Menu
EUR

Massey Ferguson 6616 tractor parts & technical data

Looking for Massey Ferguson 6616 parts? This page brings together more than 250 items, including trailer couplings, electrics and lighting for the 6600 series.

287 parts found for Massey Ferguson 6616
Show:
Gas strut roof window 300 N, 215 mm, stroke 70 mm Massey Ferguson
suitable for: Dachluke. Newtons: 300. A: 215 mm. B: 110 mm. C: 6 mm. D: 8 mm. Form: 8. d1: 8 mm. d2: 18 mm. Stroke: 70 mm. To fit: Roof hatch. More
suitable for: Dachluke. Newtons: 300. A: 215 mm. B: 110 mm. C: 6 mm. D...
€69,68 €57,59 €66,15 €54,67
You save 5%
GRANIT Mirror 330 x 240 mm, heated, rod-Ø 16 - 22 mm Massey Ferguson
GRANIT
Dimensions: 330 x 240 mm. Height: 330 mm. Width: 240 mm. Version: Heated. Notes: Electric adjustment. Rod Ø: 16 - 22 mm. More
Dimensions: 330 x 240 mm. Height: 330 mm. Width: 240 mm. Version: Heat...
€211,28 €174,61 €191,15 €157,98
You save 10%
HELLA Work lamp flood beam H3, 55 W, 12 V, 160 x 100 x 78 mm
HELLA
Bulb: H3. Connection: AMP plug. Form: Oval. Material: Housing: plastic, lens: glass. Dimensions W x H x D: 160 x 100 x 78 mm. Protection class: IP5K4K... More
Bulb: H3. Connection: AMP plug. Form: Oval. Material: Housing: plastic...
€82,55 €68,22
GRANIT Seal kit hydraulic pump 3716370M91 Massey Ferguson 5445 - 6497
€61,54 €50,86 €58,45 €48,31
You save 5%
Retaining ring PTO shaft end piece Massey Ferguson, Valtra
€149,14 €123,26 €141,65 €117,07
You save 5%
GRANIT Crankshaft seal for Ø 65 x 90 x 10 mm Fendt, Massey Ferguson
GRANIT
Outer Ø: 90 mm. Width: 10 mm. Inner Ø: 65 mm. More
Outer Ø: 90 mm. Width: 10 mm. Inner Ø: 65 mm.
€67,20 €55,54 €63,80 €52,73
You save 5%
Handle for roof hatch Massey Ferguson Series 600-8400
€88,69 €73,30 €84,25 €69,63
You save 5%
GRANIT Clevis Massey Ferguson 6485-8480
€382,70 €316,28
GRANIT Lift arm shaft Massey Ferguson 5400-6600
€535,00 €442,15 €508,25 €420,04
You save 5%
Mirror glass heated right / left 310 x 223 mm, 12 V
Dimensions: 310 x 223 mm. Version: Can be heated. Installation location: Right/left. Volts: 12. Radius of curvature: 2000 mm. More
Dimensions: 310 x 223 mm. Version: Can be heated. Installation locatio...
€120,70 €99,75 €109,20 €90,25
You save 10%
GRANIT Pin three-point parts Massey Ferguson 3050-3125, 6110-6290
€33,00 €27,27 €31,35 €25,91
You save 5%
GRANIT Temperature sensor for common rail systems Sisu-engines
GRANIT
Version: For common rail systems, to fit Sisu engines. More
Version: For common rail systems, to fit Sisu engines.
€175,14 €144,74 €158,45 €130,95
You save 10%
Showing 265 - 287 of 287

Massey Ferguson 6616 parts for the driveline, hitch and cab

When the four wheel drive clutch on a 6616 starts to slip, or the dash flags a fault on a speed sensor, the parts you need sit deep inside the tractor. More than 250 replacement parts fit this Massey Ferguson, from clutch plates to work lamps, with makers such as GRANIT, Scharmüller, Walterscheid, HELLA and DANA Spicer.

Inside the driveline

For the 4WD clutch there are external and internal plates. Alongside them you will find inductive sensors, such as the one for transmission speed, and temperature sensors. Then there are O-rings, including ones for the PTO, sealing rings, adjusting plates and seals, right down to the seal on the cab door handle.

If you are rebuilding a plate pack, soak the new friction plates in the same oil the transmission runs on before you assemble them. Plates fitted dry tend to judder or glaze in the first hours. Look at the steel plates too. Blue heat marks or warping tell you how hot the pack has been running and whether the steels should be renewed at the same time.

A fault code from an inductive sensor does not always mean the sensor has failed. Metal fines on the tip are enough to upset the signal. Wipe it clean and check the plug for green corrosion before ordering a new one. If the fault stays, replacement is the next step.

Hitching and hydraulics at the rear

At the back there are ball drawbars, drawbar frames and adapter plates. If you pull a trailer with forced steering, inner parts and other components for that system are on this page as well. A hydraulic top link from Walterscheid lets you adjust heavy implements without climbing down from the seat.

For the cab there are work lamps from HELLA and GRANIT, welcome once autumn shortens the days, plus control knobs.

Choosing the right part for a 6616

The rating plate confirms you are working on a 6616. Stick to that model, because each tractor in the 6600 series has a page of its own. With plates, sensors and sealing rings, the safest route is the number on the old component. Compare it with the parts on this page before ordering, and with clutch plates check whether the teeth sit on the inside or the outside.

Running more than one tractor from this series? Each has its own page:

Older or other Massey Ferguson tractors are covered on Massey Ferguson parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart