Menu
EUR

Massey Ferguson 690 tractor parts & technical data

Electrics playing up, a lamp out or steering that needs attention on the Massey Ferguson 690? More than 200 parts for this 600 Series tractor are listed here.

213 parts found for Massey Ferguson 690
Show:
GRANIT Sealing ring fuel line Ø 10,7 x 6,14 mm, tube-Ø 1/4 inch
GRANIT
Dimensions: Height 6, Outer Ø 10.7, Inner Ø 6.14, For pipe Ø 1/4" mm. More
Dimensions: Height 6, Outer Ø 10.7, Inner Ø 6.14, For pipe Ø 1/4" m
€1,09 €0,90
GRANIT Cylinder head gasket set upper engine 4.212-4.248
€37,03 €30,60 €35,15 €29,05
You save 5%
GRANIT Stop cable A 980 mm, B 890 mm Massey Ferguson 550-590
GRANIT
A: 980 mm. B: 890 mm. More
A: 980 mm. B: 890 mm.
€31,60 €26,12
Crankshaft seal rear Ø 133,5 x 159 x 11 mm
Outer Ø: 159 mm. Width: 11 mm. Inner Ø: 133,5 mm. More
Outer Ø: 159 mm. Width: 11 mm. Inner Ø: 133,5 mm.
€22,70 €18,76
O-ring for piston 70 x 82 x 6 mm Massey Ferguson 100-1004
Dimensions: 70 x 86.5 x 6 mm. More
Dimensions: 70 x 86.5 x 6 mm.
€27,00 €22,31
LUK Clutch kit double plate connection Massey Ferguson 165 - 690, 31 kg
LUK
Contents: Pressure plate 458230001342, clutch plate 458330001346 | Supplementary set: Without release bearing | Connection: For vehicles with double-d... More
Contents: Pressure plate 458230001342, clutch plate 458330001346 | Sup...
€964,98 €797,50 €916,70 €757,60
You save 5%
GRANIT Starter motor with reduction 12 V, 3,2 kW, 10 teeth, 226 mm, Ø 89 mm
€287,67 €237,74 €273,25 €225,83
You save 5%
GRANIT Seal input shaft reversing clutch Ø 28,5 x 38,1 x 6,35 mm
GRANIT
Dimensions: 28,5 x 38,1 x 6,35 mm. Outer Ø: 38.1 mm. Inner Ø: 28,5 mm. Height 1: 6.35 mm. More
Dimensions: 28,5 x 38,1 x 6,35 mm. Outer Ø: 38.1 mm. Inner Ø: 28,5 m...
€4,15 €3,43
Radiator hose, top inner-Ø 38 / 42 mm Massey Ferguson 670-690
€17,70 €14,63
Cylinder head bolt 1/2" x 92 mm Massey Ferguson
Dimensions: 1/2" x 92 mm. More
Dimensions: 1/2" x 92 mm.
€15,20 €12,56
GRANIT Steering pump Massey Ferguson 165-690
€640,69 €529,50 €608,65 €503,02
You save 5%
GRANIT Yoke three-point parts 16-1/4" x 1" UNF Massey Ferguson
GRANIT
Dimensions: 16 1/4" x 1" UNF mm. More
Dimensions: 16 1/4" x 1" UNF mm.
€91,90 €75,95 €87,30 €72,15
You save 5%
Engine oil filter W940/1, LF3401, Ø 93 mm, height 142 mm, 3/4-16 UNF
Showing 193 - 213 of 213

Massey Ferguson 690 parts for engine, clutch and cab

On an older Massey Ferguson 690, repair jobs tend to come in clusters. One weeping seal turns into a weekend with the engine open, and once the tractor is split you may as well sort out the clutch while you are in there. This page gathers more than 200 new replacement parts that fit the 690, from GRANIT alongside makers such as LUK, Eaton, GRAMMER and PROBOSS.

Engine, transmission and linkage

For an engine rebuild there are piston and liner sets, water pump gaskets, sealing rings for the fuel lines and loose O-rings. The oil pressure switch is a small item that deserves attention when the warning light starts acting up, because a faulty switch can raise a false alarm or, worse, stay silent while pressure really drops. Further back you will find thrust washers for the transmission and a seal for the lift arm shaft, a familiar spot for oil to creep out and collect dust.

Clutch work can be done with a single clutch plate or a complete clutch kit. If you are splitting the tractor anyway, the kit is usually the smarter call. The pressure plate and release bearing have done the same hours as the disc, and nobody wants to split a 690 twice in one season. Check the flywheel face before reassembly. Scoring or blue heat marks need machining first, otherwise the new plate will judder or wear early.

Massey Ferguson 690 cab parts

The cab parts here centre on the driver. There are air suspended tractor seats and seat units from GRAMMER and PROBOSS, some with a seat heater, plus gas struts for the rear window. A rear window that no longer stays open is nearly always down to a tired strut. Fit struts as a pair so the window is carried evenly, and mount them rod downwards so the internal seal stays lubricated and lasts longer.

Matching the right part to your tractor

The 690 belongs to the Massey Ferguson 600 series, but never assume that a part from a neighbouring model is identical. Start with the type plate, which gives the exact model and serial number. Then look at the old part, since seals, gaskets and washers often carry a reference number that is stamped or printed on them. Compare that number with the product description before you order parts online. For sealing rings and O-rings, measuring the old one before it goes in the bin can save you a second order.

Other tractors from the same series have pages of their own:

Every other model from the brand is listed under Massey Ferguson parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart