Menu
EUR

Fiat 90-90 tractor parts & technical data

If there is a Fiat 90-90 in your yard, this is your overview: more than 200 parts for the 90 series, including lighting, electrics and trailer couplings.

235 parts found for Fiat 90-90
Show:
Scharmüller Drawbar pin-Ø 38 mm, 1279 mm, category 3, black Fiat
Scharmüller
Drawbar pin-Ø 38 mm, 1279 mm, category 3, black Fiat
Colour: Black | Mounting position: 2 | D-value (kN): 93,7 | Width (mm): 90 | Loc...
€736,45 €608,64
 
LUK Thrust bearing 50 x 90 x 21,6 mm
5%
LUK
Thrust bearing 50 x 90 x 21,6 mm
Dimensions (mm): 50 x 90 x 21.6
€85,00 €70,25 €80,75 €66,74
 
Clutch kit Fiat 880, 980, 90-90 - 110-90
5%
Clutch kit Fiat 880, 980, 90-90 - 110-90
Contents: Clutch (445K88876102), organic disc (445S64914003), release bearing (4...
€756,55 €625,25 €718,70 €593,97
 
HELLA Alternator 14 V, 65 A, without belt pulley
20%
HELLA
Alternator 14 V, 65 A, without belt pulley
Nominal voltage (V): 14 | Additional information: Without pulley | Nominal value...
€304,81 €251,91 €245,00 €202,48
 
FEBI Fuel filter WK842
57%
FEBI
Fuel filter WK842
€19,60 €16,20 €8,47 €7,00
 
Bush drive shaft 12 teeth Fiat Series 90, M 100-160, F 100-140
5%
Bush drive shaft 12 teeth Fiat Series 90, M 100-160, F 100-140
€36,42 €30,10 €34,55 €28,55
 
Ball joint 106 mm, taper 20 - 22 mm, M18 x 1,5, M24 x 1,5
5%
Ball joint 106 mm, taper 20 - 22 mm, M18 x 1,5, M24 x 1,5
A: 106 mm. C: M18 x 1,5 mm. D: M24 x 1,5 mm. E: 20 mm. F: 22 mm. Taper: 20 - 22 ...
€57,56 €47,57 €54,65 €45,17
 
GRANIT Spring clutch Fiat, Ford, New Holland
GRANIT
Spring clutch Fiat, Ford, New Holland
€1,61 €1,33
 
Collet set Fiat, New Holland
Collet set Fiat, New Holland
€2,04 €1,69
 
GRANIT O-ring thermostat Ford, Case IH, Fiat, Steyr
GRANIT
O-ring thermostat Ford, Case IH, Fiat, Steyr
€4,31 €3,56
 
Lever with bolt and lock steering valve Fiat, Ford, New Holland
5%
Lever with bolt and lock steering valve Fiat, Ford, New Holland
€85,28 €70,48 €81,00 €66,94
 
GRANIT Joint Fiat 90-90, 100-90, 110-90
5%
GRANIT
Joint Fiat 90-90, 100-90, 110-90
€75,63 €62,50 €71,80 €59,34
 
Signal transmitter temperature thread M16
Signal transmitter temperature thread M16
Version: Temperature, thread: M16.
€22,80 €18,84
 
Cobo Multifunction switch horn, lighting, indicators
5%
Cobo
Multifunction switch horn, lighting, indicators
Version: For horn, lights, indicators.
€135,54 €112,02 €128,75 €106,41
 
Cobo Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
10%
Cobo
Fuse box 12-pin blade fuse connection, 174 x 50 x 34,5 mm
Version: Without fuses, blade terminal connection at the bottom, transparent cov...
€90,71 €74,97 €82,00 €67,77
 
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
10%
Flasher unit 12 V, 2+1+1 x 21 W, with holder and indicator instruments
To fit as: Case IH 238, 248, 258, 268, 278, 288, 323, 354, 374, 384, 444, 474, 4...
€48,98 €40,48 €44,30 €36,61
 
GRANIT External plate 1,5 mm, inner 100 mm, outer 152 mm, 6 teeth
GRANIT
External plate 1,5 mm, inner 100 mm, outer 152 mm, 6 teeth
Version: Thickness: 1.5 mm Inner: 100 mm Outer: 152 mm 6 teeth
€10,65 €8,80
 
SACHS Thrust bearing 50 x 80 mm, 89 x 22 mm
14%
SACHS
Thrust bearing 50 x 80 mm, 89 x 22 mm
Dimensions (mm): 50 x 80 89 x 22
€84,70 €70,00 €72,85 €60,21
 
LUK Thrust bearing PTO clutch 75 x 115 x 20 mm
5%
LUK
Thrust bearing PTO clutch 75 x 115 x 20 mm
Dimensions (mm): 75 x 115 x 20
€175,89 €145,36 €167,00 €138,02
 
Showing 145 - 168 of 235

Fiat 90-90 parts for the linkage, engine and steering

Most Fiat 90-90 tractors have a lot of hours behind them, and it shows in seals, bearings and bushes. More than 200 replacement parts fit this model, from GRANIT and from makers such as Cobo, Walterscheid, Bosch/Rexroth and FLEETGUARD.

Bringing the linkage back to life

If the linkage slowly drops with an implement on, the leak is often in the lift cylinder. There are seals for the outer lift cylinder and piston sealing rings, along with bushes for the lift arm shaft and lift rods. For oil pressure there is a single hydraulic pump from Bosch/Rexroth. Before fitting new seals, inspect the cylinder bore for scoring. A groove in the bore will chew through fresh seals in no time and the job will have been wasted.

Engine, clutch and front axle

For cooling there is a thermostat with its O-ring, plus gaskets for the water pump and the rear engine cover. A FLEETGUARD air filter with a separate inner element keeps the intake clean. The driving clutch can take a new thrust bearing, the steering new ball joints, and the brakes new brake cylinder O-rings. Lamp glasses, holders, yokes and rocker switches complete the list.

A quick note on the inner air filter: replace it rather than blowing it out. It is the last line of defence for the engine if the outer element is ever damaged.

Thrust bearing and clutch

A thrust bearing that sings or rattles as soon as you press the clutch pedal needs replacing. The tractor has to be split to reach it, so inspect the clutch plate and pressure plate on the same job. Reset the pedal play after fitting. With too little play the bearing turns all the time and the new one will soon be worn out too.

Ordering the right part

On an older tractor the type plate can be weathered, so clean it carefully to confirm you have a 90-90. For seals, bushes and bearings, measure the old part and compare the bore, outside size and width with the product details. Filters usually have a clearly printed reference number on the housing.

The rest of the 90 series

The 90 series came in several sizes, and each one has a page here with the parts that fit it:

For the rest of the brand, go to Fiat parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart