Need parts for a Case IH 845, also known as the IHC 845? Find more than 250 here, including lighting, classic tractor parts, brakes and transmission parts.
Plenty of people still call it the IHC 845, while newer paperwork says Case IH 845. It is the same tractor, and the more than 250 parts on this page apply under either name. They are new replacement parts from makers such as GRANIT, LUK, FEBI, HELLA and GRAMMER. A tractor that has put in this many hours needs three things looked after: whatever seals, whatever turns and whatever couples.
If the clutch slips under load, or you hear a whine as soon as you press the pedal, it is time to split the tractor. For that job there are clutch plates with organic lining and release bearings, with LUK among the makers. You will also find bearings for the axles and sealing rings for the lower link shaft, where oil creeps out along the shaft once the ring has worn.
Tip: with the tractor already split, always renew the release bearing together with the clutch plate, even if the old bearing still seems quiet. The bearing is a small part compared with the work of splitting the tractor a second time. While you are there, look at the crankshaft seal on the flywheel side. If the old plate is oily, a new one will soon slip as well.
Around the engine there are gaskets, for example the one under the thermostat housing, and water pumps for when the pump weeps from its tell tale hole or the shaft develops play. O-rings for the feed pump keep air out of the fuel, and crankshaft seals stop oil loss at the front and rear of the block. A cracked exhaust manifold can be replaced, as can the stop cable you use to shut the engine down. Always fit a new manifold with new gaskets and tighten the nuts from the centre outwards so it does not distort.
Play in the steering often comes from worn ball joints. These come in several lengths and thread sizes, so hold the old one against the new one or measure it before you order. There are also gas struts, control knobs and HELLA number plate lights. Small things, but a missing knob or an unlit number plate is noticed straight away at a roadside check.
The type plate gives you the model and serial number of the tractor. The serial number helps with parts that changed during production. The reference number on the part itself, for example on a water pump or a clutch plate, is the surest guide. Compare it with the details shown for the item.
If you run an 845 XL, it has its own page: Case IH 845 XL. Related Case IH tractors each have their own overview with their own parts too, such as the Case IH 553, Case IH 624, Case IH 654 and Case IH 824. Every model of the make is listed under Case IH parts.