Menu
EUR

Case IH 695 XL tractor parts & technical data

Whether you call it Case IH 695 XL or IHC 695 XL, this page has more than 250 fitting parts. Steering and front axle, lighting and electrics lead the range.

261 parts found for Case IH 695 XL
Show:
GRANIT Ball joint 95 mm, M14 x 1,5, 7/8" x 16, taper 15,6 - 18 mm
GRANIT
A: 95 mm. C: M14 x 1,5 mm. D: 7/8" x 16 mm. E: 15,6 mm. F: 18 mm. Taper: 15,6 - 18 mm. More
A: 95 mm. C: M14 x 1,5 mm. D: 7/8" x 16 mm. E: 15,6 mm. F: 18 mm. Tape...
€35,04 €28,96 €33,25 €27,48
You save 5%
Carraro Bearing bush front axle 30 x 34 x 30 mm John Deere, Massey Ferguson, Case IH
Carraro
Outer Ø: 34 mm. Inner Ø: 30 mm. Length: 30 mm. More
Outer Ø: 34 mm. Inner Ø: 30 mm. Length: 30 mm.
€9,15 €7,56
PTO shaft end piece 244,5 mm Case IH
Version: Length 244,5 mm. More
Version: Length 244,5 mm.
€221,49 €183,05 €210,40 €173,88
You save 5%
KS Piston set, complete Ø 100 mm, piston pin Ø 38 mm, depth 24 mm
KS
Dimensions: 3 rings, Ø 100 mm, Gudgeon pin Ø 38 x 82 mm, Combustion chamber Ø 59.5 mm, Combustion chamber depth 24 mm, Ring carrier piston. Descrip... More
Dimensions: 3 rings, Ø 100 mm, Gudgeon pin Ø 38 x 82 mm, Combustion ...
€371,95 €307,40 €353,35 €292,02
You save 5%
GRANIT Vibration damper radiator Case IH
Radiator hose, bottom Ø 50 / 57 mm Case IH 288-995, 3210-4240
€53,89 €44,54 €51,15 €42,27
You save 5%
GRANIT Radiator hose by-pass Ø 50 mm Case IH
GRANIT
Inner Ø: 50 mm. More
Inner Ø: 50 mm.
€27,00 €22,31
Silencer 1145 mm, Ø 60/50 mm Case IH series 85, 95, 200
Version: Length: 1145 mm, Inlet Ø: 60 mm, Outlet Ø: 50 mm. More
Version: Length: 1145 mm, Inlet Ø: 60 mm, Outlet Ø: 50 mm.
€150,91 €124,72 €143,35 €118,47
You save 5%
GRANIT Hand throttle cable A 1440 mm, B 1190 mm Case IH 3210-4240, 485 XL - 995 XL
€78,41 €64,80 €74,45 €61,53
You save 5%
O-ring feed pump Ø 32 x 2,5 mm Case IH
Version: Ø 32 x 2.5 mm. More
Version: Ø 32 x 2.5 mm.
€11,00 €9,09
Connecting rod bush Case IH
GRANIT Crankshaft seal set for Case IH
GRANIT
Menke no.: 63685. More
Menke no.: 63685.
€57,00 €47,11 €54,15 €44,75
You save 5%
GRANIT Door lock, right Case IH Series 32-4240
€116,93 €96,64 €111,00 €91,74
You save 5%
GRANIT Handle half for deurruitverstelling Case IH Series 32-4240
€33,18 €27,42 €31,50 €26,03
You save 5%
Lifting spindle complete 580 - 710 mm, thread 7/8", yoke 45 mm Case IH
Dimensions: Length min. = 580, Length max. = 710, Thread = 7/8", Ø top = 16, Ø bottom = 19, Clevis width = 45 mm. More
Dimensions: Length min. = 580, Length max. = 710, Thread = 7/8", Ø to...
€165,65 €136,90 €157,35 €130,04
You save 5%
Showing 193 - 216 of 261

Case IH 695 XL parts for engine rebuilds and upkeep

The Case IH 695 XL, which many farmers still call the IHC 695 XL, often gets a second life through an engine rebuild. This page lists more than 250 replacement parts for this tractor, from manufacturers including GRANIT, HELLA, ZF, KS and Carraro.

Rebuilding the engine

For an overhaul there are complete piston sets and piston ring sets, backed up by gaskets and O-rings, for instance for the feed pump and the thermostat. The brass bushes that hold the injector nozzle holders are here too.

A word on those bushes: they separate the coolant from the combustion chamber. If you see bubbles in the radiator or coolant disappears without a visible leak, a failed bush may be the cause. Replace them whenever you rebuild, since the head is already on the bench. With new piston rings, check the ring gap by pushing each ring squarely into the bore and measuring before it goes onto the piston.

Cooling, steering and driveline

Around the cooling system there are radiator hoses, such as the by-pass hose, and thermostat gaskets. The by-pass hose is often awkward to reach and tends to get forgotten. Replace it along with the thermostat, since everything is already open. For the front axle and steering there are axial joints and ball joints, which announce wear through play at the steering wheel. In the driveline you will find clutch packs with internal and external plates.

Cab and electrics

Gas struts hold the cab door open, and one that no longer holds is more than a nuisance on a windy day. For the lights there are work lamps, rocker switches and flasher units. If the indicators suddenly flash twice as fast, a bulb has usually blown. If they stop flashing altogether, suspect the flasher unit first.

  • piston sets and piston ring sets
  • nozzle holder bushes, gaskets and O-rings
  • radiator hoses and sealing rings
  • axial joints and ball joints
  • work lamps, rocker switches and flasher units

From type plate to engine number

The type plate on your 695 XL confirms the model, but for an engine rebuild the number on the block matters just as much. Pistons and rings are matched to the bore, so measure the cylinders before you order. For individual parts, the reference number on the old component is a good guide.

The same series also includes the Case IH 695 and the Case IH 895 XL. Each has its own page, so pick the one matching the model on your type plate. Other Case IH and IHC tractors are under Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart