A New Holland T8.360 from the T8 series is covered here by more than 140 parts, from steering and front axle components to electrics and trailer couplings.
A T8.360 spends its days pulling heavy implements and loaded trailers, so the rear end takes the punishment. Pins wear oval, the hitch jaw develops play and a latch that once snapped shut starts to hesitate. This page holds more than 140 parts that fit the New Holland T8.360, made by GRANIT and by specialists such as ROCKINGER, Scharmüller, Walterscheid and Optibelt.
You will find automatic drawbars and hitches, top drawbars, flange hitches and trailer couplings, plus Piton Fix hooks for heavy trailers. Adapter plates let you mount a different coupling system on the rail of the drawbar frame, which saves a lot of spanner work if you switch between a tipping trailer and a slurry tanker during the week.
Before ordering, measure the rail width and the diameter of the locking pin on your own tractor. Both differ between frames, and comparing them with the product description is the quickest way to make sure a new hitch slides into the guide first time.
On the engine side there are injection lines, temperature sensors, seal kits and tank caps for the cooling system. When you swap an injection line, keep everything clean and cap any open port straight away, because a single grain of dirt in the high pressure circuit can damage an injector. Never bend a new line to make it fit. Use the line made for that particular cylinder.
Around the cab you can choose gas struts for windows and hoods, aircon compressors and connector heads for the trailer air brake line. Steering cylinders are available too. A leaking steering cylinder usually gives itself away with a damp piston rod that collects dust.
Temperature sensors normally sit in the coolant circuit. Swap them with the engine cold, keep a drip tray underneath and screw the new sensor in quickly so you lose very little coolant. Afterwards, top up and check that the tank cap still seals, because a tired cap lets the system lose pressure.
Start with the rating plate, which shows the exact model and serial number. If you still have the worn part, look for a stamped or printed reference number and compare it with the numbers in the product description. Unsure? Send us that number together with a photo of the part.
Running more than one T8 on the farm? Each model has its own page, so check them one by one: New Holland T8.330, New Holland T8.390 and New Holland T8.410. For every other model from the brand, go to the overview of New Holland parts.
