Trailer couplings, electrics and lighting for the Case IH JXU 115 are gathered here. In total there are more than 180 parts for this model from the JXU series.
A linkage that sinks on its own, a PTO that has stopped responding, a rear light that has gone dark. For the Case IH JXU 115 you will find more than 180 parts on this page, from GRANIT and from Sauermann, ROCKINGER, GRAMMER and Walterscheid.
If the linkage slowly drops with nothing on it, worn piston sealing rings or a tired lift shaft seal are common causes. Both are here. For the PTO there is a sensor with a connecting cable and plug.
Before you replace that sensor, unplug it, check the connector for moisture or green corrosion and measure whether there is voltage on the cable. A corroded plug throws the same fault as a failed sensor. If the plug is clean and the sensor is still dead, put a little contact grease on the pins of the new one.
A Piton Fix tows through a fixed pin that passes through the drawbar eye. Because the pin takes load on every turn, every brake application and every pull, both the pin and the eye wear. Check the pin regularly for oval wear and keep it greased, especially if you spend a lot of time on the road with heavy trailers. If the drawbar eye is worn as well, a new pin alone will not cure the slack. Whatever hitch you use, check how the pin is secured, because a pin that works loose is dangerous. Measure the rail width of the existing bracket before ordering too.
The type plate tells you which model from the JXU range you have. For seals and sensors, the number on the old part is the surest guide. Match that reference number to what the product information lists. With mirrors, lights and springs, make sure you have the correct side.
These models from the JXU and JX ranges have their own pages:
That way you can order for each tractor separately. If other Case IH tractors share the yard with your JXU 115, the brand page Case IH parts covers them.
