More than 140 replacement parts that fit the New Holland T8.390 from the T8 series, covering trailer couplings, electrics and engine parts, all on one page.
A New Holland T8.390 spends its working life pulling heavy trailers and large implements, so the hitch hardware at the back takes a real beating. This page lists more than 140 replacement parts that fit this tractor, made by GRANIT and by suppliers such as ROCKINGER, Scharmüller, Walterscheid and Optibelt.
The rear of the T8.390 can be set up in several ways. You will find automatic drawbars, hitch jaws, top drawbars, trailer couplings and drawbar arms, along with the Piton Fix system that lets you swap between a ball and a towing eye in the same rail. Adapter plates allow a different coupling to sit in the existing guide. For trailer air brakes there are connector heads for the supply and control lines.
Before ordering a new drawbar or adapter plate, measure the rail width and the locking pin on the tractor itself. The rail systems look very much alike, yet a small difference means the block will not drop into the guide or the pin will rattle. After fitting, check that the lock engages fully before you hook up a trailer.
Injection lines run from the pump to the injectors and, after years of vibration, can start to weep or crack. When you replace one, cap every open port straight away so no dirt gets into the injection system. The T8.390 page also covers temperature sensors, seal kits, fuel tank caps and air conditioning compressors. Gas struts hold the rear window and cab doors open. Once they weaken, the window drops shut at the first bump, so it pays to replace them as a pair.
Swapping a temperature sensor sounds like a quick job, but on the T8.390 a little preparation pays off. Let the engine cool first and have a drip tray ready, because some coolant always escapes as the old sensor comes out. Fit the new one with a new sealing washer and do not overtighten it, the thread in the block is more delicate than it looks. Top up afterwards and run the engine with the cap off until no more air bubbles rise.
Start with the tractor's type plate. It carries the model and serial number, which you need whenever two versions of a part look identical. The old part usually has a reference number stamped into it or printed on a label. Compare that with the number in the product description. For sensors and seal kits in particular, the number is far more reliable than a photo.
New Holland builds the T8.390 as part of its T8 range of tractors. Each of its siblings has its own page that shows only what has been approved for that tractor: New Holland T8.410, New Holland T8.360 and New Holland T8.330. For everything we carry for the brand, go to New Holland parts.