For the New Holland TD5.75 from the TD5 series you will find more than 160 items here, covering trailer couplings, brakes, transmission and electrics.
A TD5.75 that spends its days on yard work, road haulage and field jobs tends to show wear first in the clutch and at the back end where implements and trailers hang. This page lists more than 160 parts that fit the New Holland TD5.75, including thrust bearings, clutch plates and complete clutch kits, gear wheels and planetary gears, sealing rings for pistons and shafts, drawbars, ball joints and steering cylinders. Brands include GRANIT, LUK, Eaton, ROCKINGER and Walterscheid.
A slipping clutch is rarely cured by a plate alone. If the tractor is already split, replace the thrust bearing and the nearby seals at the same time so you are not opening it up again a season later. Check the flywheel face for scoring or blue heat marks, since a damaged face will glaze a new plate quickly. If the old plate was oily, find the leak before you reassemble, because a weeping crankshaft or input shaft seal is often what killed it. You will find clutch kits for the double plate clutch, single clutch plates and thrust bearings for the driving clutch here.
For hitching there are automatic drawbars for the rail, Piton Fix units with locking pin and hydraulic lifting struts with a clevis at each end. Before ordering a rail drawbar, measure the rail width and pin diameter of the bracket on your tractor. Those two figures decide whether the new part slides into the guide. On the steering side you will find ball joints and steering cylinders. A knock when you turn the wheel on the spot usually means a worn ball joint, so check both ends of the track rod and have the toe reset after fitting.
A gearbox that whines under load or jumps out of a gear is worth opening before the damage spreads. Besides gear wheels there are planetary gears and shafts on this page, including one for the PTO input. Check the bearing seats and thrust faces as well as the teeth, and refill with fresh transmission oil after reassembly so debris from the old failure does not reach the new parts.
The model and serial number are on the type plate, and the reference number stamped or cast into the old part is often the quickest way to compare. For cooling there are radiators and intercoolers, and for the cab there are gas struts. If you also run another model from the TD5 line, use its own page, which only shows parts for that type: New Holland TD5.85 and New Holland TD5.95. Everything for the brand is under New Holland parts.
