Menu
EUR

Steyr 545 tractor parts & technical data

Searching for Steyr 545 parts from the Plus series? This page gathers more than 60 items that fit this type, so there is no guesswork involved.

70 parts found for Steyr 545
Show:
Bosch/Rexroth Hydraulic pump anticlockwise 8 cm³/rpm., taper 1:5, Ø 17 x 17
8%
Bosch/Rexroth
Hydraulic pump anticlockwise 8 cm³/rpm., taper 1:5, Ø 17 x 17
Output volume: 8 cc/rev. Drive shaft: Taper 1:5, Ø 17 x 17. Operating pressure m...
€550,76 €455,17 €506,70 €418,76
 
Pin Ø 25 mm Steyr Series 80-8075, Series M 900, M 968-975
8%
Pin Ø 25 mm Steyr Series 80-8075, Series M 900, M 968-975
Dimensions: Ø: 25 mm.
€49,94 €41,27 €45,94 €37,97
 
Gasket exhaust Steyr 430-768
Gasket exhaust Steyr 430-768
To fit as: Steyr 430, 540, 545, 548, 650, 658, 760, 768
€4,15 €3,43
 
MANN-FILTER Fuel filter WK842
MANN-FILTER
Fuel filter WK842
€18,79 €15,53
 
Outlet valve Steyr engine WD 308, WD 311, WD 408, WD 611
8%
Outlet valve Steyr engine WD 308, WD 311, WD 408, WD 611
€37,00 €30,58 €34,04 €28,13
 
Inlet valve engine WD 308 - WD 611 Steyr
8%
Inlet valve engine WD 308 - WD 611 Steyr
€40,83 €33,74 €37,56 €31,04
 
Thrust washer set Steyr Plus 40-768, 942, 948, 8045
8%
Thrust washer set Steyr Plus 40-768, 942, 948, 8045
€55,92 €46,21 €51,45 €42,52
 
Piston ring set 4 clamp, Ø 100 mm, 2,5 / 2,5 / 2,5 / 4 mm Steyr
8%
Piston ring set 4 clamp, Ø 100 mm, 2,5 / 2,5 / 2,5 / 4 mm Steyr
Dimensions: 4 rings, Ø 100 mm, 2.5 mm (trapezoidal ring) / 2.5 mm / 2.5 mm / 4 m...
€68,76 €56,83 €63,26 €52,28
 
Gasket set engine WD 308 Steyr 545 Plus, 548 Plus
8%
Gasket set engine WD 308 Steyr 545 Plus, 548 Plus
€226,97 €187,58 €208,81 €172,57
 
Bolt set 3de steering valve 3x M8 x 230 Fendt, Case IH, Steyr, Schlüter
8%
Bolt set 3de steering valve 3x M8 x 230 Fendt, Case IH, Steyr, Schlüter
Technical data: 3x M8 x 230.
€56,60 €46,78 €52,07 €43,03
 
Bolt set 4de steering valve 3x M8 x 280
8%
Bolt set 4de steering valve 3x M8 x 280
Technical data: 3x M8 x 280.
€67,87 €56,09 €62,44 €51,60
 
Single hydraulic pump 8,2 cm³/rpm., taper 1:5, Ø 17 x 17, left
8%
Single hydraulic pump 8,2 cm³/rpm., taper 1:5, Ø 17 x 17, left
Output volume: 8,2 cc/rev. Drive shaft: Taper 1:5, Ø 17 x 17. Direction of rotat...
€455,31 €376,29 €418,89 €346,19
 
Joint spindle 190 mm, ball-Ø 28,5/34,25 mm, M30 x 3 Steyr
Joint spindle 190 mm, ball-Ø 28,5/34,25 mm, M30 x 3 Steyr
Dimensions: Length = 190, Ball Ø = 28.5/34.25, M30 x 3 mm.
€21,63 €17,87
 
Silencer vertical 1070 mm, Ø 55 mm Steyr 430-768
8%
Silencer vertical 1070 mm, Ø 55 mm Steyr 430-768
To fit as: Steyr 430, 540, 545, 548, 650, 658, 760, 768
€160,80 €132,89 €147,94 €122,26
 
KS Piston ring set 3 rings Ø 100 mm, 2,5 / 2,5 / 4 mm Steyr 540-760
8%
KS
Piston ring set 3 rings Ø 100 mm, 2,5 / 2,5 / 4 mm Steyr 540-760
Dimensions: 3 rings, Ø 100 mm, 2.5 mm / 2.5 mm / 4 mm.
€53,84 €44,50 €49,53 €40,94
 
Cylinder head gasket set upper engine WD 308 Steyr 545 Plus, 548 Plus
8%
Cylinder head gasket set upper engine WD 308 Steyr 545 Plus, 548 Plus
€259,14 €214,17 €238,41 €197,03
 
Connecting rod bearing standard Steyr engine WD 306 - WD 408
8%
Connecting rod bearing standard Steyr engine WD 306 - WD 408
€57,50 €47,52 €52,90 €43,72
 
Lifting spindle right 420 - 520 mm, Ø 24,5 mm Steyr
8%
Lifting spindle right 420 - 520 mm, Ø 24,5 mm Steyr
Dimensions: Length = 420 - 520, Clevis inside = 40, Clevis outside = 71, Ø = 24....
€225,25 €186,16 €207,23 €171,26
 
Showing 49 - 70 of 70

Steyr 545 parts

A Steyr 545 that smokes, uses oil or is hard to start is often heading for an engine rebuild. This page lists more than 60 parts that fit the 545, and a good share of them are for that engine. Alongside GRANIT you will find makers such as MAHLE, MANN-FILTER, Bosch/Rexroth and GRAMMER.

Engine rebuild parts

For a rebuild there are MAHLE piston ring sets, inlet valves, valve cover gaskets and seal kits. Before fitting new piston rings, push each ring squarely into its bore and measure the end gap with a feeler gauge. Fit the rings with the marking facing up and stagger the gaps so they never line up. A new inlet valve should be lapped into its seat before the cylinder head goes back on.

On a rebuild, renew the valve cover gasket and every seal you disturb along the way. An old gasket that has already been compressed rarely seals properly a second time, and oil leaking from the top of the engine runs down the block and makes it hard to trace any other leak. Change the fuel filter at the same time so the rebuilt engine starts on clean fuel.

Other parts for the 545

  • Fuel filters from MANN-FILTER, vertical silencers and exhaust gaskets.
  • Radiator hoses, including the bottom hose to the radiator.
  • Clutch plates and thrust bearings.
  • Bosch/Rexroth hydraulic pumps and bolt sets for the steering valve.
  • Alternators, window rubbers and pins for pivot points.

A tip for the cooling system: squeeze each hose with the engine cold. If it feels hard, or soft and spongy, or you can see fine cracks near the clamps, replace it even if it is not leaking yet. A hose that bursts halfway through mowing costs far more than the hose itself, and it is worth fitting new clamps rather than reusing the old ones.

Type plate, reference numbers and the Plus range

Check the type plate and keep the old part alongside. A reference number on a filter, piston ring or hydraulic pump is more reliable than comparing photos. With piston ring sets, look at the diameter and width of each ring. With a hydraulic pump, check direction of rotation and the connections.

The 545 is part of the Steyr Plus range. The Steyr 540, Steyr 650, Steyr 760 and Steyr 870 each have a page of their own with the parts that fit that particular model, handy when more than one Steyr works on the farm. Every other Steyr tractor can be found under Steyr parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison
This product has been added to your cart