Menu
EUR

Steyr 9125 tractor parts & technical data

Need parts for a Steyr 9125 from the 9100 series? Choose from more than 300 items, such as trailer couplings, lighting, and steering and front axle parts.

331 parts found for Steyr 9125
Show:
Joint pin 127 mm, Ø 55 mm, Ø 40 mm, M27 x 1,5, M22 x 1,5
5%
Joint pin 127 mm, Ø 55 mm, Ø 40 mm, M27 x 1,5, M22 x 1,5
A: 127 mm. C: M22 x 1,5 mm. D: M27 x 1,5 mm. Ø B: 55 mm. Ø E: 40 mm.
€94,03 €77,71 €89,30 €73,80
 
GRANIT Ball joint 280 mm, taper 24 - 27 mm, M20 x 1,5 / M24 x 1,5
5%
GRANIT
Ball joint 280 mm, taper 24 - 27 mm, M20 x 1,5 / M24 x 1,5
A: 280 mm. C: M20 x 1,5 mm. D: M24 x 1,5 mm. E: 24 mm. F: 27 mm. Taper: 24 - 27 ...
€197,75 €163,43 €187,85 €155,25
 
Plate foot brake Ø 150 x 228 mm, steel Case IH, Steyr
5%
Plate foot brake Ø 150 x 228 mm, steel Case IH, Steyr
€33,64 €27,80 €31,95 €26,41
 
Front cover gasket Case IH, New Holland, Steyr
5%
Front cover gasket Case IH, New Holland, Steyr
€109,05 €90,12 €103,55 €85,58
 
GRANIT Oil cooler Case IH CS 100 - CS 150, Steyr 9105-9145
5%
GRANIT
Oil cooler Case IH CS 100 - CS 150, Steyr 9105-9145
€3.057,59 €2.526,93 €2.904,70 €2.400,58
 
Exhaust manifold Case IH, Steyr
Exhaust manifold Case IH, Steyr
€1.282,00 €1.059,50
 
Clamp New Holland, Steyr, Case IH
5%
Clamp New Holland, Steyr, Case IH
€55,91 €46,21 €53,10 €43,88
 
Thermostat gasket Case IH, Steyr
Thermostat gasket Case IH, Steyr
€9,75 €8,06
 
Thermostat gasket Case IH, Steyr
Thermostat gasket Case IH, Steyr
€12,60 €10,41
 
Optibelt V-belt Deutz-Fahr DX 3.10SC-3.80SC
Optibelt
V-belt Deutz-Fahr DX 3.10SC-3.80SC
€20,10 €16,61
 
Feed pump 5 hole, hole spacing 25/37 and 45 mm, flange 52 mm
5%
Feed pump 5 hole, hole spacing 25/37 and 45 mm, flange 52 mm
Version: 5 holes, Vertical hole spacing: 25/37 mm, Horizontal hole spacing: 45 m...
€42,99 €35,53 €40,80 €33,72
 
GRANIT Valve seat outlet valve engine Sisu 320, 420, 620
5%
GRANIT
Valve seat outlet valve engine Sisu 320, 420, 620
€72,75 €60,12 €69,10 €57,11
 
Piston ring set 3 rings Ø 108 mm, 3 mm trapezoidal ring / 3 mm / 4 mm
5%
Piston ring set 3 rings Ø 108 mm, 3 mm trapezoidal ring / 3 mm / 4 mm
Dimensions: 3 rings, Ø 108 mm, 3 mm (trapezoidal ring) / 3 mm / 4 mm.
€46,69 €38,59 €44,35 €36,65
 
GRANIT Hand throttle cable A 3400 mm, B 3115 mm Case IH, Steyr
5%
GRANIT
Hand throttle cable A 3400 mm, B 3115 mm Case IH, Steyr
A: 3400 mm. B: 3115 mm.
€91,27 €75,43 €86,70 €71,65
 
Intake manifold gasket Massey Ferguson, Case IH, Steyr, New Holland
5%
Intake manifold gasket Massey Ferguson, Case IH, Steyr, New Holland
€52,11 €43,07 €49,50 €40,91
 
GRANIT Cylinder head gasket engine Sisu
5%
GRANIT
Cylinder head gasket engine Sisu
€79,42 €65,64 €75,40 €62,31
 
Bolt set 4de steering valve 3x M8 x 220 Steyr
5%
Bolt set 4de steering valve 3x M8 x 220 Steyr
Technical data: 3x M8 x 220.
€49,37 €40,80 €46,90 €38,76
 
Bolt set 2de steering valve 3x M8 x 180
Bolt set 2de steering valve 3x M8 x 180
Technical data: 3x M8 x 180. Menke no.: 51682. Description: For 3rd Control unit...
€27,90 €23,06
 
Showing 145 - 168 of 331

Steyr 9125 parts from belt drive to drawbar

There are more than 300 Steyr 9125 parts on this page, made by GRANIT and by brands such as Scharmüller, HELLA, MAHLE and GRAMMER. They run from the belts at the front of the engine to the hitch at the back.

The 9125 often works with heavy trailers and front loaders. That puts extra strain on the steering, the linkage and the electrical controls, which is where many of the parts on this page come in.

Engine front and charging

V-belts, including one for the air conditioning, and alternators with a fixed flange and pulley sit at the front of the engine. There is a gasket for the water pump and a seal for the fuel feed pump. A V-belt that squeals when you pull away or switch on the aircon is usually too slack or glazed on its flanks. Fit a new one, then check the tension again after a few hours of work, because a fresh belt stretches a little at first.

Hitch, steering and seals

For the rear there are drawbars with a K80 ball on a rail and adapter plates. Ball joints and bushes cover the steering and linkage, while O-rings and sealing rings keep oil and coolant where they belong, for example a sealing ring that is used on Case IH and Steyr tractors.

Switches, lights and cab

The cab of the 9125 has plenty of switches that wear over time. You will find push buttons, such as the yellow one for lifting and lowering, and rocker switches in the dashboard, for instance for the front work lights. Work lamps are here too, among them a corner light with a flood beam. A tractor seat and gas struts for the hood complete the list. If a switch only works when you press harder, check the connector behind it before replacing the switch. Contact spray often does the job.

Making sure it fits

Check the type plate to confirm the machine is a 9125. If you still have the old part, look for a reference number on it. With gaskets and sealing rings that look alike, that number is often the only reliable way to tell them apart. Within the Steyr range, the 9125 is part of the 9100 line. The other types in that series each have their own page: Steyr 9105, Steyr 9115 and Steyr 9145. To browse every tractor of the make, go to Steyr parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart