT Installation cable mini-contact plug 1 m
5%
GRANIT
Installation cable mini-contact plug 1 m
Length: 1 m. Technical data: Closure: 1.0 m. Reference no.: 1762510.
€163,94 €135,49 €155,70 €128,68
 
GRANIT Flange curved water pump Ford, Fiat
GRANIT
Flange curved water pump Ford, Fiat
€10,85 €8,97
 
GRANIT Plastic fitting Ø 31 mm Ford, Fiat
GRANIT
Plastic fitting Ø 31 mm Ford, Fiat
Dimensions: Ø 31 mm.
€24,75 €20,45
 
Water pump gasket Ford, Fiat
Water pump gasket Ford, Fiat
€12,35 €10,21
 
Stop solenoid switch New Holland, Ford, Fiat, Fendt
5%
Stop solenoid switch New Holland, Ford, Fiat, Fendt
€48,82 €40,35 €46,35 €38,31
 
GRANIT Injection nozzle Fiat 60-46 - 88-94, L 60, 75
5%
GRANIT
Injection nozzle Fiat 60-46 - 88-94, L 60, 75
Type formula: DLLA136S1000, 0433271775. Bosch no.: 2580433271775.
€31,94 €26,40 €30,30 €25,04
 
Tension spring fast lift Fiat
Tension spring fast lift Fiat
€0,96 €0,79
 
Yoke pin-Ø 26 mm, bore 20 mm Fiat
5%
Yoke pin-Ø 26 mm, bore 20 mm Fiat
Dimensions: Bolt Ø = 26, Bore = 20 mm.
€40,14 €33,17 €38,10 €31,49
 
GRANIT Lifting shaft sealing ring 55 x 70 x 8/8,5 mm Ford, Fiat, New Holland
GRANIT
Lifting shaft sealing ring 55 x 70 x 8/8,5 mm Ford, Fiat, New Holland
Dimensions: 55 x 70 x 8/8.5 mm.
€3,60 €2,98
 
GRANIT Lift rod right and left 650 - 730 mm, Ø lower 25, upper 26 mm Fiat
5%
GRANIT
Lift rod right and left 650 - 730 mm, Ø lower 25, upper 26 mm Fiat
Dimensions: Length = min. 650, max. 730, Ø bottom 25, top 26, Clevis width insid...
€213,20 €176,20 €202,50 €167,36
 
Sensor oliepeil transmission, M32 x 1,5
10%
Sensor oliepeil transmission, M32 x 1,5
Version: Oil level monitoring, Thread: M32 x 1.5.
€69,81 €57,69 €63,15 €52,19
 
Cobo Starter switch with key, 12 V, blade terminal, parking light, Ø 40 mm
10%
Cobo
Starter switch with key, 12 V, blade terminal, parking light, Ø 40 mm
Version: 12 V, with blade terminal, Function:, P: parking light, 0: off, 1: cons...
€64,66 €53,44 €58,50 €48,35
 
Cobo Rocker switch work lamp 12 V / 24 V, 8 connections
10%
Cobo
Rocker switch work lamp 12 V / 24 V, 8 connections
Version: 12 V/24 V, On/off switch, 8 blade terminals, Installation dimension: 15...
€46,18 €38,17 €41,75 €34,50
 
GRANIT Thermostat Ø 54 mm, 79 °C Ford, Case IH, Fiat, Steyr, New Holland
GRANIT
Thermostat Ø 54 mm, 79 °C Ford, Case IH, Fiat, Steyr, New Holland
To fit as: New Holland TD 55D, 65D, 75D, 85D, 95D, TL 70, 80, 90, 100, TN 55, 65...
€23,30 €19,26
 
MANN-FILTER Secondary air filter CF990/2, main filter C17337/2
MANN-FILTER
Secondary air filter CF990/2, main filter C17337/2
Suitable main filter 565C17337.2
€36,00 €29,75
 
Showing 121 - 144 of 235

Fiat 90-90 parts for the linkage, engine and steering

Most Fiat 90-90 tractors have a lot of hours behind them, and it shows in seals, bearings and bushes. More than 200 replacement parts fit this model, from GRANIT and from makers such as Cobo, Walterscheid, Bosch/Rexroth and FLEETGUARD.

Bringing the linkage back to life

If the linkage slowly drops with an implement on, the leak is often in the lift cylinder. There are seals for the outer lift cylinder and piston sealing rings, along with bushes for the lift arm shaft and lift rods. For oil pressure there is a single hydraulic pump from Bosch/Rexroth. Before fitting new seals, inspect the cylinder bore for scoring. A groove in the bore will chew through fresh seals in no time and the job will have been wasted.

Engine, clutch and front axle

For cooling there is a thermostat with its O-ring, plus gaskets for the water pump and the rear engine cover. A FLEETGUARD air filter with a separate inner element keeps the intake clean. The driving clutch can take a new thrust bearing, the steering new ball joints, and the brakes new brake cylinder O-rings. Lamp glasses, holders, yokes and rocker switches complete the list.

A quick note on the inner air filter: replace it rather than blowing it out. It is the last line of defence for the engine if the outer element is ever damaged.

Thrust bearing and clutch

A thrust bearing that sings or rattles as soon as you press the clutch pedal needs replacing. The tractor has to be split to reach it, so inspect the clutch plate and pressure plate on the same job. Reset the pedal play after fitting. With too little play the bearing turns all the time and the new one will soon be worn out too.

Ordering the right part

On an older tractor the type plate can be weathered, so clean it carefully to confirm you have a 90-90. For seals, bushes and bearings, measure the old part and compare the bore, outside size and width with the product details. Filters usually have a clearly printed reference number on the housing.

The rest of the 90 series

The 90 series came in several sizes, and each one has a page here with the parts that fit it:

For the rest of the brand, go to Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart