Menu
EUR

New Holland T5060 tractor parts & technical data

Own a New Holland T5060 from the T5000 series? Choose from more than 200 matching parts here, such as trailer couplings, electrics and lighting.

231 parts found for New Holland T5060
Show:
FEBI Engine oil filter LF16117
€32,61 €26,95 €20,58 €17,01
You save 37%
Ball joint 888 mm, M16 x 1,5, 23,8 mm, taper 18,2 - 20,5 mm
A: 888 mm. C: M16 x 1,5 mm. D: 23,8 mm. E: 18,2 mm. F: 20,5 mm. Taper: 18,2 - 20,5 mm. More
A: 888 mm. C: M16 x 1,5 mm. D: 23,8 mm. E: 18,2 mm. F: 20,5 mm. Taper:...
€151,63 €125,31 €144,00 €119,01
You save 5%
Master brake cylinder mineral oil piston Ø 38,3 mm Case IH, New Holland
€171,34 €141,60 €162,75 €134,50
You save 5%
GRANIT Gear wheel PTO shaft 540 rpm. New Holland
GRANIT
Version: PTO shaft, 540 rpm. More
Version: PTO shaft, 540 rpm.
€162,62 €134,40 €154,45 €127,64
You save 5%
GRANIT Gear wheel PTO shaft 14 / 57 teeth Fiat, New Holland
GRANIT
Number of teeth: 14/57. More
Number of teeth: 14/57.
€115,68 €95,60 €109,85 €90,79
You save 5%
GRANIT Intermediate gear reversing clutch 28/38 teeth New Holland, Fiat
GRANIT
Number of teeth: 28/38. More
Number of teeth: 28/38.
€299,26 €247,32 €284,25 €234,92
You save 5%
BOSCH Pull magnet 12 V, 3 A New Holland, Case IH
BOSCH
Current: 3 A. Nominal voltage: 12 V. More
Current: 3 A. Nominal voltage: 12 V.
€42,83 €35,40 €37,85 €31,28
You save 12%
GRANIT Piston, complete 3 rings, piston pin Ø 38 x 82 mm, without cylinder liner
GRANIT
Dimensions: 3 rings, Gudgeon pin Ø 38 x 82 mm, Combustion chamber Ø 52.3 mm, Combustion chamber depth 24 mm, Rings 2.8 (trapezoidal ring) / 2.4 mm /... More
Dimensions: 3 rings, Gudgeon pin Ø 38 x 82 mm, Combustion chamber Ø ...
€126,41 €104,47 €120,00 €99,17
You save 5%
GRANIT Water pump with gasket Case IH, Steyr, New Holland
GRANIT
Reference no.: S.68286. More
Reference no.: S.68286.
€93,30 €77,11 €88,60 €73,22
You save 5%
Seal lift arm shaft 28 x 43 x 14 mm Ford, Case IH, Steyr, New Holland
Dimensions: 28 x 43 x 14 mm. More
Dimensions: 28 x 43 x 14 mm.
€25,90 €21,41
GRANIT Sealing ring piston 110 x 114 x 4 mm Fiat, Ford, New Holland
GRANIT
Dimensions: 110 x 114 x 4 mm. More
Dimensions: 110 x 114 x 4 mm.
€17,45 €14,42
Seal kit Hürlimann, Deutz-Fahr, Steyr
Reference no.: 47436943. More
Reference no.: 47436943.
€78,26 €64,68 €74,30 €61,41
You save 5%
Sensor getriebeöl temperature
Version: Sensor for transmission oil temperature. More
Version: Sensor for transmission oil temperature.
€74,78 €61,80 €71,00 €58,68
You save 5%
GRANIT Lamp glass right, left
GRANIT
Installation location: Right, left. More
Installation location: Right, left.
€27,85 €23,02
Cobo Micro relays N/O-contact 12 V / 25 A, 4-pin, 6,3 mm, with holder
Cobo
Version: 12 V / 25 A, With bracket, 4-pin, blade terminal 6.3 mm, With parallel resistor for suppressing inductive interference voltages. More
Version: 12 V / 25 A, With bracket, 4-pin, blade terminal 6.3 mm, With...
€35,15 €29,05
GRANIT Double clutch DuT 310 sintered, 40 x 45 mm, 16 splines
GRANIT
Material specifications: Sintered clutch lining | Additional information: Made in Germany | Dimensions (mm): 40 x 45 16 grooves More
Material specifications: Sintered clutch lining | Additional informati...
€768,97 €635,51 €695,70 €574,96
You save 10%
Showing 169 - 192 of 231

New Holland T5060 parts for clutch, linkage and transmission

Clutch slipping, lift cylinder weeping, or a fault showing on the PTO? This page has more than 200 New Holland T5060 parts that fit this tractor, from GRANIT, ROCKINGER, LUK, Sauermann and Eaton among others.

Doing the clutch properly

For the driving clutch there are thrust bearings, pressure plates and clutch plates, including parts from LUK. The workshop rule: always replace all three together. Splitting the tractor is the bulk of the labour, and an old release bearing that starts to squeal a few months later means starting all over again. While it is open, inspect the flywheel. Scoring or blue patches point to overheating, and the face should be checked before the new plate goes in.

Before ordering clutch parts, write down the reference number on the old plate or pressure plate. That way you are not left with a split tractor waiting for the wrong part.

Linkage, transmission and sensors

For a leaking linkage there are seals for the outer lift cylinder and sealing rings for the piston. Transmission parts include gear wheels, such as a reduction gear, and springs. O-rings for the injection system are listed as well. A PTO shaft sensor with connection cable and plug, plus contact switches, cover the electrical side.

If the PTO throws a fault, look at the sensor plug first. Dirt and moisture in the connector produce exactly the same symptoms as a failed sensor. Clean and dry the contacts and push the plug home firmly. If the warning keeps coming back, the sensor itself is due for replacement.

Cab, lights and hitch

A roof window that will not stay open needs a new gas strut. Tractor seats include an air suspended version with fabric cover. If one slowly sinks during the day, check its air lines and fittings with soapy water before replacing the whole seat. Rear lights are available for the left and right side. At the back you will find automatic drawbars and the Piton Fix system, from ROCKINGER among others.

Making sure it fits

Check the type plate first to confirm you have a T5060. Sensors usually carry a number too, so compare that with the shop before you buy.

The T5060 is part of the T5000 range, and every model in it has its own page. Smaller siblings are the New Holland T5030, the T5040 and the T5050. If you run the heavier model, go to the New Holland T5070. The full brand is under New Holland parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart