Keeping a Massey Ferguson 168 running takes the right parts. Choose from more than 140 items here, including vintage tractor parts, lighting and electrics.
A Massey Ferguson 168 that still earns its keep around the yard needs attention to the basics: cooling, front axle, exhaust and tinwork. This page lists more than 140 parts for the 168 from FEBI, Blue Print, GRANIT, CARLISLE and MASSEY FERGUSON.
Front axle parts include stub axles for left and right, wheel bearings for the reinforced front axle, wheel hub seals, sealing rings and bushes, along with steering arms. When changing wheel bearings, clean the hub thoroughly, pack the new bearing with grease and set the preload with the castle nut until the wheel turns freely with no felt play. Then lock it with a new split pin. Drive a new seal in with a suitable drift so it sits square in the hub.
For the cooling system there are cooling fans, radiator hoses and gaskets, including the water pump gasket. A radiator hose that feels soft or swollen is better replaced before it bursts out in the field. Fit new hoses with clean clamps and check them again after the first warm up. Exhaust manifolds are listed too, as well as O-rings for the fuel system and filters.
Many owners like to keep a 168 looking right. For that there are side plates for the bonnet, headlamp housings and gear lever gaiters that keep dirt and water out of the gearbox.
A cracked exhaust manifold gives itself away on a cold start as a ticking that fades once the iron warms up. When you replace the manifold on the 168, use new gaskets and tighten the nuts from the centre outwards in stages, then run the engine up to temperature and retighten once it has cooled. If the studs are rusted in, penetrating oil and patience beat brute force, since a snapped stud in the block costs you an extra afternoon. Filters for the hydraulic steering belong in the regular service. With the steering arms it pays to check the bushes and stub axles at the same time, as play in the steering rarely comes from one spot. After fitting a new arm, turn the wheel from lock to lock with the tractor standing and make sure nothing fouls.
On a tractor like the 168 the type plate is often hard to read. Compare the reference number stamped or cast into the old part, and for bearings and seals check the sizes marked on the part itself. For other models from the brand, go to Massey Ferguson parts, where each tractor has its own page.