If a Claas Axion 830 is part of your fleet, more than 70 matching parts are listed here, among them trailer couplings and three-point linkage parts.
The Axion 830 spends its working life pulling things, so the parts that take the strain are the ones at the back and the one you sit on. On this page you will find more than 70 parts that fit the Claas Axion 830, from makers such as Scharmüller, Walterscheid, ROCKINGER, GRAMMER and GRANIT.
The rear of the Axion 830 has a rail that takes the hitch insert. Depending on the job you can fit a drawbar, an automatic hitch, a Piton Fix or a ball insert for a ball coupling. Support plates and adapter plates let you mount a different coupling on the same rail, and a screw ball adapter does the same for a ball. For trailed implements with forced steering there are the forced steering parts themselves. Top drawbars and complete drawbar frames complete the set.
Two measurements decide whether a replacement drawbar or Piton Fix will slide into your rail: the rail width and the diameter of the locking pin. Take both from the part you are removing before you order. Many hitch parts also carry a stamped reference number, which makes comparing them with the parts on this page quick. While the old drawbar is out, check the rail guides too. Worn guides will make a new drawbar rattle and wear the locking pin faster.
Air suspension seats eventually leak at the bellows or the small compressor, and you end up bottoming out over every rut. This page has tractor seats for the Axion 830, including a GRAMMER Maximo and an air sprung PROBOSS seat with seat heating. Compare the bolt pattern of your seat base with the new seat before ordering.
If the cab stops cooling while the compressor clutch still engages, the aircon compressor itself is a likely cause. When you change it, fit a new receiver drier at the same time and have the system evacuated before refilling, otherwise moisture will shorten the life of the new compressor.
Every Axion type has its own page with the parts listed for that model only. If you run more than one, these pages save you checking each part twice:
The Axion 920 and Axion 940 belong to the same range. For every other tractor from this maker, start from the overview of all Claas parts.
