Menu
EUR

Case IH CVX 140 tractor parts & technical data

Does your Case IH CVX 140 need a new trailer coupling, electrics or lighting? You will find them here among more than 300 parts matched to this model.

316 parts found for Case IH CVX 140
Show:
Electric feed pump without filter 230 l/hour, 0,55 bar
Version: Delivery volume 230 l/h, Pressure 0.55 bar. Menke no.: 209005. More
Version: Delivery volume 230 l/h, Pressure 0.55 bar. Menke no.: 209005...
€109,94 €90,86 €104,40 €86,28
You save 5%
Main bearing standard Ø 85 mm
€48,38 €39,98 €45,95 €37,98
You save 5%
Air hose to the intercooler Case IH, New Holland, Steyr
€192,15 €158,80 €182,50 €150,83
You save 5%
Adjustment pin stabilizer Case IH, Steyr
€90,01 €74,39 €85,50 €70,66
You save 5%
Pin stabilizer Case IH, Steyr
€61,95 €51,20 €58,85 €48,64
You save 5%
GRANIT Bush for lower link shaft 66 x 70 x 45 mm Case IH, Steyr
GRANIT
Dimensions: 66 x 70 x 45 mm. More
Dimensions: 66 x 70 x 45 mm.
€115,43 €95,40 €109,65 €90,62
You save 5%
Sealing ring 82 x 6 mm Case IH, Steyr
Dimensions: 82 x 6 mm. More
Dimensions: 82 x 6 mm.
€10,65 €8,80
GRANIT Potentiometer receivers vierwielaangedreven as Carraro
GRANIT
Version: Receiver - four-wheel drive axle (Carraro). More
Version: Receiver - four-wheel drive axle (Carraro).
€259,31 €214,31 €234,60 €193,88
You save 10%
GRANIT LED work lights flood beam 30 W, 3100 lm, 150 x 72 x 68 mm, 12 / 24 V
GRANIT
Nominal voltage: 12 / 24 V. Voltage range: 10 - 30 V. Bulb: LED. Bulbs included: Yes. Light function: Close-range illumination. Dimensions W x H x D: ... More
Nominal voltage: 12 / 24 V. Voltage range: 10 - 30 V. Bulb: LED. Bulbs...
€64,09 €52,97 €60,85 €50,29
You save 5%
Maintenance switch air filter Case IH, New Holland, Steyr
Version: Function: maintenance switch Connection cable with plug connection More
Version: Function: maintenance switch Connection cable with plug conne...
€101,00 €83,47 €95,95 €79,30
You save 5%
GRANIT Push button switch lift, extern circuit Case IH, New Holland, Steyr
GRANIT
Version: Raise control hydraulics, External switch (on mudguard) More
Version: Raise control hydraulics, External switch (on mudguard)
€42,81 €35,38 €40,65 €33,60
You save 5%
GRANIT Rocker switch dashboard front work light
GRANIT
Version: Dashboard Control panel Front headlights More
Version: Dashboard Control panel Front headlights
€93,63 €77,38 €88,90 €73,47
You save 5%
HELLA Alternator 14 V / 95 A, pulley Ø 86 mm, 2 grooves, Case IH, Ford
HELLA
Nominal values (V / A): 14 / 95 | No. of grooves: 2 | Charging current (A): 95 | Nominal voltage (V): 14 | Additional information: With double pulley ... More
Nominal values (V / A): 14 / 95 | No. of grooves: 2 | Charging current...
€476,33 €393,66 €382,95 €316,49
You save 20%
GRANIT Brake disc Ø 241 mm, thickness 5 mm, 28 teeth
€49,15 €40,62 €46,65 €38,55
You save 5%
O-ring Ø 305 x 4 mm Case IH, Steyr
€55,96 €46,25 €53,15 €43,93
You save 5%
GRANIT Seal PTO shaft end piece 94 x 118 x 12 mm
GRANIT
Version: 94 x 118 x 12 mm. More
Version: 94 x 118 x 12 mm.
€100,99 €83,46 €95,90 €79,26
You save 5%
Gasket manifold for turbocharger 162000110800, 47107834
€31,81 €26,29 €30,20 €24,96
You save 5%
Showing 265 - 288 of 316

Case IH CVX 140 parts and how to match them

With a Case IH CVX 140, finding the right part starts at the type plate, which tells you the exact model. Check that first. From there the part you have taken off is your best reference. Bushes, sealing rings and gaskets often have no readable number left, so measure them with a caliper. Alternators, switches and work lamps usually carry a sticker or a stamped reference number to compare with the product. More than 300 parts on this page fit the CVX 140.

What is available

Around the rear linkage there are lower link shaft bushes and sealing rings. For the engine you will find a water pump gasket, an O-ring for the oil filler cap, multi-rib belts and an alternator, while seals for the lubrication lines keep oil where it belongs. In the cab there are rocker switches for the front work lights, a push button switch for lowering the front linkage, gas struts and air suspended seats. Outside, HELLA work lamps light up the job, and at the back there are drawbar hitches, adapter plates and Piton Fix parts from Scharmüller and ROCKINGER, with Carraro and GRANIT also among the makers.

Changing the multi-rib belt

A belt that squeals on a cold start often points to a weak tensioner rather than a worn belt. When you change it, spin the tensioner and idler pulleys by hand. Any bearing that rumbles or has play should be replaced at the same time, or the new belt will soon be damaged too. Take a photo of the belt routing before removing the old one so the new belt goes on the right way first time.

Bushes in the rear linkage

When the lower link shaft has play, the lift arms wobble and implements run unevenly behind the CVX 140. Press new bushes in with a suitable drift rather than hammering straight onto the edge, and put a little grease on the shaft before assembly so nothing seizes. Check the sealing rings next to the bushes at the same time, as a worn seal lets water and dirt into the new bushes.

Other CVX models

Each model in the CVX line has its own page, which helps if you look after several and want to see only the parts that suit each machine:

The rest of the brand is listed under Case IH parts.

Brands
  • View more
Price
Min Max
Close
Choose your language
Choose your currency
€

Recently added

Total incl. tax
€0,00
0
Compare
Start comparison

This product has been added to your cart