Menu
EUR

Steyr 9115 tractor parts & technical data

Steyr 9115 in the workshop? Pick from more than 300 parts for the 9100 series, such as trailer couplings, lighting and parts for the front axle steering.

333 parts found for Steyr 9115
Show:
FEBI Fuel filter Ø 84 mm, inner-Ø 19 mm
€14,06 €11,62 €6,38 €5,27
You save 55%
FEBI Alternator 14 V / 95 A, form B, flange 50,8 mm
FEBI
To fit as: Case IH, McCormick, Steyr More
To fit as: Case IH, McCormick, Steyr
€399,30 €330,00 €141,74 €117,14
You save 65%
GRANIT Seal PU 55 x 70 x 7 mm
€12,45 €10,29
GRANIT Sealing ring 115 x 154 x 5,5 mm Ford, Case IH, Steyr, New Holland
€38,18 €31,55 €36,25 €29,96
You save 5%
Disc steering cylinder and housing Carraro front axle 145706
€39,87 €32,95 €37,85 €31,28
You save 5%
Joint pin 127 mm, Ø 55 mm, Ø 40 mm, M27 x 1,5, M22 x 1,5
A: 127 mm. C: M22 x 1,5 mm. D: M27 x 1,5 mm. Ø B: 55 mm. Ø E: 40 mm. More
A: 127 mm. C: M22 x 1,5 mm. D: M27 x 1,5 mm. Ø B: 55 mm. Ø E: 40 mm.
€94,03 €77,71 €89,30 €73,80
You save 5%
Plate foot brake Ø 150 x 228 mm, steel Case IH, Steyr
€33,64 €27,80 €31,95 €26,41
You save 5%
Scharmüller Adapter plate rail width 335 mm, hole pattern 140 x 80 mm, M20
Scharmüller
Load capacity: 3000 kg. D-value: 89,3 kN. Rail width: 335 mm. Hole pattern: 140 x 80 mm. Guide width: 30 mm. Plate height: 150 mm. Thread: M20. Colour... More
Load capacity: 3000 kg. D-value: 89,3 kN. Rail width: 335 mm. Hole pat...
€664,77 €549,40 €587,90 €485,87
You save 12%
GRANIT Oil cooler Case IH CS 100 - CS 150, Steyr 9105-9145
€3.057,59 €2.526,93 €2.904,70 €2.400,58
You save 5%
GRANIT Flame glow plug 12 V, 12,5 A, thread 7/8" - 3/8" UNF Steyr, Case IH
GRANIT
Version: 12 V, 12.5 A, thread 7/8" - 3/8" UNF. More
Version: 12 V, 12.5 A, thread 7/8" - 3/8" UNF.
€33,26 €27,49 €31,55 €26,07
You save 5%
Exhaust manifold Case IH, Steyr
Clamp New Holland, Steyr, Case IH
€55,91 €46,21 €53,10 €43,88
You save 5%
Optibelt V-belt Deutz-Fahr DX 3.10SC-3.80SC
Feed pump 5 hole, hole spacing 25/37 and 45 mm, flange 52 mm
Version: 5 holes, Vertical hole spacing: 25/37 mm, Horizontal hole spacing: 45 mm, Flange to lever end: 52 mm. Menke no.: 209000. More
Version: 5 holes, Vertical hole spacing: 25/37 mm, Horizontal hole spa...
€42,99 €35,53 €40,80 €33,72
You save 5%
GRANIT Valve seat outlet valve engine Sisu 320, 420, 620
€72,75 €60,12 €69,10 €57,11
You save 5%
Piston ring set 3 rings Ø 108 mm, 3 mm trapezoidal ring / 3 mm / 4 mm
Dimensions: 3 rings, Ø 108 mm, 3 mm (trapezoidal ring) / 3 mm / 4 mm. More
Dimensions: 3 rings, Ø 108 mm, 3 mm (trapezoidal ring) / 3 mm / 4 mm.
€46,69 €38,59 €44,35 €36,65
You save 5%
Showing 145 - 168 of 333

Steyr 9115 parts for engine, electrics and hitch

On this page you will find more than 300 replacement parts that fit the Steyr 9115, supplied by GRANIT, Scharmüller, HELLA, MAHLE, GRAMMER and others. The list runs from small seals to a complete tractor seat.

Charging and switches

When the battery stops charging properly, the alternator is the first thing to suspect. Alternators for this type are here, along with V-belts. For the dashboard there are push button switches, for example for raising and lowering the linkage, and rocker switches such as the one for the front work lights. The work lights themselves are available too, including corner lamps with a flood beam.

A useful tip after fitting a new alternator: check the belt tension. A loose belt slips, squeals on a cold start and leaves the battery undercharged. A belt that is too tight puts extra load on the bearings of both the alternator and the water pump.

Engine seals, hood and seat

Around the engine there are water pump gaskets, seals and O-rings for the feed pump, and sealing rings. A drip under the tractor often comes from one of these small items rather than from the pump itself, so they are worth checking first. Gas struts for the hood are also listed. Fit them with the rod pointing down where possible, which keeps the internal seal lubricated.

For the driver there is a GRAMMER tractor seat, and at the rear you will find drawbars with a ball, automatic hitches, adapter plates and bushes.

At the rear, keep an eye on the jaw and pin of the automatic hitch. A worn pin gives a knock every time you pull away or brake, and that shock travels through the whole rear end. Check the drawbar eye on the trailer at the same time, since a new pin in a worn eye achieves little. On the ball hitch, a thin film of grease and a clean catch make sure it locks every time.

Matching parts to your 9115

Start with the type plate to confirm the tractor is a 9115. Then use the old part: many components carry a stamped or printed reference number that you can match against the parts on this page. With switches, also compare the symbol and the colour.

Steyr places this tractor in its 9100 line. These models from the same series have their own page:

For every other model of the brand, go to the Steyr parts overview.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart