Menu
EUR

Steyr 9115 tractor parts & technical data

Steyr 9115 in the workshop? Pick from more than 300 parts for the 9100 series, such as trailer couplings, lighting and parts for the front axle steering.

333 parts found for Steyr 9115
Show:
FEBI Fuel filter Ø 84 mm, inner-Ø 19 mm
55%
FEBI
Fuel filter Ø 84 mm, inner-Ø 19 mm
€14,06 €11,62 €6,38 €5,27
 
FEBI Alternator 14 V / 95 A, form B, flange 50,8 mm
65%
FEBI
Alternator 14 V / 95 A, form B, flange 50,8 mm
To fit as: Case IH, McCormick, Steyr
€399,30 €330,00 €141,74 €117,14
 
GRANIT Seal PU 55 x 70 x 7 mm
GRANIT
Seal PU 55 x 70 x 7 mm
€12,45 €10,29
 
GRANIT Sealing ring 115 x 154 x 5,5 mm Ford, Case IH, Steyr, New Holland
5%
GRANIT
Sealing ring 115 x 154 x 5,5 mm Ford, Case IH, Steyr, New Holland
€38,18 €31,55 €36,25 €29,96
 
Disc steering cylinder and housing Carraro front axle 145706
5%
Disc steering cylinder and housing Carraro front axle 145706
€39,87 €32,95 €37,85 €31,28
 
GRANIT O-ring lower arm Carraro front axle 145706
GRANIT
O-ring lower arm Carraro front axle 145706
€2,84 €2,35
 
Joint pin 127 mm, Ø 55 mm, Ø 40 mm, M27 x 1,5, M22 x 1,5
5%
Joint pin 127 mm, Ø 55 mm, Ø 40 mm, M27 x 1,5, M22 x 1,5
A: 127 mm. C: M22 x 1,5 mm. D: M27 x 1,5 mm. Ø B: 55 mm. Ø E: 40 mm.
€94,03 €77,71 €89,30 €73,80
 
Plate foot brake Ø 150 x 228 mm, steel Case IH, Steyr
5%
Plate foot brake Ø 150 x 228 mm, steel Case IH, Steyr
€33,64 €27,80 €31,95 €26,41
 
GRANIT Clutch pedal return spring 98 mm, Ø 3 mm
GRANIT
Clutch pedal return spring 98 mm, Ø 3 mm
€21,80 €18,02
 
Scharmüller Adapter plate rail width 335 mm, hole pattern 140 x 80 mm, M20
12%
Scharmüller
Adapter plate rail width 335 mm, hole pattern 140 x 80 mm, M20
Load capacity: 3000 kg. D-value: 89,3 kN. Rail width: 335 mm. Hole pattern: 140 ...
€664,77 €549,40 €587,90 €485,87
 
GRANIT Oil cooler Case IH CS 100 - CS 150, Steyr 9105-9145
5%
GRANIT
Oil cooler Case IH CS 100 - CS 150, Steyr 9105-9145
€3.057,59 €2.526,93 €2.904,70 €2.400,58
 
GRANIT Flame glow plug 12 V, 12,5 A, thread 7/8" - 3/8" UNF Steyr, Case IH
5%
GRANIT
Flame glow plug 12 V, 12,5 A, thread 7/8" - 3/8" UNF Steyr, Case IH
Version: 12 V, 12.5 A, thread 7/8" - 3/8" UNF.
€33,26 €27,49 €31,55 €26,07
 
Exhaust manifold Case IH, Steyr
Exhaust manifold Case IH, Steyr
€1.282,00 €1.059,50
 
Clamp New Holland, Steyr, Case IH
5%
Clamp New Holland, Steyr, Case IH
€55,91 €46,21 €53,10 €43,88
 
Thermostat gasket Case IH, Steyr
Thermostat gasket Case IH, Steyr
€9,75 €8,06
 
Thermostat gasket Case IH, Steyr
Thermostat gasket Case IH, Steyr
€12,60 €10,41
 
Optibelt V-belt Deutz-Fahr DX 3.10SC-3.80SC
Optibelt
V-belt Deutz-Fahr DX 3.10SC-3.80SC
€20,10 €16,61
 
Feed pump 5 hole, hole spacing 25/37 and 45 mm, flange 52 mm
5%
Feed pump 5 hole, hole spacing 25/37 and 45 mm, flange 52 mm
Version: 5 holes, Vertical hole spacing: 25/37 mm, Horizontal hole spacing: 45 m...
€42,99 €35,53 €40,80 €33,72
 
GRANIT Valve seat outlet valve engine Sisu 320, 420, 620
5%
GRANIT
Valve seat outlet valve engine Sisu 320, 420, 620
€72,75 €60,12 €69,10 €57,11
 
Piston ring set 3 rings Ø 108 mm, 3 mm trapezoidal ring / 3 mm / 4 mm
5%
Piston ring set 3 rings Ø 108 mm, 3 mm trapezoidal ring / 3 mm / 4 mm
Dimensions: 3 rings, Ø 108 mm, 3 mm (trapezoidal ring) / 3 mm / 4 mm.
€46,69 €38,59 €44,35 €36,65
 
Showing 145 - 168 of 333

Steyr 9115 parts for engine, electrics and hitch

On this page you will find more than 300 replacement parts that fit the Steyr 9115, supplied by GRANIT, Scharmüller, HELLA, MAHLE, GRAMMER and others. The list runs from small seals to a complete tractor seat.

Charging and switches

When the battery stops charging properly, the alternator is the first thing to suspect. Alternators for this type are here, along with V-belts. For the dashboard there are push button switches, for example for raising and lowering the linkage, and rocker switches such as the one for the front work lights. The work lights themselves are available too, including corner lamps with a flood beam.

A useful tip after fitting a new alternator: check the belt tension. A loose belt slips, squeals on a cold start and leaves the battery undercharged. A belt that is too tight puts extra load on the bearings of both the alternator and the water pump.

Engine seals, hood and seat

Around the engine there are water pump gaskets, seals and O-rings for the feed pump, and sealing rings. A drip under the tractor often comes from one of these small items rather than from the pump itself, so they are worth checking first. Gas struts for the hood are also listed. Fit them with the rod pointing down where possible, which keeps the internal seal lubricated.

For the driver there is a GRAMMER tractor seat, and at the rear you will find drawbars with a ball, automatic hitches, adapter plates and bushes.

At the rear, keep an eye on the jaw and pin of the automatic hitch. A worn pin gives a knock every time you pull away or brake, and that shock travels through the whole rear end. Check the drawbar eye on the trailer at the same time, since a new pin in a worn eye achieves little. On the ball hitch, a thin film of grease and a clean catch make sure it locks every time.

Matching parts to your 9115

Start with the type plate to confirm the tractor is a 9115. Then use the old part: many components carry a stamped or printed reference number that you can match against the parts on this page. With switches, also compare the symbol and the colour.

Steyr places this tractor in its 9100 line. These models from the same series have their own page:

For every other model of the brand, go to the Steyr parts overview.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart