This page brings together more than 40 parts for the New Holland TD3.50, such as trailer couplings, brake and transmission parts and steering components.
On a compact tractor like the TD3.50 the clutch tends to be the big job, while the small things such as a lost key or a cracked mirror are the daily annoyances. This page covers both, with more than 40 new parts for the TD3.50 from LUK, SACHS, ROCKINGER, Sauermann and GRANIT.
For the drive clutch there are clutch plates, complete kits for a double plate clutch and thrust bearings, plus a vibration damper for the driveline.
If the tractor is already split, always fit a new thrust bearing along with the plate. The bearing costs little next to the labour of splitting the tractor a second time. Inspect the flywheel while you are in there. Scoring or blue heat marks should be skimmed off before the new plate goes on, otherwise the clutch will judder as you pull away.
The TD3.50 belongs to the New Holland TD3 series. Note the serial number from the tractor's data plate first. For clutch parts the reference number on the old plate is the best guide, and counting the splines on the hub and comparing the diameter confirms that the new plate will slide onto the input shaft.
After fitting a new automatic drawbar, check on the first hookup that the latch closes with a clear click and the pin is fully down. A pin that hangs halfway can let the trailer go on the road.
Small items earn their place here as well. There are replacement keys, rear-view mirrors and direction symbols for the controls, as well as a multifunction switch for forward and reverse. Spacer springs and a radiator round out the list.
If the forward and reverse switch works only now and then, check the plug and the earth connection before replacing it. A green, corroded connector produces exactly the same fault as a failed switch.
When cleaning the radiator with compressed air, blow from the engine side outwards, against the normal airflow. That pushes chaff and dust back out instead of packing it deeper into the fins. Bent fins can be carefully straightened with a fin comb so air can pass freely again.
Parts for every other model from the brand are on the New Holland parts page, which is also a good starting point if you are not sure which model you have.