Menu
EUR

Steyr 760 tractor parts & technical data

For the Steyr 760 of the Plus series this page gathers more than 80 matching parts, electrics among them, so you no longer have to guess.

88 parts found for Steyr 760
Show:
Water pump double pulley Ø 110/137 mm, fastening 4 x M8 and 4 x M10
5%
Water pump double pulley Ø 110/137 mm, fastening 4 x M8 and 4 x M10
€254,54 €210,36 €241,80 €199,83
 
GRANIT V-belt Steyr 650-760 Plus
GRANIT
V-belt Steyr 650-760 Plus
€24,25 €20,04
 
Radiator filler cap Ø 67 mm, height 20 mm
5%
Radiator filler cap Ø 67 mm, height 20 mm
Neck Ø: 67 mm. Height: 20 mm.
€60,03 €49,61 €57,00 €47,11
 
Crankshaft 4-cylinder Steyr 760, 760A
5%
Crankshaft 4-cylinder Steyr 760, 760A
Notes: Please follow the installation instructions. Then fill in the test report...
€862,55 €712,85 €819,40 €677,19
 
GRANIT Inlet valve engine WD 308 - WD 611 Steyr
5%
GRANIT
Inlet valve engine WD 308 - WD 611 Steyr
€39,13 €32,34 €37,15 €30,70
 
GRANIT Cylinder head gasket Steyr 650, 658, 760, 768
5%
GRANIT
Cylinder head gasket Steyr 650, 658, 760, 768
€91,46 €75,59 €86,85 €71,78
 
GRANIT Linkage Steyr 99001, Series 80-8170
5%
GRANIT
Linkage Steyr 99001, Series 80-8170
Technical data: can be used in 80 series.
€174,81 €144,47 €166,00 €137,19
 
Bosch/Rexroth Hydraulic pump anticlockwise 8 cm³/rpm., taper 1:5, Ø 17 x 17
5%
Bosch/Rexroth
Hydraulic pump anticlockwise 8 cm³/rpm., taper 1:5, Ø 17 x 17
Output volume: 8 cc/rev. Drive shaft: Taper 1:5, Ø 17 x 17. Operating pressure m...
€527,80 €436,20 €501,40 €414,38
 
Pin Ø 25 mm Steyr Series 80-8075, Series M 900, M 968-975
10%
Pin Ø 25 mm Steyr Series 80-8075, Series M 900, M 968-975
Dimensions: Ø: 25 mm.
€50,25 €41,53 €45,45 €37,56
 
GRANIT Silencer vertical 1070 mm, Ø 55 mm, exhaust Ø 43 mm Steyr
5%
GRANIT
Silencer vertical 1070 mm, Ø 55 mm, exhaust Ø 43 mm Steyr
Version: Length: 1070 mm, Inner Ø: 55 mm, Outlet Ø: 43 mm. Dimensions: Length: 1...
€154,09 €127,35 €146,35 €120,95
 
Single hydraulic pump 8,2 cm³/rpm., taper 1:5, Ø 17 x 17, left
5%
Single hydraulic pump 8,2 cm³/rpm., taper 1:5, Ø 17 x 17, left
Output volume: 8,2 cc/rev. Drive shaft: Taper 1:5, Ø 17 x 17. Direction of rotat...
€436,33 €360,60 €414,50 €342,56
 
GRANIT Gasket exhaust Steyr 430-768
GRANIT
Gasket exhaust Steyr 430-768
To fit as: Steyr 430, 540, 545, 548, 650, 658, 760, 768
€3,98 €3,29
 
GRANIT Single hydraulic pump 16,8 cm³/rpm., taper 1:5, Ø 17 x 17, left
5%
GRANIT
Single hydraulic pump 16,8 cm³/rpm., taper 1:5, Ø 17 x 17, left
Output volume: 16,8 cc/rev. Drive shaft: Taper 1:5, Ø 17 x 17. Direction of rota...
€469,72 €388,20 €446,20 €368,76
 
Showing 73 - 88 of 88

Steyr 760 parts for engine overhaul, hydraulics and clutch

The Steyr 760 from the Plus range is the kind of tractor people keep for decades, provided the wear parts are replaced in time. This page brings together more than 80 parts that fit the 760, from GRANIT, Bosch/Rexroth, MAHLE, LUK and GRAMMER.

Clutch and engine

When the drive clutch slips, you will find clutch plates and a thrust bearing here. A good habit when the tractor is split anyway: replace the thrust bearing together with the plate. A bearing that still turns quietly but has some play rarely lasts long, and splitting the tractor twice costs far more than the bearing. Check the flywheel face as well, since scoring or blue heat marks mean it needs machining before the new plate goes in.

For an engine that burns oil or smokes blue, MAHLE piston ring sets are available for a rebuild. The cooling system is covered with a thermostat and radiator hoses, and the exhaust with a vertical silencer and gasket.

Hydraulics, electrics and cab

Hydraulic pumps, including single pumps from Bosch/Rexroth, keep the linkage and steering working. Always match the direction of rotation and the shaft taper, because a left hand pump will not deliver oil where a right hand one belongs. A bolt set for the control valve is also listed. For the electrics there is a starter motor and an alternator, and new window rubber keeps the cab dry. Ball joints and pins take the slack out of the steering and the linkage.

Finding the right part for your 760

Check the serial plate first to confirm you are working on a Steyr 760. The old part is the next best source: pumps, starters and alternators usually carry a reference number you can compare with the new part. On a clutch plate, count the splines and measure the hub bore.

If you fit new piston rings yourself, stagger the ring gaps around the piston so they do not line up, and install each ring with its marking facing up. Check the end gap of every ring in its bore first. During the first hours, vary the load rather than letting the engine idle for long, so the rings bed in properly.

Related Steyr models

Other tractors from the same range have their own pages with the parts that fit them:

The full selection for the brand is under Steyr parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart