For the Claas Arion 410 we keep it focused with more than 40 matching parts, such as trailer couplings and three-point linkage parts for the Arion series.
On many farms the Arion 410 is the tractor that pulls whatever is in the yard: the livestock trailer, the tipper, the muck spreader. This page lists more than 40 Claas Arion 410 parts from Scharmüller, Walterscheid, ROCKINGER and FEBI. They cover the hitch at the rear, plus a few parts for the linkage and routine servicing.
Not sure which system is fitted to your tractor? Measure the rail width of the frame and the diameter of the locking pin. Those two figures decide which drawbar or insert fits your frame, so compare them with the product description.
A Piton Fix takes a lot of punishment with heavy trailers. Check the pin and the drawbar eye for wear regularly and keep the pin lightly greased. A worn pin creates play, which you feel as knocks when pulling away and braking. Always put the safety catch back after coupling up, even for a short trip across the yard.
For the three-point linkage there is a hydraulic lifting strut. It replaces the manual lift rod so you can adjust implement height from the seat. Keep the quick couplers clean when connecting, because dirt in the coupler goes straight into the hydraulics.
For routine servicing there is a FEBI engine oil filter. Smear the rubber ring of the new filter with a little fresh engine oil and tighten the filter by hand only. Doing it up with a tool makes it hard to remove later and can damage the ring.
The type plate on your tractor gives the model and serial number. For hitch parts, the number on the old frame or drawbar is the best check, and for the filter the number on its housing.
The Arion 410 has several siblings in the Arion range. Each model has its own page with the parts that fit that tractor:
Every other Claas tractor is under Claas parts.