Menu
EUR

Massey Ferguson 575 tractor parts & technical data

Lighting, electrics and trailer couplings for the Massey Ferguson 575 are grouped here. In total more than 250 parts that fit this 500 series tractor.

253 parts found for Massey Ferguson 575
Show:
Eaton Thrust washer transmission 74 g Massey Ferguson 158 F - 5365
Eaton
Reference no.: 1671891M2 More
Reference no.: 1671891M2
€56,45 €46,65 €53,60 €44,30
You save 5%
Detent rod 369 mm, M16 x 1,5, taper 17,4 - 19,8 mm
A: 369 mm. C: M16 x 1,5 mm. D: 18,8 mm. E: 17,4 mm. F: 19,8 mm. Taper: 17,4 - 19,8 mm. More
A: 369 mm. C: M16 x 1,5 mm. D: 18,8 mm. E: 17,4 mm. F: 19,8 mm. Taper:...
€34,85 €28,80
Repair set brake cylinder Massey Ferguson, Landini
€34,62 €28,61 €32,85 €27,15
You save 5%
GRANIT Wheel brake cylinder 2x 3/8 UNF, DOT 4 Massey Ferguson 255-1004
€108,72 €89,85 €103,25 €85,33
You save 5%
GRANIT O-ring PTO shaft 47,29 x 2,62 mm Massey Ferguson
GRANIT
Version: Ø 47,29 x 2,62 mm. More
Version: Ø 47,29 x 2,62 mm.
€8,35 €6,90
Needle bearing transmission input Ø 49,3 x 41,2 x 16,1 mm
Dimensions: 41,2 x 49,3 x 16,1 mm. Outer Ø: 49,3 mm. Inner Ø: 41,2 mm. Height 1: 16.1 mm. More
Dimensions: 41,2 x 49,3 x 16,1 mm. Outer Ø: 49,3 mm. Inner Ø: 41,2 m...
€10,30 €8,51
Gear lever knob Ø 29 mm, thread 7/16" UNF Massey Ferguson
Version: Ø 29 mm, thread 7/16" UNF. More
Version: Ø 29 mm, thread 7/16" UNF.
€10,50 €8,68
GRANIT Heating element John Deere, Massey Ferguson, McCormick
€284,36 €235,01 €270,10 €223,22
You save 5%
VICTOR REINZ Cylinder head gasket set engine Perkins 4.236, 4.248 Massey Ferguson
€126,93 €104,90 €120,55 €99,63
You save 5%
GRANIT Radiator hose, bottom inner-Ø 40 mm Massey Ferguson 178-590
€20,70 €17,11
GRANIT Flame glow plug 12 V, 12,5 A, thread 7/8" - 14 UNF / 3/8" - 24 UNF
€32,95 €27,23 €31,30 €25,87
You save 5%
GRANIT Silencer vertical 1130 mm, inner-Ø 54 mm, Massey Ferguson
GRANIT
Version: Length: 1130 mm, Inner Ø: 54 mm, Outlet Ø: 45 mm. A: 58 mm. B: 54 mm. C: 100 mm. D: 42 mm. E: 65 mm. F: 590 mm. G: 455 mm. More
Version: Length: 1130 mm, Inner Ø: 54 mm, Outlet Ø: 45 mm. A: 58 mm....
€81,57 €67,41 €77,45 €64,01
You save 5%
GRANIT Glow plug 12 V, 18 A, thread 7/8 inch - 14 UNF Massey Ferguson
GRANIT
Version: 12 V, 18 A, thread 7/8" - 14 UNF. Menke no.: 70723. More
Version: 12 V, 18 A, thread 7/8" - 14 UNF. Menke no.: 70723.
€33,70 €27,85
GRANIT Counterweight with 4 fixing bolts Landini, Massey Ferguson, Perkins
€504,63 €417,05 €479,35 €396,16
You save 5%
GRANIT Cylinder head bolt 1/2" x 103 mm Massey Ferguson, Perkins
GRANIT
Dimensions: 1/2" x 103 mm. More
Dimensions: 1/2" x 103 mm.
€19,35 €15,99
Connecting rod bearing standard, Ø 63,47 mm Landini, Massey Ferguson
€20,90 €17,27
GRANIT Bolt set additional control unit 4x M8 x 110 Massey Ferguson
GRANIT
Technical data: 4x M8 x 110. More
Technical data: 4x M8 x 110.
€36,90 €30,50
GRANIT Gas strut rear window 210 N, 500 mm, stroke 202 mm, B 255 mm
GRANIT
suitable for: Heckscheibe. Newtons: 210. A: 500 mm. B: 255 mm. C: 8 mm. D: 8 mm. Form: 2. d1: 8 mm. d2: 18 mm. Stroke: 202 mm. To fit: Rear screen. More
suitable for: Heckscheibe. Newtons: 210. A: 500 mm. B: 255 mm. C: 8 mm...
€57,84 €47,80 €54,90 €45,37
You save 5%
Showing 193 - 216 of 253

Massey Ferguson 575 parts for the lift, clutch and seat

If the linkage on your 575 creeps down with the engine off, the cause is usually a seal. This page lists more than 250 replacement parts for the Massey Ferguson 575, made by GRANIT and by brands such as Eaton, Cobo, LUK and GRAMMER.

Sealing the hydraulic lift

For the lift there are sealing rings for the lift cylinder, seals for the lift arm shaft and a gasket for the lift housing block. A lift that sinks under load is losing oil past the piston or the valves. Start with the lift cylinder sealing ring, as it tends to go first. Clean and degrease every face when replacing seals, and do not use gasket sealant where a solid gasket belongs. Sealant that finds its way into the lift housing can later make a valve stick.

Identifying the right part

The type plate confirms a 575 from the 500 series. For the lift and clutch, the reference number on the old part is your safest guide. With a clutch plate, count the splines and measure the hub. With a starter motor, check the number of teeth and the flange size.

Clutch and engine

For the clutch you will find double clutch assemblies, clutch plates, thrust washers and complete clutch kits. There are also starter motors, cooling fans and silencers. Always fit a cooling fan with new lock washers or self-locking nuts, then turn it by hand after fitting to make sure it does not touch the cowl anywhere.

Adjust a double clutch after fitting according to the workshop manual, so that pressing the pedal releases the travel clutch first and the PTO clutch second. If it is set unevenly, the PTO keeps turning or the clutch slips. Always replace the clutch plate together with the double clutch.

Seats and lighting

Long days on a 575 show up in your back. There are seats and tractor seats, including air suspended versions from PROBOSS and Maximo, and plain fabric tractor seats. A new seat only fits properly if its mounting holes line up with the console, so measure the hole spacing on your current seat before choosing. For lighting there are rear lights and headlight inserts.

Other 500 series models

The Massey Ferguson 550 and Massey Ferguson 565 each have a separate page with the parts listed for that model. If you look after more Massey Ferguson tractors, every model is listed under Massey Ferguson parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart